₦airaland Forum

louken:
2006 Rx330 AWD. 13 pin gearbox

Are you sure is 13 pin
Text me on 08167071246

AXYZ:
Gazzuzz

Please I'd need your help. I need to take my Toyota Rush 2020 to your shop. Do you know where I can find the front shock absorber?

Thanks

if you're ready contact me on 08167071246 lekki marwa, I'll get that for you

AXYZ:
Gazzuzz

Please I'd need your help. I need to take my Toyota Rush 2020 to your shop. Do you know where I can find the front shock absorber?

Thanks

08167071246

louken:
Ok. Thank you for the information.
Please can you give me an estimate of the cost of transmission control module (a.k.a gear brain box) of this vehicle.

Which vehicle

clinician2x:
I have misfire on cyl 4 (p0304) as the only code. Now when I clear it and drive, it will not show up and acceleration will be steady for as long as but once I park and get out, only to start the car much later to move, car will start jerking and check engine will appear and start blinking for a few seconds and acceleration will be steady if I drive for say 5 mins. On anothercold start however the cycle continues.. I have changed all plugs and mechs have cleaned the injectors.

Check your coil, take note most of the time if the check engine was blinking it relayed to bad ignition coil

timenamoney:
Re: Tell Us Your Car Fault Lets Assess And Fix Them by kingreign(m): 8:52am On Jan 17
louken:
I started experiencing sluggish acceleration at second and, sometimes, third. Beyond that the vehicle moves smoothly.
I scanned and got these codes: P0500, P0986 and P0798.
Please how do I tackle this problem especially with the last two codes that point to solenoid.
Will replacing the gear brain box solve the problem.
Also, where is the vehicle speed sensor A located. (P0500)

Car is 2006 Rx330 AWD



PLEASE KINDLY DISREGARD THIS UNRECOMMENDED ADVICE FOR TROUBLESHOOTING YOUR PROBLEM

THE GEAR DOES NOT HAVE IT'S OWN BRAIN BOX, RATHER IT HAS SENSOR'S, SOLENOID, VALVE, THAT REPORTS TO THE CAR ECU OR ECM (BRAIN BOX ) FOR PROPER TRANSMISSION AND ENGINE OPERATION FOR PROPER MOVEMENTS, THE MANUFACTURERS KNOW THIS ITEMS MAY GET BAD AND BE REPLACED, THAT WHY YOU HAVE THE CODE TO IDENTIFY THE PARTICULAR COURSE OF THE SLUGGISH ACCELERATION, AND WILL NEVER ADVICE YOU TO BUY A NEW TRANSMISSION , WHAT IF YOU BUY A NEW TRANSMISSION AND A TRANSMISSION OBD CODE COMES ON AGAIN , WILL YOU PREFER REPEATEDLY CHANGING TRANSMISSION'S ?

REMEMBER TIMENAMONEY

Most American and German vehicles have their own TCM TRANSMISSION CONTROL MODULE

vivalavida:
Please explain what you meant here by the engine oil change interval due to the the ECU reading how many tines the tire has rotated. Is this for cars where you can set their oil life?
And secondly, can one fully trust the oil life monitor in cars?

Lol this is going to calculate how many kilometers the vehicle has covered to determine when you are going to change your oil, it determined the next services, that's when maintenance required to shows up on your dashboard

louken:
Did that before coming to nairaland.
P0986 appeared in the first scanning.
P0500, P0986 and P0798 appeared in the second scanning

The problem is from valve body or ECM, thank you

kingreign:
Where did you read or heard or learn about this from?
It’s totally untrue and needless.

Do you want to hit the car in your front, can you explain more to me cause we learn from argument

Elvis8108:
Please am looking for any Nigeria used Volkswagen and Audi cars to buy. If it has fault don't worry I will fix it. Am into buying and selling.

Contact me on 08167071246

jojomario:
Where are you at?

Lekki, Marwa 08167071246

kingreign:
Wear the quoted pls.

Also, more quotes from Quora.com,
https://g05.bimmerpost.com/forums/showthread.php?t=1788962

Etc

take note, you can't idle when the transmission is in the drive when you are in the traffic, So if you want to idle you need to shift to neutral. So why idling? Shifting up and down is a bad idea.

kingreign:
Wear the quoted pls.

Also, more quotes from Quora.com,
https://g05.bimmerpost.com/forums/showthread.php?t=1788962

Etc

that's why we called it automatic, but if you want to relax your leg based on how much the traffic is you can put it in park ���

jojomario:
liasu Rd ikotun area Lagos.

