Eliminate germs and water waste with a tap activated by movement. It is easy to install and even easier to use.

Kitchen faucets are one of the dirtiest spots in your home. Dirty hands turn on the faucet, right after handling raw meat or cookie dough, and germs spread to the handles. And unless you sanitize the faucet after each use, dirt builds up.

Permanently eliminate bacteria by installing a hands-free kitchen faucet. The device is motion activated, so it will record the movements of your hand and automatically turn on when you need a wash.

It's a win-win situation - you'll save time and water, all while improving your health! Plus, a touch less faucet is quite simple to install.


Step 1: Place the faucet:

Turn off the hot and cold water supplies at the kitchen sink. Remove the old faucet, then thread the data cable, hoses, and stem of the new faucet through the bridge gasket.

Align with the bottom of the faucet body. Then insert the cable, hoses and stem through the mounting hole. If there are multiple holes, install the cover plate.

Make sure the faucet handle is on the right side and the spout is facing you before continuing.

Step 2: Safe Faucet:

Under the sink, slide the support plate over the cables, then slide the mounting washer onto the stem of the faucet. Make sure that the data cable and pipes are inside the curve of the washing machine.

Screw the mounting nut onto the faucet stem, then make sure the faucet is properly placed on the counter or sink. Tighten the nut with the supplied installation tool.

Step 3: Install the pipe bracket:

Install the pipe bracket about 2 inches from the end of the connecting pipe. Slide the bracket onto the end of the tap and secure it in place with a pipe guide nut. Guide in the spout of the faucet.

Remove the protective cap at the end of the hose and connect it to the tap with the quick-connect lines. Just press, hang up and hear an audible click indicating a secure connection.


Step 4: Connect the hose and power lines:

Connect the hoses and power lines by identifying the corresponding inputs on the control box. Remove the protective caps on the pipes and push them into place.

Pull lightly to make sure each tube is secure. Connect the hot and cold water supply lines. Secure the connection with an adjustable wrench - it should be snug but not too tight. Attack the cold side the same way.

Step 5: Installing the Control Box:

Install the control box by snapping it onto the tube guide nut. If you are mounting the control box on the base of the cabinet, install it where the data cable and pipes can reach.

Step 6: Connect the spray wand:

Attach the spray dispenser to the removable tube by removing the protective cover and making sure that the rubber washer and the screen are in place.

Slide the spray wand onto the drop hose and tighten with an adjustable wrench until the hose nut is flush with the wand. Be careful not to over tighten.

Find the white mark on the drop tube and install a weight just below it.

Step 7: Install the Battery:

Install the battery pack making sure the cable can reach the bottom of the control box. Remove the cover, insert the batteries, and then replace the cover. The battery pack can be fixed to the wall with double-sided tape or fixed with a screw.

Step 8: Connect the data cable:

Remove the protective cap and connect the data cable to the control box. Make sure the mini USB connection is properly aligned with the data port.

Use a zip tie to tie hoses and cables together, except for the pull-out hose. Then insert the battery cable into the control box. Make sure nothing is within 3 feet of the faucet sensors to ensure a proper start.

A blue light will flash at the base of the faucet. https://plumberslubbocktx.com

Step 9: turn on the water:

Reactivate the hot and cold water inlets. To ensure proper operation of the pull-out hose, make sure there are no cleaning products or objects preventing movement under the sink.