₦airaland Forum

easyyoke:
Going to a year now

hmm n de tend to balance well. Do u monitor the individual 12v batteries

Compliant:
I once requested information on this thread on the best inverter AC to buy and after reading comments, I decided to go for LG 1 HP inverter Ac with Gen Mode from fouani for N559,000

It was installed few days ago and the installer set it to Gen Mode 0.8 and to my surprise the whole power it was pulling was just 320watts

which of d lg 1hp model are u using.

Can it chill properly with this voltage? Do you notice any difference?

Compliant:
I once requested information on this thread on the best inverter AC to buy and after reading comments, I decided to go for LG 1 HP inverter Ac with Gen Mode from fouani for N559,000

It was installed few days ago and the installer set it to Gen Mode 0.8 and to my surprise the whole power it was pulling is between 280w to 320w

easyyoke:
Lol. I have four different brands of LIFEPO4 batteries paralleled together. I have been using it for 2years plus. You can parallel even different capacity as the internal resistance of each battery will tell your charger which battery to supply higher amps. Recently I connected the four different 12v battery in series(using an external equalizer) to make 48V 100ah, then I paralleled the 4 to another single 48v 100ah using a bus bar. Manufacturers telling you not to parallel their batteries with other brands is BS so far the batteries are thesame chemistry(i.e you cannot parralel Lead Acid with Lithium).

Sensible sense.
Good.

Pnutmillionaire:
I just changed it, the soc is still on 92% and every other thing is the same

Try this settings.....it works for me.
Also try balancing the cells. Damreey can assist with that

fuckboys:
Y,all with undersized power banks how’s the weather treating you?


Charging at under 200w at 12pm. Never getting a full battery today.

Before now, I make use of 4 pieces of 615w jinko panel but 2 days ago I decided to add extra 4 pieces of 615w jinko due to bad weather this season after installation I was able to pull 2.47kw despite the bad weather

Ayomipoe:
Can it chill properly with this voltage? Do you notice any difference?

Considering the cold weather, i would say, its very okay. If i need it to be cooler than that then i can make use of 0.6

good evening guys..
happy Sunday all

1. Go to the BMS settings and set your preferred voltage for it to reset to 100% (if the JK BMS is the V15 or V19).
2. Set the RCV, RFV and OVP accordingly.
3. Change the CAN protocol to the Deye inverter protocol (protocol 2 if I remember correctly) on the BMS.
4. Drain the battery to like 2.7v to 2.5v and charge it up again to recalibrate the BMS.

Pnutmillionaire:
What could be the problem with this bms.
The battery is obviously full from the voltage displayed but it states soc as 92%.
Although it hasnt exceeded 58V before, it used to show the correct percentage in respect to voltage.

Compliant:
I once requested information on this thread on the best inverter AC to buy and after reading comments, I decided to go for LG 1 HP inverter Ac with Gen Mode from fouani for N559,000

It was installed few days ago and the installer set it to Gen Mode 0.8 and to my surprise the whole power it was pulling is between 280w to 320w

Raining season and Gen mode is a bae, its actually 0.6 that consume this low wattage.

Compliant:
I once requested information on this thread on the best inverter AC to buy and after reading comments, I decided to go for LG 1 HP inverter Ac with Gen Mode from fouani for N559,000

It was installed few days ago and the installer set it to Gen Mode 0.8 and to my surprise the whole power it was pulling is between 280w to 320w

we're in cold season and it's not working much to cool your already cold space.

I use same ac and typical power consumption is between 600 - 800w.

I don't even use ac this period cos fan is blowing cold enough.

Ferdiwar:
1. Go to the BMS settings and set your preferred voltage for it to reset to 100% (if the JK BMS is the V15 or V19).
2. Set the RCV, RFV and OVP accordingly.
3. Change the CAN protocol to the Deye inverter protocol (protocol 2 if I remember correctly) on the BMS.
4. Drain the battery to like 2.7v to 2.5v and charge it up again to recalibrate the BMS.

This makes sense

fuckboys:
we're in cold season and it's not working much to cool your already cold space.

I use same ac and typical power consumption is between 600 - 800w.

I don't even use ac this period cos fan is blowing cold enough.

He didn't put into consideration the already cold air in the room. Ac inside this cold weather? For days now no fans had turned here. Great cross ventilation is bae.

Seun:
We have fixed most of the issues with the bot and the minimum character count.

If by fixing the issues with the bot you mean empowering it to censor actual discourse on this forum then you're correct. But it's funny that you're enforcing people to write substantial content that is supposed to exceed 40 characters only to then turn around and ban them for doing just that!

Just this morning alone. I've had two posts in the Christianity section censored. For what abeg? I didn't insult anybody. I didn't plagiarize anybody. So please what was I banned for?

