₦airaland Forum

bleexInc:
Hello House, what kind of pressing iron can I use with my 6kva inverter?

you can use any iron up to 1500w,the lower the better..6kva still have about 5000w ratings….

Shebi no be laundry business? Nah once in a while ironing…I say this because of the batteries…Leads acid batteries no like heavy loads

Fremlin:
Here is the thing, the voltage from grid is unstable, but with stabilizer, I get to charge my battery via the AC input of my inverter.
However, when I try to power my load thesame time while my battery is charging from grid, my freezer in particular shuts down often.

So, I was wondering, anyway I can make my inverter not to bypass, but just charge the battery, while I power from the battery that is charged.

your best bet is to get an external charger for the battery….disconnect inverter from grid..use external charger to charge battery while using battery to power freezer

ajabani4allah:
0705 316 1079. Just tell him you are an installer because he said that that price is installer price and for solar dealer buying in large quantities

okay thanks boss

olujosh301:
That's 620k for claimed 7kwh+ but the combo could only output 5kwh+ and don't forget that he also changed the bms at an additional cost. It's not worth it for me though there are other alternatives for for 12v 280ah battery. If you're on a budget it would serve though but the longevity or cycle is uncertain.

can you name these alternatives at affordable prices?

ajabani4allah:
Yes I do

can you share?

ajabani4allah:
310k

waoh e cheap true true …where did u get them? Do u have a contact?

ajabani4allah:
I was never expecting to extract the rated capacity from the battery because of the price so, it's still very ok and it's a good buy

sorry bosss how much did you get the battery?

bassdow:
SRNE is a good brand BUT doubt that's 60Amps because I got the 60Amps and higher. That one on the image is obviously probably 45Amps or thereAbout.

Also when it comes to Felicity, better you buy from where you trust as FAKE plenty for market. Better still buy from their office.

alright boss thanks big

Hi guys I want to order this charge controller from CDcare but I need to ask before I do..

Hope say nah correct Mppt cc and not glorified pwm..

Is this better than felicity 45amps cause this is 60amp and the price difference is 4k…

I’m on 12v system o with 2.5kwh lifepo4 battery….

Your advice bosses

abidemidare:
60amp available now, 100amp sold
.

how much is the 60amps

Darey00:
omo i don tire like this. My Bread inverter, barely-noticeable noise and beast mode stopped working last month and the support center just dey drag their feet so I got this Sako inverter.

The thing dey shout non-stop even under 100w load.

I no fit sleep

codemaster2much:
Hi everyone,I need help reviving a HenryLFE 12V 150Ah battery drained to 10.24V. The BMS is locked and the Bluetooth signal has disappeared (it won't show up on any phone/app).What we've tried:14.6V 20A LiFePO4 Charger: Won’t start; doesn't "see" the battery.Parallel Jump: Tried jumping with another battery, but the BMS won't wake up or allow the charger to take over. Help

sorry o how did you drain a battery to that extent? Even normal transformer inverter cut off at 10.8v…unless you are using sachet inverter….Anyways you can take it to their wherehouse or perhaps get the charger at Aliexpress

iraybuju:
Even if you waist your time and money go the warehouse the wrong time when Chinese Dey sleep then you go waist your money go back to house because them must approve the payment for head office for china then approve manager to release your goods. Your question should be how good the battery is, it’s very cheap and affordable but quality uncor if to say you Dey near me I for say make you come carry my own bought it last month.

so is the battery good? Compare to itel,cworth and taico and the like

hoover420:
Thanks, my system is just 12v but with the little load I am using it to carry, I’m sure one or 2 more panels will solve my problem permanently. Also using grid to charge it while on prepaid is another expense o.

broooooo especially when you are on band A

hoover420:
The Amps charging current is 60a
The capacity of the battery is 3.6kwh lifepo4 battery and most of the time, it usually get to 20 percent or 30 before charging it.
Today I left it at 65 percent at 9am and I switched on my freezer only (210w). By 4pm this evening, it was only able to give me an extra 10 percent from the panel. But with grid, the battery becomes full in just 3 and half hours. At peak sun, the panel doesn’t produce more than 300 watt at most and the panel is directly facing the sun

for a 1.5kva inverter,60a Waoh…Thos felicity 1.5 will be putting 20-30a..
It’s obvious majority of the power is going to your freezer and other things(charging and maybe fan).
Just approximately 80-90 watts is going to the battery…
You will need at least one more 535 watts panel,since you can’t find exact that just for 580watts,,I suggest u get 2 sef as we are approaching rainy season..if your system is 24v the controller should handle it effortlessly

hoover420:
Hello guys, I have a 1.5kVA Haisic inverter with one 535W Jinko bifacial panel installed. The single panel is not generating enough power to fully charge the battery during the day, so I still rely heavily on grid power to top it up.
I want to add another panel, but I can no longer find the exact 535W Jinko bifacial model I bought.
My question is, can I add a different panel (for example, monocrystalline panel) to work together with the existing Jinko bifacial one, or must I use the exact same 535W Jinko bifacial model?

first what’s the maximum of/Amps charging current of the inverter

What’s the capacity of your battery ?
And how much dod do you get to before recharge?
Angle of the panel too..

Cause normaly 40a cc should fast charge 2.5kwh lifepo4 battery even with that 535watts without many loads during pick sun

Good morning and happy new week..let’s have a wonderful week

Good morning and happy new week..let’s have a wonderful week

Good morning and happy new week..let’s have a wonderful week

Good morning and happy new week..let’s have a wonderful week

kingviny:
Call to swap or change your batteries to a quality one.

bro do you still run this swap deal ?

peohum:
Please help ooo

I also need a 2kva 12v inverter hybrid inverter.
Please recommend a good product and source.

itel,felicity,,cworth,, are okay and quite cheap too

ask4bk:
Thanks, but isn't there inverters that come with that also? Not ready for all that work of changing fans.

Any inverter brand in mind?

he’s just trying to help you cut cost of getting a new one..any inverter is okay,,Felicity,luminous,cworth,itel…..The capacity and voltage depends on your loads and system,,

justcallmenuel:
360k

for 1.2kwh

justcallmenuel:
1.2kwh 12v felicity lithium battery available.

how much boss

Penuelseun:
ok, you can use your current inverter, then get an external charge controller for the panels, or just get an hybrid inverter

I have a question boss….i can’t afford Mppt cc for now…..can I use pwm cc of 60A with a single 450-510watts solar panels to charge the 12v 2.5lifepo4 battery…..my loads during the night won’t pass 100watts….thats about 50% DOD

Penuelseun:
you can use your old inverter with the battery but get an external charger to recharge. Do you have solar panels installed?

not yet chief…but I will get one after 2 months of getting the battery…

tziz:
I use a 1.5Kva 12v Haisic Hybrid Inverter. Yes, u can't use ur old Luminous inverter to charge the Lithium Batt. U will need an external Smart Lithium Iron Battery charger and/or solar Charging. Or u can just sell off the Luminous and buy a Hybrid inverter. That's what I did, sold my Mercury 1kva Transformer inverter before I went for Hybrid.

oh okay…..how much can I get this hybrid inverter? Can’t I get a used one?