For those who have a certain understanding of the charcoal production machine, they all know that if they want to produce a qualified mechanism charcoal, they must master the operation skills of the equipment and the experience of charcoal production. In fact, many people do not know how to use the rod making mechanism. The secret. As long as you master this secret, you don't have to worry about the production mechanism charcoal, and the success rate is greatly improved. So what kind of secret is it?

Secret one charcoal production mechanism rod machine propeller must be reformed

The key to a successful stick is that the charcoal production mechanism must be welded before the rod propeller can be used. The directly produced propeller can not be produced without welding and repairing. The low-cost propeller you purchased directly on a treasure is only A shovel can't be used without reform. The place of welding is the process of reforming the propulsion head. The charcoal production machine manufacturers need to repair the propellers one by one before they can be sent to the customers. Therefore, they can still be made without welding. At present, most of the low-cost propellers sold on the online store are unreformed and cannot be used at all. Most users may not know it yet.

Don't buy cheap scrap iron, and delay production of charcoal. At present, depending on the model of the rod making machine, the size and repair method of the propeller are slightly different. The 50-type rod making machine adopts the 490mm propeller, and the 80-type rod making machine belongs to the large rod making machine, using the 520mm propeller, and of course other The size of the propeller, due to the small demand on the market and the low frequency of use, is not recommended for users.

Secret two charcoal production mechanism rod machine thruster replacement and repair

The [url]Charcoal briquette machine[/url]http://www.charcoal-machines.com/charcoal-briquette-production-line propeller is an important part of the charcoal production mechanism rod machine, because it is a loss product that must be replaced or repaired after a period of time to not affect the quality of the rod. Under normal use, the [url]Charcoal briquette machine[/url]http://www.charcoal-machines.com/charcoal-briquette-production-line propeller should be replaced after about 12 hours. For example, if you have two pairs of shoes, you can wear them for a longer period of time. If you wear them all the time, the wear will be very fast. It is more expensive to wear than to wear a pair of shoes. The same is true for the stick machine. Some raw materials are more complicated in texture, and the wear on the propeller is more serious. It may take a shorter time to remove the repair (the wear resistance and heat resistance of the electrode used in the repair may also affect the use time). The wear of the front end of the propeller is less than 4 mm; the diameter of the inner hole of the finished rod is less than 15 mm; the spiral portion of the propeller is worn due to foreign matter such as iron, nails or the like. If the wear is more serious, it needs to be replaced, and a new propeller is used to ensure the quality of the carbon rod produced.

The above are the two secrets of being able to produce a good salary bar. Users want to produce good mechanism charcoal, and can refer to these operations, so that the quality of the produced charcoal will be more stable and the quality will be improved.