This thing is starting to get on my nerves. If you don't want us to visit your site anymore let us know. What's the point of chat forum where people can't even chat without getting the hammer for stupendous reasons?

I'm not saying there should be cursings and all that. I'm firmly against that too. But at least allow people to have reasoned and detailed conversations. I can't be hiding important information I need to share here because I have to cater to the feelings of your emotionally unstable bots!

I might just have to block this website on my phone if this farce persists. Then maybe you can enjoy your draconian website.

Dam5reey1:
Raining season and Gen mode is a bae, its actually 0.6 that consume this low wattage.

Please drop your contact, I need to buy some things from you

Pnutmillionaire:
What could be the problem with this bms.
The battery is obviously full from the voltage displayed but it states soc as 92%.
Although it hasnt exceeded 58V before, it used to show the correct percentage in respect to voltage.

Battery capacity = 314Ah; Remaining capacity = 290Ah
290/314 X100% = 92% approximately

juludith:
Battery capacity = 314Ah; Remaining capacity = 290Ah
290/314 X100% = 92% approximately

The 92% was static. Battery was at 57.8V which should be 100%, Bms had already stopped letting in any charge.
If I change battery capacity to 200Ah for instance, the bms would adjust the remaining capacity to whatever it needs to be to be at 92%

Ferdiwar:
1. Go to the BMS settings and set your preferred voltage for it to reset to 100% (if the JK BMS is the V15 or V19).
2. Set the RCV, RFV and OVP accordingly.
3. Change the CAN protocol to the Deye inverter protocol (protocol 2 if I remember correctly) on the BMS.
4. Drain the battery to like 2.7v to 2.5v and charge it up again to recalibrate the BMS.

These are the settings in the image below.
The jk bms is software version 15.38. and Version 4.28.0
The percentage mismatch is from the battery, the inverter is just showing what the battery is showing.
I will try draining the battery cos I havent done that since it was installed, it barely goes beyond 60 % in the morning.

Also, the "dc volt low" error I used to get changed to "bms communication error" as I enabled "bms error stop" on the deye inverter.

Seun:
We have fixed most of the issues with the bot and the minimum character count.

What are you doing about the “deactivating” option? Why can’t I decide to deactivate my account at my own free will? Why is everything about Nigerian things just so weird and authoritatively-inspired?

And why do you think you have the right to make me type 40 characters if I don’t have that strength? Like how do you really think? Is there no honest person in your team to tell you this?

dollarnaira:
Follow who know road bro.
3000w Satchet pulling 67a right now pumping water on 0.5hp sumo.

You never jam better Satchet inverter.
500w Satchet inverter surge freezer of 115w.
Plenty fake ppu dey too

The sachet inverter pumping water is it 12v or 24v, i need were did you get it from post picture of the inverter and seller

Iinnov8:
My oga, thanks for your interest.

It is a pure sinewave inverter with very minimal fan noise. it is available for just 103k,

Which brand are u selling 24v is how much do u have from 4000w

Abeg drop price list

dollarnaira:
From Valto(Xinboke) or Iinnov(easun) all Satchet inveters.
Valto also sells 500w psw board only (aggressively nice but can drain below 9v without bms).

Which of the product will U recommend for daily usage to power 1hp air conditioning non inverter Easun or xinboke

HeavenlyBang:
24v inverter from Bread, Powmr, or Firman - 400k
3 units of 615w Jinko panel - 400k
Cables and accessories - 100k
Installation - 100k
Rest of budget on largest 24v Lifepo4 battery you can find

I have decided to go for the Haisic 8kwh battery, please kindly resize the system. How many panels do I have to get for this battery bank? I will still go for the 24v Inverter. Thank you

spartacus11:
The sachet inverter pumping water is it 12v or 24v, i need were did you get it from post picture of the inverter and seller

Mine were purchased years ago from AliExpress 1600w and 3000w. No name.
12v

Please can a 5kva 48v felicity hybrid high voltage inverter handle heavy loads like pumping water, pressing iron boiling water without long term damage

kewhos:
I have decided to go for the Haisic 8kwh battery, please kindly resize the system. How many panels do I have to get for this battery bank? I will still go for the 24v Inverter. Thank you

Depends on your budget. 2500w of panels would be fine. 3500w would be better.

kewhos:
I have decided to go for the Haisic 8kwh battery, please kindly resize the system. How many panels do I have to get for this battery bank? I will still go for the 24v Inverter. Thank you

How reliable is this Haisic battery

fuckboys:
Y,all with undersized power banks how’s the weather treating you?


Charging at under 200w at 12pm. Never getting a full battery today.

I have no choice but to make arrangements for the purchase of additional power banks, eventhough I have an oversized solar array, the battery bank is not keeping up with my power demands overnight, but the power I produce in a day can fill more batteries than I currently have

This weak link in my setup must be fixed before the end of the month