₦airaland Forum

GOOD LIBRARY

Guide to Installing joy tv/multi tv with a new strong HD rx for a newbie

olenyi: First of all couple the dish together (dis might be difficult except u look at ur neighbours already coupled own). Locate ur ''east'' from ur proposed dish mount point (making sure u have a clear line of sight to the horizon up to the sky). Mount ur dish (also looking at ur neighbours own for the exact mount setting)Then fix the metallic f connector at both ends of ur cable. Screw one end to the lnb at the front of the dish. Get an extension box to help bring ur ''mains'' to a point near ur mounted dish. bring out ur tv to the dish point and put it on. Connect ur receiver also to the extension box. Now screw on the other end of the cable to the point at the back panel of ur receiver labeled ''lnb input''. Connect the av wires and put it on also. (IT VERY IMPORTANT U FOLLOW THE SEQUENCE OF MY INSTRUCTIONS.)

Now as the receiver is a new one, ''ok'' every option on the screen until u get to the home screen and u see ''no or bad signal'' press menu on the remote. Press ok. Enter 4 zero's for the pin and scroll down to manual scan. Press ok. Now using the right volume button, start scrolling through the satellites until u get ''astra 1N/2abd. When u get it, scroll down to frequency and using the left volume button now, start lookin for 12.5 something something. Press zero when u get it and select edit. Enter 12.523. Scroll down to ''symbol rate'' and enter 27042. Hand the ''polarization'' to ''v'' if its not so.

Phew!!!!!

If u've gotten to this point, Then u're doing great.

Now go to ur dish. And standing at the back of the dish or hanging from a ladder, (and with ur eyes on the two red signal bars at the top right hand side of ur screen) and with ur lnb positioned in such a way dat the point with u screwed on the cable is at 4 o'clock assuming u have an imaginary clock in ur head. Start raising the dish slowing up, up , up until it pointing to the sky still with ur eyes on the signal bar for when it will turn to green to indicate u've gotten a signal (remember it should be facing east). Bring it down slowly. Now shift the dish a tiny bit horizontal to the right. (remember u're at the back of the dish)

Take it up up up again and down. Right, up up up and down. Slowly. Keep at it until u hit green or until u get to ur south. If no green. Den start repeating the steps again but this time, shift horizontally to ur left.

When u hit green, adjust the dish a little to maximize the signal percentage and then tighten the 4 screws by the side of th dish and also the ones holding it to the pole arm all this while slowly and wit ur eyes on the signal so dat it doesn't go down.. When this is done, rotate the lnb a little clockwise and a little anticlockwise to get the best position for max signal and tighten.

Hmmm.... Tired now

We're almost dia.

When dis is done, press the red button to scan. Afterwards, exit everything until it starts showing at the home screen.

Regards.

Guide for installing joy tv with 69x/xii

olenyi: First of all couple the dish together (dis might be difficult except u look at ur neighbours already coupled own). Locate ur ''east'' from ur proposed dish mount point (making sure u have a clear line of sight to the horizon up to the sky). Mount ur dish (also looking at ur neighbours own for the exact mount setting)Then fix the metallic f connector at both ends of ur cable. Screw one end to the lnb at the front of the dish. Get an extension box to help bring ur ''mains'' to a point near ur mounted dish. bring out ur tv to the dish point and put it on. Connect ur receiver also to the extension box. Now screw on the other end of the cable to the point at the back panel of ur receiver labeled ''lnb input''. Connect the av wires and put it on also. (IT VERY IMPORTANT U FOLLOW THE SEQUENCE OF MY INSTRUCTIONS.)

press menu on the remote. Press ok. Enter 4 zero's for the pin and scroll down to manual scan. Press ok. Now using the right volume button, start scrolling through the satellites until u get ''astra 1N/2abd. When u get it, scroll down to frequency and using the left volume button now, start lookin for 12.5 something something. When u get it, scroll down to frequency, Press zero and select edit. Enter 12.523. Scroll down to ''symbol rate'' and enter 27042. Change the ''polarization'' to ''v'' if its not so.

Phew!!!!!

If u've gotten to this point, Then u're doing great.

