The [url]peanut peeling machine[/url]http://www.nuts-machine.com/Products/29.html is conveyed by a V-belt. After the new belt is used for a period of time, it will gradually elongate and appear slack due to the pulling force. Therefore, it is necessary to regularly check the tension of each transmission belt and the clearance of each fitting part. Make adjustments. During the operation, always pay attention to whether the speed, sound and temperature of the machine are normal. Every time after removing one type or one day of work, it should be stopped to check whether the bearings are overheated, whether the fastening screws and key pins of various parts are loose. If it is loose, it should be tightened at any time, especially for high-speed parts, such as: Whether the fan blades, especially the lower fan blades, are worn or broken, whether the reinforcing plates for external use of the blades are worn or deformed, and if problems are found, they should be repaired or replaced in time. For the suspension shaft of the sieve body and all the joints of the joints, it is necessary to check in time whether there is oil shortage and wear, and if it occurs in time, replace it with oil. After each operation, the bottom of the sieve machine, that is, the hole in the slats, is regularly cleaned with a wire brush. After the processing season, the machine is inspected once. Check the running and wear of each bearing; check the screen bottom for deformation or cracks; check the wear of the sorting screen. After the inspection, repair the damaged parts to remove dirt and residual peanuts from the machine. After the peanut sheller is used, the belt is removed and the machine is placed in a dry warehouse for storage. The removed belt should be hung on an indoor wall that is not exposed to the sun.