₦airaland Forum

badesco:
Can somebody help me out. My Peugeot 406 car suddenly goes off and when you restart it come up again. This issue has been on for sometime now. I have consulted about two rewires to do proper checks. it recommended that I change the fuel pump and service the nozzles. I service the nozzle. yet still the same. Can somebody in the house help me out.

i know this has been here for a while. but i had similar problems and i had mine fix. so i'll be sharing it here for people that may face same issue with the 406 2.0 , ew10 and so on.

first, mechs will tell you its the fuel pump or coil or spark plugs the throttle module, idle state.

the solution is: 1st check your spark plugs they should have two pins on top instead of one. *ive attached a photo of the sample*
*this shouldn't cost you more than 4k. and when you are reading this and it cost more, trust me its a good investment

2ndly its highly possible your ECU (brain box) is three lines of parallel pins. *some wisdom i got this type gives alot of problems to 406. so you need to change it to a 2 serial pin ECU + entire cables connecting to the ecu on your engine. it connects to the engine block. sensors for temp, stepper motor, coil, idle air control valve. well almost everything thats under the hood.

this should cost you about 36k max. i had this done like last week, i got a friendly 26k bargain and it was goodbye to the misery. ive also attatched a 3 seial pin ecu to compare with yours.
i hope this helps someone.

regards

both were communists, and the US successfully killed MKO before he became a leader! as for Fidel, he has about 100 assassination attempts on him

good morning all, i can use some past questions as well. yamta.a@hotmail.com

Mogwai:
Good morning all, I got the invite for NITDA Scholarship Aptitude Test yesterday. I did appreciate if anyone has access to recent past questions & answers. kindly send to my email: martinsogwai@gmail.com. Many thanx.

but this is what the islamic law says as well

is there any Mikrotik expert in the house. i am trying to connect subnetworks. i require assistance with that

horllamy:
Have you tried to install the printer software?

yes i have, it worked perfectly. i finally deployed it as a network printer on my campus network.

most likely liquid substance poured on your mouse pad area. wipe the area clean with a tissue, if it persists please take it to a computer repair specialist.

WhyNa:
Can someone please help me outtt!!!!!!!!

Hi, this is my fist post on nairaland.
I recently solved a problem of printing documents from computer systems to a Xerox workcentre 5020. i initially joined nairaland to post it as a problem, but if anyone is having similar problem, i'll be glad to help

regards, tito.