Now go to ur dish. And standing at the back of the dish or hanging from a ladder, (and with ur eyes on the two red signal bars at the top right hand side of ur screen) and with ur lnb positioned in such a way dat the point which u screwed on the cable is at 4 o'clock assuming u have an imaginary clock in ur head. Start raising the dish slowing up, up , up until it's pointing to the sky still with ur eyes on the signal bar for when it will turn to green to indicate u've gotten a signal (remember it should be facing east). Bring it down slowly. Now shift the dish a tiny bit horizontally to the right. (remember u're at the back of the dish)

Take it up up up again and down. Right, up up up and down. Slowly. Keep at it until u hit green or until u get to ur south. If no green. Den start repeating the steps again but this time, shift horizontally to ur left.

When u hit green, adjust the dish a little to maximize the signal percentage and then tighten the 4 screws by the side of th dish and also the ones holding it to the pole arm all this while slowly and wit ur eyes on the signal so dat it doesn't go down.. When this is done, rotate the lnb a little clockwise and a little anticlockwise to get the best position for max signal and tighten.

Hmmm.... Tired now

We're almost dia.

When dis is done, press the ''ok'' button to scan. Afterwards, exit everything until it starts showing at the home screen.

Regards.

https://www.nairaland.com/331903/newbie-satellite-installation-introduce-yourself/54

You beat me to it bro. . .
Gud job . . .It would all have been your posts anyways

freshp: You beat me to it bro. . .
Gud job . . .Ut would all have been your posts anyways

My warm regards.

Olenyi,my Oga @ d top,greetings

olenyi: Guide to Installing joy tv/multi tv with a new strong HD rx for a newbie

i need steps in installing cmtv, am a newbie

GOOGLE UR BEST FRIEND

Please can someone help me with the list of FTA channels accessible from Ghana and the respective frequencies and symbol rates..

Moderator pls, this topic was transfered to you from general forum. Maybe The moderators there don't know what to do about it. www.nairaland.com/1404370/latest-inventions-nubrella-funny-looking-hands-free#17568721

SIM Routers for ALL networks.

4m fibre dish made october last year in good condition for sale location bisam mafuloku by international airport access road.will post pictures once i figure out how how to upload. lol

dynamicd28: 4m fibre dish made october last year in good condition for sale location bisam mafuloku by international airport access road.will post pictures once i figure out how how to upload. lol

Use d rite thread

Plis I have a Hitv decoder can I get joy TV with my Hitv decoder

[color=#000000][/color][color=#990000][/color][b][/b] plis I need help with new channels on pas 7/10 nollywood channel not showing on my Hitv decoder and am ku ban

.

WELL SAID

Link to 2 in 1 lnb for multi-tv and dstv or multi-tv and Amos 5.
www.nairaland.com/1450408/multi-lnbf-2-1-lnb

vn

U guys are great

dynamicd28: 4m fibre dish made october last year in good condition for sale location bisam mafuloku by international airport access road.will post pictures once i figure out how how to upload. lol

Is it still available. how much are you selling

THIS IS A WARNING TO EVERYBODY...POSTING SUBJECTS AND TOPICS NOT RELATING TO REFERENCES WILL BE DELETED AND THE USER BANNED TEMPORARILY... You have been warned.

Guys how do I connect to BREAKTHROUGH BROASCATING NETWORK?

I need to watch Shiloh 2013 live!

Urgent please!!!

Guys how do I connect to BREAKTHROUGH BROADCASTING NETWORK?

I need to watch Shiloh 2013 live!

Urgent please!!!

Mods do not allow thread derailment pls. D language we understand is d use of 'HAMMER', pls employ it!

I have two satellite dishes, 1 for the multi tv and the other for mytv africa.
I find out that each time i try to scan for channels using the 68°Intelsat 7/10, i get all the mytv africa channels which is correct but when i try scanning using the 28°astra1A/2B..which is suppose to be multi tv, i still get all the channels i got with the intelsat.
Av read all the similar posts in the forum but none seems to be helping.
I'd appreciate it if i get help.

visited a friend in lagos and
found out some FTA in his
house are 6 HD Arab stations
e.g NBC movies etc. Pls what tp
can I use to track these in lagos
and what's d direction? Thanks

please Guys, I need the frequency for tracking joytv and other fta channels. I am using SRT 4922A and a 60cm dish.I am from makurdi. I will appreeciate your assitance.
Whatsapp 08093822376

Contact me for any of your satellite TV installation and solutions in Abuja and its environs. 07039582380

Yo: guys i know this sounds funny.... But is there any possibility that I can add some dstv stations on my mytv decoder preferably music stations nd movies... Not Benin or Ghana stations