280 Webmoney needed

GAZZUZZ:


that's it!

It will never turn out well. Switch back.

Ha. switch back just like that...in this Buhari regime.

I didnt have this noise until i changed belt tensioner. What can we do to savage this? i can't afford a new engine now. I know some CRV come with K20A engine

GAZZUZZ:


Did you replace engine recently?

A year ago the engine was replaced. K24A for K20A

Hello Gazzuzz

I am having a few issues with my car. Honda CRV 2002. I hear this growling noise when i accelerate either in reverse or drive. It comes from the power steering, compressor, tensioner area. I can't pin point the exact cause. Beside my serpentine belt is off by one thread but i doubt if that is the cause.

Also there is loss of power and i have a "Pending Code" - P0172 - System too rich. My A/F sensor reads about 0.6V. Short term and long term trims are in the negatives.


i need epp oooo

Hello everyone,
I need to get a smart charger 24V with 40A or more for a gel battery

bigrovar:


You need to come clean on all your setup to be able to get good advise here. Especially has you have confirmed to be a noob on this subject. At least let us know what controller u are using, the estimated distance between charge controller and solar panels. There is no standard advise that apply to all type of setup. How u string your panel depends on many variables. Let us know the type of controller especially the model and rated output etc. Then u will get best advise not just a generic advise which might not apply to your setup.

Okay sir. I plan on using a Fangpusun Flexmax 60A. Approximate distance between panels and controller is about 40ft from my estimation.

Batteries are 2V 500Ah Huawei Agisson setup in series for 24V.
Inverter is a 1.5KVA Safe power.

Please let me know if i missed something out.

Thanks

life707:

Voc = 37.33V
Vmp =29.81V
Ioc =8.93A
Pmp=250W
I want to connect 4 solar panels of the rating above in parallel to get as much current as possible. Is it a good setup?
Battery to be connected in a 24V setup
2v 500Ah Gel
Max Charging current is 100A
Float is 2.23V
Cycle is 2.35V


Depending on the charge controller you are using.

1) if it's 24/48v CC, then 2 x 2 is ok.
This should be atleast 25A

But

2) if it's 12/24v CC, then all 4panels should go parallel. This should be atleast 40A

Okay.. But how does the CC affect this? I be noob no vex

DMerciful:
Best connection is 2 by 2 ie series-parallel.

What would be the total Vmp and Ioc i would get from the 2 by 2?

Voc = 37.33V
Vmp =29.81V
Ioc =8.93A
Pmp=250W
I want to connect 4 solar panels of the rating above in parallel to get as much current as possible. Is it a good setup?

Battery to be connected in a 24V setup
2v 500Ah Gel
Max Charging current is 100A
Float is 2.23V
Cycle is 2.35V

earthrealm:
@xreakz, those batts r gel, u gotta pamper them real goods, gels are quite reliable, but delicate, once they dry out, usually caused by overcharging/improper inverter/charger...then its all over, its irreversible....priced dem a cxouple of months ago, they were going for btw 38k n 45k for new, toks abt 25k or 30k

hope ur inverter/cc/batt charger has a gel setting?

My inverter doesn't have special settings. It is a SafePower 1.5Kva one of those Indian brands

Braaad:
Hello sir...I need those kinds of battery.
are they new of fairly used? where can I get them?

Im in the south.

Sorry sir.. Got them a while back. The guy no longer stocks them

shithapuns:


ur batt appears like 2v 500ah batts?...abi 800ah.
pls confirm the amperage, 500ah wud be easier for ur cc to charge than 800ah, hope u know abt the c/10, c/8, c/12 formular for smf/flooded/gel batts

They are 2v 500AH. I dont know abt the c/10, c/8, c/12 formula.. But am right.. Are these gel batteries

chris81964:

More than enough. Depending on your battery type, you will see about 28 to 30 v during the charge cycle. I have 2 kw on 24 V 60 amp controller. Works fine

How much current do you get?

Here is my battery type. I think it is gel

Good morning guys. Is a 40A CC good enough for a 1000W solar panel with 24V battery backup. The calculation puts the requirement at 41.67A or do i go higher like the 45A?

JUO:
super device believe me you won't regret getting one. Suitable for any kind of battery

Thanks bro.

Any chance for a bright pic?

Anyone using this epsolar 45A or 60A mppt controller? Is it a good substitute for the more expensive American products like Outback or MorningStar?

Thanks

Thanks everyone for the replies...

Today was a bit cloudy and no sunshine... How much power did you generate today from ur solar panel.. What happens when the rainy seasons fully kicks off?

JUO:

Please chip in.

Does this mean i can practically have a 1KW Solar panel + a 3KW inverter with good batteries then conveniently run a 2KW load without frying anything?

DMerciful:
You panels charges ur batteries so the load does not directly burden d panels but your batteries so that the maximum load you can power depends on ur inverter capacity. However with solar or inverter, u want to reduce ur load as much as possible to have good benefit from it hence d advocacy of low energy appliances.

DMerciful:
Don't waste ur money on solar inverter. If you are satisfied with ur current inverter performance then buy only solar panels and an mppt charge controller. Connect these to ur current system and you're good. Same thing I am currently doing.

If i am to setup a 1KW solar panel, can i use say 3kw from this setup if my inverter can handle 3kw. I am trying to understand if the panels charges the battery and supply power to your load and you a limited to max rating of your panel or it charges the battery and your load is limited to the max rating of your inverter.
Thanks in advance

Hello gurus, what solar inverter brand would you advice one to get. I am looking to upgrade my current battery-only setup to a solar + battery + AC setup.

Thanks in advance

Hello Fogman,

Do you have any 2DIN running on android 4.4? If available, what is the cost of the device without installation

Thanks

Hello. Please i need Oxygen sensors for Honda CRV 2002. How much is the pair? Mine was "chopped off" by the last mechanic that worked on the car before i got it

Hello everyone.
Is there a major difference between a Canadian Masters and a PostGraduate Diploma outside there names? Please let's consider this based on viability of taking a paid employment after schooling.

Also let's look at the fact that some Masters Courses are way cheaper than PostGraduate Diploma in related fields. Thanks

Fhemmmy:

Check with your friend well to make sure it is not fake or scam . . . .

Thanks bro. He finally got an Immigration Consultant to handle his case.

Fhemmmy:

Ok

Oga Fhemmmy, what should his next step be?

Fhemmmy:

Check with your friend well to make sure it is not fake or scam . . . .

It is the real deal. He has his LMO and an appointment letter. His job falls under section 2174/2175 under the NOC classification.

Hello People, a friend of mine just got a job in Canada and has to relocate. Please he needs to know the kind of visa to apply for and how long it would take.

Thanks and God Bless.

Siga: .... I believe u can make payments with any major credit card ... u will have to submit all the docs attached plus any extra u get when requested....just ensure u fulfil the checklist

Thanks boss. This is quite helpful. Many regards. Please, do you advise I write a letter of intent. If yes, what should it contain

Hello Good people of NL. Hope the evening is been good to y'all. Please I need help with applying for a study permit via the online applicatioñ portal.I already have per§onal checklist code. The challenges now are:
1. Would pÀyment via a credit Çard be accepted?
2. What documents do I take to VFS afterwards.

Thanks

Happy for those that have gotten TRVs and those undergoing medicals. We walk/work by faith.

i was refused a study permit on some funny grounds earlier this month.

- The VCO stated that i didn't have a travel history
- Also that there wasn't proof that i would return to my country
- and finally 'NOT A BONA FIDE student'.

Can the TRV scholars help me tackle this because i"m ready to start off another application

Thanks