Caesar II is a software used in the oil and gas industry for analysing the amount of stress developed in a piping system due to weight ,thermal and occasional loads such as wind ,earthwake ,wave etc .Hence,providing support where needed on the system to prevent the failure of the system and to also keep the stress developed within the allowable limit as specified by the relevant codes eg ASME B31.3.
An opportunity is here to acquire a comprehensive training on not just the software but about Pipe Stress analysis and become a Pipe Stress engineer.The course contents are stated below

 Inputs Required for Stress Analysis

 Classification of Critical & Non Critical Lines

 Pipe supports Selection & Span Calculation

 Expansion Loop Design & Flexibility Calculations as per ASME B 31.3

 Wind Load Calculation

 Flange Leakage Calculation

 Building of Input Model in Ceaser II

 Introduction to LOAD CASES.& Building Up using CAESARII

 Pump Suction Model & Analysis

 Pump Discharge Model & Analysis

 Static Analysis of Model

 Qualifying Nozzle as per API 610 - Pump Nozzle Analysis
Interfacing between CAESARII AND PDMS
GENERATING PIPING STRESS ISOMETRICS IN AUTOCAD


Call 08036614808 for further details