₦airaland Forum

I'm also in Shomolu, would you mind if I recommend the guy who installed mine? He stays around Oke-suna

aloyt:
Hello Peeps, can anyone suggest a good installer here that can assist with sola panel installation in Lagos. I already have an inverter system working with the grid, i just want t add solar panels to the setup. Is anyone here that can help with the installation pls. Kindly get in touch
Location: Shomolu, Lagos

Dabss:
please let us know if adding more panels improves your yeild. Alot of use are having similar issues. 🙏

Don’t be deceived.. me I use just 4 panels and get 2.3kwh at peak. My friend way Dey get 2.7 uncor for just 4 panels. We dey use original panels though not stickers

chuxmgc:
Please house, how many amp should I be greeting from 2 300watts mono panel with pwm charge controller on a 12v battery system..
Cos I'm only getting 10amp at the peak of the sun, which I think it's too small

well depends on the imp and vmp (max power voltage ) of the panel..since it’s 300w I believe it’s high voltage panel let’s say above 37 and I believe the power current should be around 6-8 +- ….the pwm cc will drag the voltage to you battery voltage…I believe your battery is 12v….that two panels can’t generate more than 12amp……

Pwm cc are not good for high voltage panels because the waste excess voltage since they only use the battery voltage and waste the rest unlinke Mppt that converts excess voltage to current..


Best panels for pwm are panels with low voltage and high current in parallels….get an mppt cc and avoid glorified pwm disguised as mppt

jstemmanex:
I'm also in Shomolu, would you mind if I recommend the guy who installed mine? He stays around Oke-suna

You can drop the contact, it's fine

favouredbymercy:
What you are experiencing is not abnormal. That is the very limitation pwm has. For a 12v system on pwm, highest panel size you should have used is 200w. 200w x 3 in parallel, would serve you better than 300w x 2 in parallel. Only advice I have is for you to get an mppt and series the 2 300w panels.

even 200w panels with high voltage and low amps will still give him same result….if he’s using 12v system best for pwm is panels with 17-18v and mayb 10 imp…

iraybuju:
Don’t be deceived.. me I use just 4 panels and get 2.3kwh at peak. My friend way Dey get 2.7 uncor for just 4 panels. We not use original panels though not stickers

are you using a 24v or a 48V system?

Bryanluke:
which thread, why u dey always dey tackle me here, did you know what brought up the question at all

If the fan is not working you have ti check and make sure it’s working otherwise it will keep tripping and showing error code

Dabss:
are you using a 24v or a 48V system?

48v bro

lovediehatelive:
I've joined the wire directly from the battery to the direct wire from solar panel without using charge controller but nothing came up.

Them just Dey advise you up and down but them nor tell you say that thing fit catch fire as a result of over charge or wrong polarity, you don’t even have a meter to know what you are doing, brother just look for who knows it and they will help you bring it back to life

chuxmgc:
Please house, how many amp should I be greeting from 2 300watts mono panel with pwm charge controller on a 12v battery system..
Cos I'm only getting 10amp at the peak of the sun, which I think it's too small

What you are seeing is absolutely normal and your panel I’m very sure they are not 300 but 180watts or 200watts

chuxmgc:
Please house, how many amp should I be greeting from 2 300watts mono panel with pwm charge controller on a 12v battery system..
Cos I'm only getting 10amp at the peak of the sun, which I think it's too small

Parallel them.

Price of Mama home Dayo - Tope induction cookers now almost times 2 in price-- 35k upward. If you saw it lesser --- please share.

Demand and supply going on.
Cooking gas teaching everyone a lesson.
Price of Induction pots will jump up too..

dollarnaira:
Price of Mama home Dayo - Tope induction cookers now almost times 2 in price-- 35k upward. If you saw it lesser --- please share.

Demand and supply going on.
Cooking gas teaching everyone a lesson.
Price of Induction pots will jump up too..

I knew this was going to happen, I got 2pcs of the dayo cooker then and went to ijesha warehouse and got 4 sets of pots and I'm all set.

I don park my cylinder and gas cooker since.

