₦airaland Forum

Check very well pls. There should be over 200 millions of those padlocks there.

We only know of Engine Oil

I'm sure we were all expecting it.

U guys forgot his face ni?

Odiegwu. In this HARD TIMEs a lot more could be done if ATMs and banks have cash and not POS operators.

Jesus is Lord

Na so

How many cubs?

How true can this be?

Very good

Second or third time this year. God help us.

trendyprettygir:
Please I need help.

I have changed:
Radiator
Condenser
Complete fan
Radiator cover
Top gasket
Done surfacing of cylinder
Fan belt
Crankshaft sensor or so
I used coolant
Radiator hose has been checked
I changed oil and oil filter
Scanned (this brought the sensor matter)

Yet the radiator sends water to the reservoir and the reservoir is full but radiator remains empty. We have tried removing from reservoir and send to the radiator. Same thing repeats.Then the car temperature guage goes up and then comes down.

If I switch on ac temperature guage goes up and go down when I switch off.

Another thing is the car vibrates for few seconds when it’s started and then stops and it does not happen maybe till I start another time but not everyday or everytime. It’s Hyundai 2012 accent.

I am tired and depressed. I have spent a lot of funds fixing car. What could be the problem?

What is really wrong?

Check for blockages in all the pipes including the pipes in and out of the heater matrix. I believe the engine thermostat is not present as we speak but if present, remove and test its operation. Bleed the coolant thoroughly and start the engine. Allow bubbles to escape while engine is on idle the cover with the radiator cap. Observe and feedback.

Ayo8:
2004 Camry 2az Drivetrain making a loud buzzing/vibration noise on startup and when accelerating after engine rebuild. Engine overheated and crankshaft and components were changed because the previous was affected. Vibration disappears at 100km/h.
Had to use a street Mech for the job because of the location.

Your mech forgot to bolt down the balance cog on the camshaft sprocket before removal and obviously did not bolt it on in tension before installation. Its usually done by bolting down with a 10mm short bolt.

Repeat the procedure of camshaft removal and follow the instructions.

michytluv:
Good afternoon all, pls i want to replace my front shock absorber Toyota Corolla 2006. I need advice.
Thanks

Ok but what type of advice do you wnat here?

Just imagine

And they have a governor

What is the translation for Pythagoras Theorem in youruba language?

Also ignore that flirty lady. Her boyfriend is the local underworld kingpin. U can thank me later on this one.

Make una clap for am abeg

Mr Idiris Ne-nye-oku.

Where does bribe and settlement fit into these penalties?

Special adviser to the Presidents

They will be needing a real miracle soon

LOCATION: ABUJA

I just felt scammed. N1300 per litre yet the price signboard was showing N1050 per litre. Whats going on in your area?

This whole amount i just calculated seems like a big joke. N120k

No be until we see am?

Make una do quick sha. The traffic hold up is insane.

Make i just dey manage this my Toyota Corolla Tecno. Its so reliable but battery life is hmmmmm

Even Fulani herdsmen without any education dey buy car.

This suicide thing is getting rampant. Government should pls do something.

All these end time stories. Everyday building collapse in Nigeria. This thing is getting out of hand.

There is something in that tollgate that loves teargas.