Need rx300 naija used urgently. Car must be in bayelsa for inspection

How much can I get rx300 1999/2000 model cleared to lagos

1m 50k and we seal this deal tomorrow

Am interested in this car. Pls send last price and mileage to this email: rutsearts@gmail.com

Am interested in the 03 highlander V4. Pls send more pictures, mileage and last price to rutsearts@gmail.com

JT6HF10U0X0036394. Sorry this is the correct vin number. Thanks

Please help me check this vin JT6HFI0UQX0036994 out. Thanks

@cretin... Nissan xterra 2000 uses dextron III hence I went for seahorse dextron III which was the only brand I saw to buy.

I was able to drain the excess engine oil (removed about 2litre leaving about 3litre behind), checked the gauze and was just ok. I drove the car around. The hesistancy reduced but It̶̲̥̅̊ still drag and jerks b4 gear change. I read through the manual and discovered that It̶̲̥̅̊ should change from gear 1 to 2 at 15mph and gear 2 to 3 at 25mph which the cars did perfectly well. What could be responsible for the reving and single jerk before the gear change? Also noticed that the seal in the engine oil tank is leaking oil into the collecting pan underneath the car. Could there be sludge in the engine? Can I use oil flush? What type is best?

Would be in oghara close to benin until month ending b4 returning to bayelsa. Do you have ǻ repair station in benin?

@nissparts. What is RPM vibrations? I know for It̶̲̥̅̊ to change from gear 1 to 2 , I have to rev hard up to 2500rpm with loud noise then release my feet from acceleration abit before It̶̲̥̅̊ changes with ǻ forward jerk. It̶̲̥̅̊ has been like this since after 1st oil change last year, not progressive, still enters reverse, park or drive without hesistancy. Let me change to mobil 1 engine oil, put the 4litre and see if any improvement. Where is the PCR valve located?

@nissipart... Does overfilling engine oil have effect on engine performance? I was thinking since It̶̲̥̅̊ started after engine oil change, probably overfilling. I use 5litres but reading through my manual today discovered that I need about 3.3litres. Still xpecting your reply

@nissiparts ... The lag started about ǻ year ago after car overheated. I just stabilized the fan and did 1st oil change with total oil then noticed It̶̲̥̅̊ on driving home. I scanned then and the codes where p0141, p0325, p0160 and p0140. I changed both post catalyst oxygen sensor and distributor. Check engine light went off and ♧°˚NÕ̾°˚♧. Code on scanning but lag still persisted. I went ahead to service transmission by washing transmission filter and ATF change but lag still persisted

♧°˚NÕ̾°˚♧. Code. I scanned with my personal OBD 11 scanner. I was thinking of changing my plugs and engine oil from mobil xhp to mobil 1 5w-30. I am just confused, don't knw if this would solve it

Having similar issues with my nissan xterra 2000. Changed the post catalyst oxygen sensor and distributor(including power transitor, coil and camshaft sensor) but still draging with gear change from 1 to 2 and slow take off speed. I also drained and replace ATF with seahorse dextron 3 (6.5litres). ♧°˚NÕ̾°˚♧. Check engine light currently. Pls T-cann have you sorted yours out? What did you do?

Please help check this vin 4T1BF1FK3CU095510. Thanks for the good job. God bless you.

Thanks very much for the urgent response. I would call you on monday morning. I would be very grateful if you could create time to see the car before leaving

I want to know if changing the ATF and filter is what I need to do for my nissan xterra 2000 V6 3.3litres. It̶̲̥̅̊ takes ǻ long time changing from gear 1 to 2, apart from that there is ♧°˚NÕ̾°˚♧. Issue with transmission, check engine light is on, codes are P161,P141, P325, P160. Also what's the recommened ATF, how many litres do I need? What type of transmission filter do I need? How much? Where do I get It̶̲̥̅̊? Am in bayelsa state... Do you have ǻ service centre in bayelsa?

Please send the details of the catalyst issue to rutsearts@gmail.com. Thanks

Sorry didn't see your reply. How much do you sell the catalyst converter?

I need your help. I own ǻ nissan xterra 2000 and I have been experiencing this hesistence in initiate speed from ǻ stop. I mean if I slow down @ ǻ speed breaker or checkpoint to accelerate up to speed goes with low sound and reving up to 3000rpm and the car just jerks forward and rpm comes down to 1500, sound reduce and car picks up speed. The service engine light is on so I did ǻ scan and got these codes : PO325, PO141,PO161,PO160 . I was adviced to check the exhaust system which I did and sealed the opening but though the sound reduced but the hesistence and single jerk is still there. Please what can I do? The fuel consumption has increased markedly to like four times normal... Am in bayelsa state! I need your candid advice and help

I need your help. I own ǻ nissan xterra 2000 and I have been experiencing this hesistence in initiate speed from ǻ stop. I mean if I slow down @ ǻ speed breaker or checkpoint to accelerate up to speed goes with low sound and reving up to 3000rpm and the car just jerks forward and rpm comes down to 1500, sound reduce and car picks up speed. The service engine light is on so I did ǻ scan and got these codes : PO325, PO141,PO161,PO160 . I was adviced to check the exhaust system which I did and sealed the opening but though the sound reduced but the hesistence and single jerk is still there. Please what can I do? The fuel consumption has increased markedly to like four times normal... Am in bayelsa state! I need your candid advice and help

I need the remote for nissan xterra 2000. How much would It̶̲̥̅̊ cost me?

Happy new year. I appreciate the good work Mr Export1...Please help me check this vin 5N1ED28Y3YC561783 and send report to my email rutsearts@gmail.com. Thks