₦airaland Forum

kingreign:
It should, but then, an aluminum smelter can redo the broken bit off.

Ok, I will ask him when he comes. Thanks 🙏

kingreign:
What's the update on this?

The driller couldn't come today but tomorrow. Another spot near the damaged part will be drilled open. According to the mechanic, a longer belt than the initial one will be installed due to the new position.
I pray it works 🙏

Macmilla:
Here I am thinking my engine is dirty. Damn!

Hapu ihe edere na motor banye na motor. The road to my area, I must swim mud in an out. Govt no gree show up. But hope dey😁.

Ngwanu, I need Ur contribution to the original question.









Pity my DC on the same road!

kingreign:
It can be redone by tuners or aluminum smelters /fabricators. Engine may need to be dropped.

Ok. I will insist they try it. The engine is on the ground already. Thanks

luvinhubby:
If you have a good mechanic, change the engine block

The damaged part

Blackbishop:
I can only give my professional opinion if I see the damage

The damaged part

kingreign:
Snap the defective part let's see

The part marked red.

Nagode!!!


34 more characters needed. So long, me tired.

kingreign:
You don't need to change the engine just yet, something can be done to repair that broken alternator holder.

Biko can U give me a hint.... The mechanic claimed that the holder is made of brass not iron

Greetings Blackbishop.
Please how do I go about fixing this?
2003 honda pilot: the alternator has 2 bolts connected to it. The down one (size 14), which goes into the engine block has damaged, after constant breaking of bolt and drilling the bolts out.

The last one happened yesterday and now, the part to tight it in on the engine is gone. They suggest I change the engine. Gambling to get only the engine block was not advised according to them.

What do you think?

Greetings Luvinhubby.
Please how do I go about fixing this?
2003 honda pilot: the alternator has 2 bolts connected to it. The down one (size 14), which goes into the engine block has damaged, after constant breaking of bolt and drilling the bolts out.

The last one happened yesterday and now, the part to tight it in on the engine is gone. They suggest I change the engine. Gambling to get only the engine block was not advised according to them.

What do you think?


Cc: Macmilla

Greetings Kingrein.
Please how do I go about fixing this?
2003 honda pilot: the alternator has 2 bolts connected to it. The down one (size 14), which goes into the engine block has damaged, after constant breaking of bolt and drilling the bolts out.

The last one happened yesterday and now, the part to tight it in on the engine is gone. They suggest I change the engine. Gambling to get only the engine block was not advised according to them.

What do you think?

Present APC administration attacking immediate past APC administration. Fools!!!

MarkNsukkaBread:
Is it people who have not been able to feed themselves that you want to mandate to buy drones?

Nah! Be positive ori okpa nsukka, do U expect everyone on a street to buy it? Those that can afford it should be encouraged nah.

The govt should encourage it's citizens or residents to buy drone. When things like this happen, leave the rest to Nigerians with their drones. Technologia!!!

No where to hide, if we can do something with fones, drones will be small case.

Rumundele:
My Engine vibrate like my head is going to be disconnected from the rest of my body especially when i put on AC. My car is DC 07, I don't enjoy driving anymore.
Secondly my gear delay and kick when i engage either drive or reverse.
Experts in the house i need your advice snd way to go.

Scan the car. The gear might be waving U goodbye in advance. The vibration? Maybe an illegal compressor has been installed in the car or fuel system is clogged.

New engine loading..... For now keep topping it up.
It's a pity. When U gauge the oil, rev up the engine to 2500/3000 rpm. Check the exhaust for smoke.

#2.5m if everything checks out.
Where's Ur location in surulere?

U just saved ursef from STDs and STIs....



Just imagine? Expecting payments for 3..... Thief

Thief!! Schoolmates thief!! Presidential thief!! Everything thief!!!

Always talking. Cho Cho Cho. U can't do anything. Not with Trump! Man with balls.
Do anyhow and see anyhow. 😄

Is it still available?

Na wa o. This 40 characters of a thing no be here.

How much last, if it's still available?

Jaysharp:
No leaks at all, I have used 2 different mechanics to check this.

If you are not seeing any leaks, then the engine is burning up the oil. Fill it up to required level, then push the throttle to 3000/4000 rpm, watch the exhaust for smoke.


Get ready to replace the engine or find someone capable to overhaul the engine, then manage it for some months/years.

[quote author=Blackbishop post=135570086][/quote]Thank you. How much can I get it? I dey east, hope to find it.

Blackbishop:
Corolla – P2195, P0171, P0420, P0031, P2238

Corolla with fuel efficiency below threshold with all these codes

P2195 – The oxygen sensor (O2 sensor) signal is biased or stuck lean

P0171 – System too lean bank 1

P0420 – Catalyst System Efficiency Below Threshold

P0031 – The heater for this sensor has a low resistance reading

P2238 – O2 Sensor Positive Current Control Circuit Low Bank 1 Sensor 1

These are the codes and simple meaning.

Symptoms

Rough idling
Black smoke at start up and intermittently
Bad fuel efficiency
Spark plug with black soot within a short period of time.

Solutions

Running a comprehensive diagnosis

Here are parts replaced

Air/Fuel Ratio Sensor
Oxygen sensor (the sensor after catalyst)
MAF – Mass Air Flow Sensor
A spacer for the oxygen sensor

After replacing all the part and wiping all the codes, drove the car for an extended period of time. The code never came back neither was the black smoke or rough idling.

Please, Blackbishop, which of the O2 spacer will fit Honda accord DC i4 engine?

Tinubu does not want anyone to emulated him.

Same thing happened to me, from same Enugu state. Same story. I gave it hot back to him. Ndi ala!!!

Meanwhile, fogman Baba, how much I fit get this? I saw it from late gazzuzz topic.

fineboynl:
I bought it 4k

Hope it's this one.

yes

Naezy:
As a bona-fide vehicle Licence Office under the Enugu SIRS, Saloon/Saden cars =, 25k ( Insurance, Proof of Ownership, Vehicle Test/Roadworthiness, Radio Licence, and Vehicle Licence) while SUV = 26k with all papers mentioned above. For Commercial Cars/Buses, we charge 28k which includes Hackney Permit. We also do Driver's Licence Renewal and New registration both 5yrs and 3yrs.
Hurry now and get your papers done authentically and within 2days.
My contact: zero eight one, sixty seven, seventy six, eighty six, thirty nine.

How much for change of plate number? Everything.

fineboynl:
Which grease is best for Honda cup?

There is the rubbish grease one mechanic use on the shaft cuo and after few days it turns something like water. It ruins the cup which now need change now.

Also which brake pad is best for Honda disk that will not be making those braking noise when marching brake.

Go for MRS grease, last time (like 2yrs) I bought it, it was around 8k. And it lasted well.

I have been using asimco brake pad. And they last well without noise. Though, I think fake ones have been introduced.

Cc: Luvinhubby and hondajosh