₦airaland Forum

Juror:
Don't arrest anyone yet.

Try to take the battery to Sako yourself, point out the discrepancies to them and tell them to disassemble the battery in your presence.

AndroBlaze:
Here is the sales manager's number attached (don't want to get banned).

He would unlikely be involved in any coverup, if there is one.

KudozInteriors:
Thank you so much.
So I should go on and buy the shunt then right?

KudozInteriors:
Ohhh…thank you so much
This means a lot
God bless you.

fuckboys:
hold don’t purchase yet, I wanna sell mine with a 200a shunt cos I just contacted Iinnov8 for his and will be buying it from him tomorrow

You can have mine for 18k

fuckboys:
So after the advice I got from my bosses here, I decided to change my breaker and I saw this.

I've installed a new Schneider 63a breaker, let's see how it goes tomorrow.

Obviously this is a fake dc breaker, I hope this si what has been causing all my charging issues.

fuckboys:
So after the advice I got from my bosses here, I decided to change my breaker and I saw this.

I've installed a new Schneider 63a breaker, let's see how it goes tomorrow.

Obviously this is a fake dc breaker, I hope this si what has been causing all my charging issues.

Dam5reey1:
I don tell you from get go. Change the breaker.

Dam5reey1:
Drama everywhere

olatade:
Good afternoon house



My inverter setup is as follows: a 3.5kVA inverter with two Luminous tubular batteries. I have three 555W Jinko solar panels connected in parallel to an old 60A Modern Felicity charge controller. 6mm copper wire from the panels to the charge controller. However, the cables(6mm) from the charge controller to the batteries tend to get warm, and sometimes even hot. What could be causing this, and is there any solution?

Mavor:
Experts in the house (HeavenlyBang, Dam5reey1, etc), please help me make a choice between these two batteries. Want to help my sis for a one-bed apt setup - https://sygniteng.com/product/growatt-hope-4-8l-c1-lithium-ion-battery/ or https://sygniteng.com/product/megatank-gl48100-lithium-ion-battery/

Never heard about Megatank before. Thanks in advance.

Mavor:
I'm thinking they cost that much because they are higher voltage rated and LiFePo4. I am strongly leaning higher voltage cos they require lower current to operate which means less heat and no fans needed so no battery noise. Your LVTOPSUN is 24V abi?

favouredbymercy:
Since you are pumping in so much current, change your cable to 16mm from that 10mm. I told you before, that is the underlining cause, not just the breaker. You said yourself that the wire gets hot. The heated wire affected this breaker. The oversizing of the panel is much, you need to see to that too

Dam5reey1:
I don tell you from get go. Change the breaker.

fuckboys:
So after the advice I got from my bosses here, I decided to change my breaker and I saw this.

I've installed a new Schneider 63a breaker, let's see how it goes tomorrow.

Obviously this is a fake dc breaker, I hope this si what has been causing all my charging issues.

AndroBlaze:
God bless you too and I really hope this is all sorted out amicably and that most of us are wrong, at least for this country's sake!!

KudozInteriors:
I hope so too chief but I don’t think we’re wrong though because I don’t see reasons why my inverter freezer and 25watt fan will run down a fully charged 5Kwh battery within 12 hours.

Thanks so much for your help once again.

maklelemakukula:
Get deye from fouani, the 48v and 12v batteries are cheaper than that growatt you linked from sygnite

CuteMaro:
Follow his advice, they're stupidly overrated, they're quoting x2+ of average 5kwh battery price whether 24 or 48v.

That amount they're offering for 5kwh can get you close to a 15kwh battery, read up the thread and you will learn a lot.

Mavor:
I am looking for a 48V and I have not seen a 15kwh for that price or close. I will gladly go for that, from a solid OEM of course. I dont want anything 24V.

Mavor:
I am looking for a 48V and I have not seen a 15kwh for that price or close. I will gladly go for that, from a solid OEM of course. I dont want anything 24V.

ManAdii:
I see two things here. It's either your mind is made up already and you're just looking for a validation to get either of the batteries or you're not getting what the people above are saying.

How can you buy 48v 100ah for 1.8m where you can get a good 48v 280ah or 314ah between 1.9m ~ 2.5m. It doesn't make financial sense to me.

Anyway, your money, your decision.

HeavenlyBang:
Did you do the capacity test I recommended?

Mavor:
You mean this specific one? - https://fouanistore.com/product/792?uuid=556f59e3-8cca-4570-9262-c38e0ceb9343

mctfopt:
If it's a Schneider breaker you bought, there is a 95% chance the Schneider is fake. Just saying.

https://www.nairaland.com/390522/solar-energy-complement-fta/1346#120371763

https://www.nairaland.com/390522/solar-energy-complement-fta/1793#131627280


https://www.nairaland.com/390522/solar-energy-complement-fta/1346#120377733

CuteMaro:
He just mentioned LVTOPSON and told you the price he got it.

There is Deriy, there is Valto, Firman, Felicity, Sako, Cworth. It's plenty. They all have 48v batteries at a fair price range.

Valto even offers 7.5kwh for 1.250m, 1.9m for 5kwh is just ridiculous.

Deriy also have 5kwh 48v for 1.050m. If you do some research you will see, it's not hidden.

ManAdii:
I see two things here. It's either your mind is made up already and you're just looking for a validation to get either of the batteries or you're not getting what the people above are saying.

How can you buy 48v 100ah for 1.8m where you can get a good 48v 280ah or 314ah between 1.9m ~ 2.5m. It doesn't make financial sense to me.

Anyway, your money, your decision.