ENGINEERING DESIGN TRAINING FOR P&ID, PLC & SCADA Nov 2012
Piping and instrumentation diagram
A piping and instrumentation diagram/drawing (P&ID) is a diagram in the process industry which shows the piping of the process flow together with the installed equipment and instrumentation.

An example of a P&ID.


A piping and instrumentation diagram/drawing (P&ID) is defined by the Institute of Instrumentation and Control as follows:
1. A diagram which shows the interconnection of process equipment and the instrumentation used to control the process. In the process industry, a standard set of symbols is used to prepare drawings of processes. The instrument symbols used in these drawings are generally based on International Society of Automation (ISA) Standard S5. 1.
2. The primary schematic drawing used for laying out a process control installation.
P&IDs play a significant role in the maintenance and modification of the process that it describes. It is critical to demonstrate the physical sequence of equipment and systems, as well as how these systems connect. During the design stage, the diagram also provides the basis for the development of system control schemes, allowing for further safety and operational investigations, such as the hazard and operability study (HAZOP & HAZID).
For processing facilities, it is a pictorial representation of
• Key piping and instrument details
• Control and shutdown schemes
• Safety and regulatory requirements
• Basic start up and operational information

At the end of the training real projects with live datas from SHELL Pet. Dev Co. will be used illustrate
***Interpretation/mechanization of P&ID

P&ID Course contents
• Instrumentation and designation
• Mechanical equipment with names and numbers
• All valves and their identifications
• Process piping, sizes and identification
• Miscellanea - vents, drains, special fittings, sampling lines, reducers, increasers and swagers
• Permanent start-up and flush lines
• Flow directions
• Interconnections references
• Control inputs and outputs, interlocks
• Interfaces for class changes
• Computer control system input
• Identification of components and subsystems delivered by others
• Mechanization of P&ID
• Gap Analysis etc….

Date: Nov 7th & 20th 2012 etc…
Venue: SIEC CONSULT
315 Aba Road
2ND FLOOR, IZZI HOUSE BY IZZI BUS STOP
ABA ROAD, PORT HARCOURT
RIVERS STATE
Phone: +2348064919891, +2348035992896, +2348122965823, +2348154645666
Special considerations for corp members!

PROGRAMMABLE LOGIC CONTROLLERS (PLC) using Omro Syswin software
• Introduction to PLC
• What is control in PLC
• Ladder Programming
• Assembling of PLC
• Addressing PLC
• Rack Layout and Addressing
• Omro Syswin software and features

SUPERVISORY CONTROL AND DATA ACQUISITION (SCADA)
• What is SCADA
• Process control and SCADA
• Types & Designs of SCADA
• Addressing in SCADA
• SCADA software for configuring control

Date: Nov 7th & 20th 2012 etc…
Venue: SIEC CONSULT
315 Aba Road
2ND FLOOR, IZZI HOUSE BY IZZI BUS STOP
ABA ROAD, PORT HARCOURT
RIVERS STATE
Phone: +2348064919891, +2348035992896, +2348122965823, +2348154645666
Special considerations for corp members

Call 08064919891

Helo pls sori if i may ask wat are d inquries cos me no finish skul o hope person wey no finish skul fit com? jus askin cos dem say person wey ask question no de miss road na hm mak i ask cos i no wan miss road. Waitin for ur reply

How much is this training or is it for free?