jceesquare:

How does one be extremely careful in this context?
Not as if you made the transfer from your own end to the wrong account number

nurey:


Don't leave money in banks

Reduce daily transfer limit to bearest minimum

If you gonna leave money in bank, make sure it is a first generation bank

nurey:


Don't leave money in banks

Reduce daily transfer limit to bearest minimum

If you gonna leave money in bank, make sure it is a first generation bank

sonssyo:


First generation like UBA,

codemaster2much:
Hi Alfa Nurey, has this been done?

nurey:


Otilor we move on. Police sef chop 20k clean mouth

Dpzeewonder:
Mr.Nurey i quoted you Sir.Please i drive a Nissan Sunny ex saloon 2004 manual transmission.It happened that i was driving recently then i stopped in traffic,but i noticed my car was doing as if it was going to go off which prompted me to keep pressing the throttle just to keep the engine working.Thinking it was fuel,i bought more fuel then hit the road,this time around the car started jerking which i managed to drive it home.Later i took it to a mechanic's place to maybe increase what i understood as "SLOW",a move that got my car system destabilized completely because he first asked me to change my spark plugs,which i did,yet the problem persists,he loosen what he called Airflow meter,he loosen throttle cable.Once he starts the car,it will start normally and immediately the sound will reduce like the car will go off then picks up again.Since he did not get what's wrong,he disconnected a sensor telling me it the airflow meters that are beginning to go bad,immediatley he disconnected the airflow meter above the compressor,the check engine sign came up.
To shorten the whole story Sir,another mechanic looked at it yesterday who asked me to change fuel pump,buy injector cleaner,i did all these,yet no changes,he checked the sensors.While trying to check the crankshaft sensor located in a very difficult part of the engine,the car would not start again,when he tried to key in the sensor back as he was unable to remove it,the sensor broke,Now the sensor has been removed by a panel beater and i sent money for another one,when the car would not start he scanned it and he got a Crankshaft sensor error,now Sir what can you suggest with this whole story and experience of mine because this car is one car that does not give me issue but unfortunately am experiencing this at the moment.Kindly help,thanks.

calculation:

I read all your story about the car problem and this remind me of Nissan Primera with QD18DE engine. All what you experienced was exactly my experience and I sold the car as scrap. Though I later found out the root cause because I didnt sell the engine. The question now, Is your engine the same as mine?

Dpzeewonder:
QG15DE that's the type of engine it uses and the car is Nissan Sunny ex saloon 2004 model,manual transmission.What is the root cause of your engine's problem then please?

calculation:

In my own case two teeth of cranshaft sprocket got broken and lead to timing jump. So just set your timing first and check if it chain and all camshaft and cranshaft sprocket align properly. Also inspect all the 3 sprocket for teeth damage.