Distance is bothering me, I for present myself

CruzJoe:
pls experts, what's the cause of this in a tier?
what will the mechanic work on, to correct it from chopping another new tier when changed.

Note: the other side of the car tier is still very okey, no single chopping. Only this driver side is chopped.

Your car alignment needs to be reset and check your lower arm bushing, tie rod 08167071246

josephsm823:
Lexus RX 350 2011 jerks when I step on the throttle pedal. It only jerks while accelerating anytime I step on the throttle pedal.
No check engine light ON

What could be the issue?

please I need help OGA GAZZUZZ

At times check engine may not on, call for a diagnosis at 08167071246

Nafizzey:
8:28pm
Good evening house, I need advice, my tyre model is Austone Athena SP, produced in 18/19 i.e. meaning it was produced around May of 2019 making it 4 year old this year 2023

Now my question is should I change the tyre ASAP now or I can use still use it till end of the year..

Note the tyres are not really pressed just within the City driving to work and back. Thanks

I need advice GAZZUZZ and other Gurus

It depends on how the tire rotation looks like, there is sure plug for austone make snap the tire number to me on WhatsApp 08167071246

samuelson06:
My engine oil is leaking from the top engine cover.

I need someone staying in Lagos to help me buy a fitting oil seal rubber. If you can help, please, let me know. God bless you in advance.

I can help you 08167071246

MedicH:
pls i have this noise called vvt rattle on my es 300. it only does on cold start. i have learnt it is a common problem of vvt engines and it is everywhere on youtube. I started noticing it as i clocked 265k miles on my car and she is still going fast. I plan to keep her till 500k miles. The mechs i have showed this problem asked about oil lights, i have none. Check engine light showed one o2 sensor is bad which i am replacing today. I used to have an oil shorting, breaking seals and smoking problems all of which were fixed after i replaced pvc valve and hose. the mechs say the noise is from the cam but i need to know what part of the cam and how many of them that needs to be replaced because i donot want any trial and error that will most certainly ruin this baby. i use fully synthetic 5w 30 which i change every 1500 miles for safety.

Where are you from, the sprocket need to be replaced ask at 08167071246

Osasxplus:
I have an es350 won’t crank security light flashing while the ignition is on steering wheel won’t unlock when I press the brake pedal is turn green but the push button does nothing at all I had key no detected issues before which they had to replace the smart key box with some IC 900 replace from the old smart key box car lock and unlock security alarm works fine but car won’t crank at all from start button please help

You will still need to reset or get the new normal smart key, it has lost communication, and this happened when your smart key fell down and scattered. Ask more at 08167071246

louken:
I started experiencing sluggish acceleration at second and, sometimes, third. Beyond that the vehicle moves smoothly.
I scanned and got these codes: P0500, P0986 and P0798.
Please how do I tackle this problem especially with the last two codes that point to solenoid.
Will replacing the gear brain box solve the problem.
Also, where is the vehicle speed sensor A located. (P0500)

Car is 2006 Rx330 AWD

After you erased the 3 fault codes, which fault code did it later bring? Because that fault normally comes from the gearbox valve body or ECM, ask me more about it at 08167071246

jojomario:
which of the Nigeria spare part market you think I should get it and at what range?

I can help you get here in lagos, Ladipo market 08167071246

frebor:
Lagos, no idea on price

I get who can sell it here in Ladipo market in lagos 08167071246

somez:
Greetings everyone. Please I am writing this with a worried heart. I left my car with my mechanic to change oil and left to buy some other things for the car servicing. Coming back, behold I found my mechanic ( he's boy actually) pouring the engine oil through the dipstick! I almost collapsed. Though I drove the car home with no issues, I'm still very worried. Would this cause any damage to the engine?

Thanks and appreciate your response.

is not going to cause any damage, the oil is going back to the bottom tray

This property is available for sale

[quote author=adisajoshua post=16852509]kindly help me out,my nissan Altima 2003 4plug just got head gasket change, no more oil and water mix but the engine shakes all the time as if finding difficult to breathe,yet it didn't stopped working
exhaust check,plug/misfire check says all is well,
yet the engine shakes until it reached 2000rpm,it idle at 800/900rpm, another mechanic says timing might not be well set, should I allow him to set timing chain again[/quote



That mean the timing was not correct

Ask whatever about wrangler and bmw mechanic

kingreign:
Contact Gazzuzz, create an appointment with him.

hello