₦airaland Forum

Besto:
Doesn't need to match, just needs a space for for installation (where the bracket seats perfectly) .

What's important that it gives the recommended psi for your steering rack to be very soft and good thing it's electric, no additional stress on your engine.

And the psi on it is madt!!!

Can this work on Ford Edge?

You just need a good electrician to hook the wiring up safely to your car system.

Pretty easy, just search for Volvo EHPS on YouTube.

Besto:
Doesn't need to match, just needs a space for for installation (where the bracket seats perfectly) .

What's important that it gives the recommended psi for your steering rack to be very soft and good thing it's electric, no additional stress on your engine.

And the psi on it is madt!!!


Can this work on Ford Edge?

You just need a good electrician to hook the wiring up safely to your car system.

Pretty easy, just search for Volvo EHPS on YouTube.

Donald3d:
I have recently worked on a car with the exact slight hesitation problem you are experiencing, its going to be hard to give you a solution without actually diagnosing the problem physically . It could be wiring issues, a bad clutch pressure control solenoid, dirty transmission oil , poor ECU connection, e.t.c

Concerning the veering and vibrating, you most likely have one or more bad suspension component, again, its going to be hard to tell you what the problem is without physically seeing the car. But you can try jacking the car up , assume your car is a clock, grab the tyres in the 3 and 9 o'clock position and try to shake, repeat for 12 and 6 o'clock position. Also visually take a look for torn bushings . Do this for both front tyres. Take a look at your brake disk, the edges, does it look like there is a "lip" at the edge ? . The brake disc/rotor could also be warped(bent)

As for the codes, I don't think the 02 sensor would cause knock sensor codes, except they share the same circuit which I doubt, knock sensors are usually one wire connectors , routed directly to the ECU because its very important to detect knock , so the ECU can adjust ignition and protect the engine if necessary. You need to check the wiring and be sure you bought the right knock sensor . The last code could also be a wiring problem or bad ground somewhere. Its hard to tell without proper diagnosis.

sandammy:
Thanks boss. I did as u suggested by checking the tires. I see that the tie rod end on the passenger side that the car is always veering to, when I apply brake suddenly is bad. The knockle head is no longer firm. I will change both sides. If it persist I will resurface the brake discs. Changing brake calipper will be the last thing because I read that these other two can also cause it

HenryWilliams:
Evening y'all.
I'm m in the market for a registered 2010-11 Accord EX-L or 2007 Acura MDX AWD.
How much should I be expecting as cost?
Thanks

Nadingo:
Pls someone should recommend for me a simple non-professional scanner that can scan engine and transmission codes. Something not too expensive but user friendly that I can pair with phone or tablet. And if you sell one, kindly post with price. Thanks

HenryWilliams:
Evening y'all.
I'm m in the market for a registered 2010-11 Accord EX-L or 2007 Acura MDX AWD.
How much should I be expecting as cost?
Thanks

Donald3d:
Autel AP200 , can read transmission codes , and you can program keys too. You should be able to get it for about 50-70k .

Not sure of your budget, but this is fairly affordable, and you get access to one car brand for life, so if you lock in Honda, all honda vehicles would always be free, if you need other car brands, you pay to buy access for other car brands. You don't have to lock in Honda, you can lock in Toyota if you want to. This is the only "disadvantage" .

If you can raise your budget, there are slightly better options, that can do bi-directional tests.

Nadingo:
I'll check it out. Thanks

HenryWilliams:
Evening y'all.
I'm m in the market for a registered 2010-11 Accord EX-L or 2007 Acura MDX AWD.
How much should I be expecting as cost?
Thanks

flootintin:
Please, how to resolve these codes, I have changed shift solenoid 3 times but the code keeps coming back. Scanned again and it was part of codes thrown by ECU. Vehicle struck in limp mode and atimes, doesn't engage drive at all.

salem344:
I need Honda Civic 2008 model. How much should I budget for both Nigerian used and foreign used? Besides, does Civic have hand wahala?

captainking:
hi guys,,,,please in am in ph...who can refer me to a plug where i can buy thermostat for my honda civic 06, american specs as well as digital speedmeeter ?

chillex8:
That's the linear shift solenoid

P0756 Shift solenoid B is the middle solenoid on the right row.

Can you clear codes and re-scan again.

Trace the wiring from the connector port of the shift solenoids. There could be a kink or broken lead.

You can message me via my signature for swift response.

flootintin:
Big thank you to @CHILLEX8 for the gift. Really appreciate you.

cmoney22222:
Chillex8 na baba nah. The Manchu know what he is doing. Na oG right from the times of Gazzuz nah. There are some silent blessing of people that don’t shout. Na chillex8 be that.

Bless up bro. Link up come collect your henny as we dey run am nah. lol 😂

Igemburg:
So I just got this Honda Accord 2014 model

Ride is smooth

The only issue I have is vibration at idle

*Engine mounts changed
*Plugs, air filter, injectors serviced
And still vibrates at idle, but when on motion it moves smoothly

Rewire told me issue is from engine, but car moves smoothly in motion
Who can recommend an expert Honda technician that can solve this

Louiscars:
Does this happen with or without the air conditioner turned on

Igemburg:
With and without the AC

Louiscars:
Physical checks would be required
Are you in Lagos

Igemburg:
Yes
Which side you dey nd digits

Igemburg:
So I just got this Honda Accord 2014 model

Ride is smooth

The only issue I have is vibration at idle

*Engine mounts changed
*Plugs, air filter, injectors serviced
And still vibrates at idle, but when on motion it moves smoothly

Rewire told me issue is from engine, but car moves smoothly in motion
Who can recommend an expert Honda technician that can solve this

Decororbit:
Hi everyone, I just bought a Honda fit 2016 ex and I am based it Abuja. Please what maintenance should I do before I make it my daily drive and is there any auto care center I can take the car to get it serviced in Abuja.
Thank you