₦airaland Forum

Airbag wasnt deployed. Only inside steering which can be replaced by purchasing a nee steering wheel or uk used

seankafor:
airbag nko

Honda crv 09

ugreat:
Try state the type of Honda and year for the gurus To Help you out

Secondly my rpm idle is always on 1
If i start the car it goes to abt 1.7, 1.8 rpm
But when i turn on the ac it goes below 1 and it vibrates the car like it wants to stall. I am fed up. I feel like honda is not for me. Help me.
My idle speed is low,if i put it on park and ac is on my car would be stalling like it wants to go off.

Xs or 11,s10,s9,s8
Rest is nonsense

Our panel beaters too much
Well its not that serious.
Bonet,chasis,fenders and change steering wheel,bumper. Wen nor be new one u wan buy
All going for 50k at ladipo

Is it by nepa control unit/agodi

timifakay:
No.
But you can try Tunde - opposite Operation Burst office.

Issue now. My steering still not straight. I have done alignment done every still same. 2 mechanics said its steering rack that is bad,but i dont believe them because its tokunbl clean title,engine has never been open or worked on.no accident,nothing so how can steering rack be bad. If i'm on 80/100kph steering starts vibrating and shaking. Then secondly my fuel economy is poor. 1 buy 1000 fuel,between a distance of 1 mile 3 litres gone .sp before i reach where am gling and back 8litres gone before you know it yellow/reserve tank light goes off. Its a 4plug but its drinking fuel like v12 engine. I have replaced 02 sensor 1,2,gpt new catalyst still no difference.i even blught brand new pump. Scanner shows coolant temp 2 sensor low. Then thridly my tmps light stays on.checcked the tyres checked all sensors on alloys nothing seems unusual.
I just want to know why its consuming much fuel,ac on or off,and my steerng wheel not straight.
I don tire dor honda

EngRichie:
Can you state the issue with your car? A little information might be of great help.

Thread abandoned

Any good honda certified car repair shop at ibadan.
Pls suggest
I'm fed up of kazeems pls

How can i correct my steering from shaking and vibrating at 70kph. I have done alignments and wheel balancing twice but problem not solved. Two mechanics said its ball joint but checked and ball joint is okay. I really do not understand what is going on. Someone should pls help..

Really.. u mean just like konga

TRYGO:
There are defective parts on Amazon prime too. I have bought a part, that after some time, got shorted in it's circuitry.

So don't fully trust those parts.

The let's there are not sold by Amazon, but by individuals, etc, using that as a platform

Prof prof, So u want to tellme that amazon prime sells defective parts up to a brand new coolant sensor of 7k.
I doubt

AutoMoTech:
Its possible bro. Even new parts are sometimes faulty. Factory defects and all... Dnt fully rule that out until u test

Its impossible. Before i purchased it i checked for the part number and amazon cofirms it fits and works for my car. Even the old one removed conpared to the new one is the same thing.i guess its wiring

thebigkendo:
It's also possible you bought a wrong sensor

I bought it direct frm amazon.
I guess its wiring.
I stay at oyo state.Yes it waa clogged,the old one aft istallation it says circuit low

thebigkendo:
This you issue is a very simple something.. But you are dealing with either an incompetent rewire or fraudulent one..

P2185 Has nothing to do with fuel consumption..

Where do you stay?
ECT Sensor 2 is the coolant sensor under the radiator, was that what that the rewire changed?

3 possibilities
-Your rewire bought a bad or wrong sensor
-Cable/Connection problem
-Rewire replaced the wrong sensor

My steering vibrates at 70/80kph and above,it also tilts to the right.i have been to so many alignment shops,they align tyrrs but still no difference. Some said its the balljoint,but balljoint is not bad. Or could it be a bad steering rack. My tyres tokunbo dont go more than 4months...

My Gosh. I'm not a rewire. Just a reg honda driver.
First it was high when it was connected.
Then when the sensor was replaced i realised it was like rusty .so we put the new sensor i got and scanned and the code now read sensor 2 circuit low.
How would i know if the engine coolant thermostat is still in the car. Sometimes ago my fan stopped and then went back they later serviced it and it started working..i dont have an obd scanner. Also my dashboard shows 89°

TRYGO:
The sensor might not be OK.
Few questions for you here.
1. Is your radiator cooling fan connected directly to the ignition system?

2. Is the engine coolant thermostat still in the car, or it has being removed?

3. Replacing that sensor, may not be the problem.

4. Run this test:
a. Unplugged the connector in that sensor, and read for trouble codes.
What code are you getting as regards the ect?
Same high or low blabla?

b. if the sensor is bad or OK, it should give you same results with the former sensor(high), when disconnected.

5. The ect wiring circuits, straight up from the sensor itself, down to the ECU maybe faulty ( a short or an open circuit there).

6. Did you read the freeze frame data on your scan tool, to lookvat the ECT temperature? Is it in the -40°C, or in the above that range?

7. Interpreting those would helped you troubleshoot this problem.


Hope this helps you more!



Regards,
Joseph (08066643532:calls/WhatsApp)
DW Nig Ltd
Isolo
Lagos

I should check the wiring at the sensor 2 i newly replaced. I guess i would have to go to anothee rewire because where the sensor is located,they were all nagging before they removed my fan and found it.pls educate me .the wiring i should check for what exactly.
I disconnected the battery and with the hope that tomorrow morning it would clear

AutoMoTech:
Check the wiring. Stop throwing parts at the problem.
You might have a short to ground somewhere. Reason for the circuit too low code. This Will definitely affect your fuel consumption since the ECU doesnt know if the engine cold or hot.

Men

How much

Before it was ect sensor 2 high after scanned
Then i bought a replacement sensor for 7k,installed it by my rewire and obd scanned. Then the scanner showed code p2185..ect sensor 2 circuit low
Now i feel frustrated as my rewire says they would need to change the sensor close to thermostat. But the obd says sensor 2 and a i noticed my acceleration doesnt pick on time and my fuel economy is poor. 1000naira fu only lasts me half a day whether ac or not.
Pls what can i do cos check engine light still on.
On honda crv 2009