Sunday
08121872590
07082164518

aloyt:
You can drop the contact, it's fine

ajabani4allah:
MSW inverters are not strong, that your 2kw msw inverter might not be more than 400w actual power, don't try it with the induction cooker

When I said i will never buy sachet inverter again .... Some people vex

oweniwe:
When I said i will never buy sachet inverter again .... Some people vex

So you one use low budget msw compare proper psw? By the way, my satchet inverter powered my Dayo induction cooker etc. Next time buy proper one from Innov or Valto. Okay?

the first issue I was having was wen the induction cooker start misbehaving if I increase the cooking power it will decrease on it own, so one day I open it up and I saw lots of little cockroach hiding undernith The touch panel, I clean it up and screw it up and everything was working fine same thing happened again and I decided to buy green leaf(cockroach killer) I put it in every comer inside the induction cooker and I couple it up again, it was after this I notice the cooker was working and stopping occasionally while the power light is still on, right now am in fouani service center with the cooker for repair, I came with the receipt and they are working on it bcus it still under warranty

fuckboys:
you've already diagnosed your problem already. Get a screwdriver and open that boy up and check for any cut/melted wires and check if fan is still okay.

osayuwamwen:
the first issue I was having was wen the induction cooker start misbehaving if I increase the cooking power it will decrease on it own, so one day I open it up and I saw lots of little cockroach hiding undernith The touch panel, I clean it up and screw it up and everything was working fine same thing happened again and I decided to buy green leaf(cockroach killer) I put it in every comer inside the induction cooker and I couple it up again, it was after this I notice the cooker was working and stopping occasionally while the power light is still on, right now am in fouani service center with the cooker for repair, I came with the receipt and they are working on it bcus it still under warranty

Opening it should have void your warranty. You're lucky if they honor that warranty sha.

lol I cleaned up everything in and out, it looked like it was not tempered with

Unfaized:
Opening it should have void your warranty. You're lucky if they honor that warranty sha.

smallsmall:
Give it a try, worst that can happen is that it will shut down due to overload. You Unplug it and reset your System.


Can you please post the link you used in buying it on Konga, here.
And how much was it?
I am considering buying one for one Hostel Student who needs it badly.

Order directly from the Mama Home website. It will be delivered to you

Boss ẹ Don over cost, even the dayo isn't available again

dollarnaira:
Price of Mama home Dayo - Tope induction cookers now almost times 2 in price-- 35k upward. If you saw it lesser --- please share.

Demand and supply going on.
Cooking gas teaching everyone a lesson.
Price of Induction pots will jump up too..

Unfaized:
Opening it should have void your warranty. You're lucky if they honor that warranty sha.

Without a broken seal, warranty is intact.

They can't even put a seal in it because the components are direct.

I didn't see any seal on it as at when I bought it newly, they are already working on it am just waiting to collect it, no body ask for any money they only ask for the receipt and I gave them they made a photocopy

dollarnaira:
Without a broken seal, warranty is intact.

They can't even put a seal in it because the components are direct.

Gshems:
Boss ẹ Don over cost, even the dayo isn't available again

Hope say you no delay the last time you wanted to buy?

dollarnaira:
Hope say you no delay the last time you wanted to buy?

What price was it sold for? The Mama Home website I found on Google is suspended.

dollarnaira:
So you one use low budget msw compare proper psw? By the way, my satchet inverter powered my Dayo induction cooker etc. Next time buy proper one from Innov or Valto. Okay?

Nor mind that guy. It’s just ignorance and nothing more.

I delayed

dollarnaira:
Hope say you no delay the last time you wanted to buy?

osayuwamwen:
lol I cleaned up everything in and out, it looked like it was not tempered with

Hahaha.. Hope they were able to fix it though.

NSEstudent:
What price was it sold for? The Mama Home website I found on Google is suspended.

It was roughly 18k before the high demand. Saw them on jiji alaba for 35k.

If you get solar and you still dey buy gas sorry o 🥱

This induction cooker gets really hot so fast I'm tired of burning food. Now na 800w I dey use and it does the job well.

aloyt:
Hello Peeps, can anyone suggest a good installer here that can assist with sola panel installation in Lagos. I already have an inverter system working with the grid, i just want t add solar panels to the setup. Is anyone here that can help with the installation pls. Kindly get in touch
Location: Shomolu, Lagos

08051355133

Get in touch