₦airaland Forum

My Mechanic serviced my Throttle body for no reason and since then my Infiniti G35 2007 on idle (On Park or Neutral gauge) revs up and down continuously between 1100 to 1900 forever. On Drive gauge the engine is too high. We have checked with computer and computer did not see any problem with the engine. What do I do. Anybody with experience on this.

I have bought the Throttle Body four times from Lagos in the last three weeks and all of them still rebs up and down. The Mechanic guy used his computer to try and bring it down to no avail. I am confused on what to do next, I just need help.

Good Morning all. Please is their anything like Horn Turn on Honda Odyssey 2002. It is presumed located inside the Steering so when you press the horn it will blow.

Good Evening all. Please is their anything like Horn Turn on Honda Odyssey 2002. It is presumed located inside the Steering so when you press the horn it will blow.

MrBuzy:
Good day,
There is no Cel light on.

Good day
Please how much is
1. Infiniti G35 2007 Throttle Body
2. Infiniti G35 2007 Airflow Meter

kingreign:
Coupe or sedan?

VQ35DE or VQ35HR?

Location pls


You may wish to try any or all of these.

Try all of these...

**a quick reset can be accomplished by disconnecting the negative battery terminal, and depressing the brake a few times.



ECU Resetting Procedures
Timing is extremely critical. If it is NOT DONE within the specify time, the ECU will not reset and the Check Engine Light (CEL) will continue to remain ON.
Operations Procedures
1. Confirm that accelerator pedal is fully released, turn ignition switch “ON” and wait 3 seconds.
2. Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds.
2a. Fully depress the accelerator pedal (HARD).
2b. Fully release the accelerator pedal.
3. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 10 seconds until the CEL starts blinking.
4. Fully release the accelerator pedal (while the CEL is still blinking)
5. Wait about 10 second.
6. Fully depress the accelerator pedal and keep it for more than 10 seconds.
7. Fully release the accelerator pedal (The CEL light will continue to blink).
8. Turn ignition switch to “OFF” position and now you can start the car. The CEL light should be gone.
If the CEL light continues to remain ON, repeat the above steps. Timing is EXTREMELY critical to resetting the ECU.


Accelerator Pedal Release Position Learning
Operation Procedure
1. Make sure that the accelerator pedal is fully released.
2. Turn ignition switch “ON” and wait at least 2 seconds.
3. Turn ignition switch “OFF” wait at least 10 seconds.
4. Turn ignition switch “ON” and wait at least 2 seconds.
5. Turn ignition switch “OFF” wait at least 10 seconds.


Throttle Valve Closed Position Learning
Operation Procedures
1. Make sure that accelerator pedal is fully released.
2. Turn ignition switch to “ON”.
3. Turn ignition switch to “OFF” wait at least 10 seconds.
Make sure that the throttle valve moves during above 10 seconds by confirming the operating sound.



Idle Air Volume Learning (Throttle Position Learning)
It is better to count the time accurately with a clock. 1. Perform “Accelerator Pedal Released Position Learning”.
2. Perform “Throttle Valve Closed Position Learning”.
3. Start engine and warm it up to normal operating temperature.
4. Turn ignition switch “OFF” and wait at least 10 seconds.
5. Confirm that the accelerator pedal is fully released, then turn ignition switch “ON” and wait 3 seconds.
6. Repeat the following (steps 7a, 7b) procedures quickly five times within 5 seconds.
7a. Fully depress the accelerator pedal (HARD)
7b. Fully release the accelerator pedal.
8. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 20 seconds until the Check Engine Light (CEL) stops blinking and turned ON.
9. Fully release the accelerator pedal within 3 seconds after the CEL is ON.
10. Start engine and let it idle.
11. Wait 20 seconds.
12. Rev up the engine two or three times and make sure the idle speed and ignition timing are within the specifications.

Good day,
There is no Cel light on.

MrBuzy:
Good day,
My Mechanic serviced my Throttle body for no reason and since then my Infiniti G35 2007 on idle (On Park or Neutral gauge) revs up and down continuously between 1100 to 1900 forever. On Drive gauge the engine is too high. We have checked with computer and computer did not see any problem with the engine. What do I do. Anybody with experience on this.

Good day
Please how much is
1. Infiniti G35 2007 Throttle Body
2. Infiniti G35 2007 Airflow Meter

Good day,
My Mechanic serviced my Throttle body for no reason and since then my Infiniti G35 2007 on idle (On Park or Neutral gauge) revs up and down continuously between 1100 to 1900 forever. On Drive gauge the engine is too high. We have checked with computer and computer did not see any problem with the engine. What do I do. Anybody with experience on this.

Good day,
Please how much can I buy Honda Odyssey 2002 to 2004 Headlamp.

Good day. Please do you have Headlamp of Honda Odyssey 2002.

aieromon:
5w-30 recommended

What have you been using?

Can I use this one.

Good day. Please what Engine oil can I use for Infiniti G35 2007 Model.

kingreign:
Meanwhile, guys be careful of the RE5R05A.

What does RE5R05A mean.

dannybrasky:
How about speed and handling.
I know you love that

Like I said earlier, that car is something else. I enjoy it most during overtaking.

I have the 2007 Model of Infiniti G35. The car is very good and strong. Three things I don't like about the car is; 1. The inside is two small for a tell guy especially if you have to carry people at the back.
2. The Dashboard is cranking like Toyota Sienna.
3. The car is almost on the ground. So it is not all Nigerian roads you will ride the car.

Good day please how much is the Air intake Hose of Infiniti G35 2007.

Good day. I have a 2002 Honda odyssey which I just changed it's gear box some months ago. Two week ago the gear started acting up. If you are driving the car, at any point maybe gear one or two or third gear the car engine will vap up because the gear could not select. What I don't really understand is that it may happen in gear 2 now and the next time gear 3 or 4. Please what do I do? Is their any hope on that gear? Is any particular thing causing this problem?

MrBuzy:
Still Available.

Still Available.

MrBuzy:
Still Available.

Still Available.

MrBuzy:
Still available.

Still Available.

MrBuzy:
Still Available

Still available.

MrBuzy:
Still Available.

Still Available

MrBuzy:
Still Available.

Still Available.

MrBuzy:
Still Available.

Still Available.

MrBuzy:
Still available

Still Available.

MrBuzy:
Still available.

Still available

MrBuzy:
Still available

Still available.

MrBuzy:
Still available.

Still available

MrBuzy:
Still Available.

Still available.

MrBuzy:
Still available.

Still Available.

MrBuzy:
Still Available.

Still available.

MrBuzy:
Still available.

Still Available.

MrBuzy:
Still Available.

Still available.