₦airaland Forum

Re

Te

Aw

At

Tt

Yy

Muyesky:
My apologies for the delay in response sir. The leakage is as a result of not the polyethylene bag not covering the edges very well if at all it was used. If really you have followed the steps I highlighted on the stages then the only thing left is to create another man hole to suck out water before using the water cement again. That should work.

thanks.

Muyesky:
Sealing the base of the septic tank:
1. Drain out existing and flowing water from the tank with a pumping machine
2. Pack out already settled mud
3. Introduce hollow blocks to the base in a bed like form
4. Cut planks to size of the tank to form a bed on the already laid blocks. This is to lift the base of the ground
5. Introduce a man hole that will serve as the means to suck out water after casting the base
6. Introduce granite to all edges around the tank to serve as blockage for any missed hole
7. Introduce polythene to cover the laid bed as a form of preventing any leakages
8. Mix sand, granite, normal cement and water sealant together and cast away.

You sure know your onion bro.well done man.

euromilion:
You sure know your onion bro.well done man.

Euromillion, I was following everything... I wish you didn't make the bad decision.

Hajji M.

more from the pop installation

mufutau55:
Euromillion, I was following everything... I wish you didn't make the bad decision.

Hajji M.

My brother,I've learnt my lesson.in my life there's no rooms for regrets.i'll make a correction and move on,I'll not let some ego maniacs hold me down.

Thanks for all yr care and advice.

hello muyesky. can i have your email address please . thank you

EndiaSami:
hello muyesky. can i have your email address please . thank you

muyiwaolakunde@rocketmail.com

Tr

Oy

Gy

Oi

Gy

Hy

By

Go

Or

Yt

Ji

Muyesky:
Sealing the base of the septic tank:
1. Drain out existing and flowing water from the tank with a pumping machine
2. Pack out already settled mud
3. Introduce hollow blocks to the base in a bed like form
4. Cut planks to size of the tank to form a bed on the already laid blocks. This is to lift the base of the ground
5. Introduce a man hole that will serve as the means to suck out water after casting the base
6. Introduce granite to all edges around the tank to serve as blockage for any missed hole
7. Introduce polythene to cover the laid bed as a form of preventing any leakages
8. Mix sand, granite, normal cement and water sealant together and cast away.

Hello sir,

Will this soakaway be emptied from time to time?

tsiriman:
Hello sir,

Will this soakaway be emptied from time to time?

At least, not in the next 10 years