Welcome, Guest: Register On Nairaland / LOGIN! / Trending / Recent / New
Stats: 3,152,704 members, 7,816,881 topics. Date: Friday, 03 May 2024 at 07:20 PM

. - Car Talk - Nairaland

Nairaland Forum / Nairaland / General / Car Talk / . (407 Views)

My Mechanic Uses Total Quartz Motor Oil 20W-50 For My Steering Pump. / Symptoms Of A Bad Power Steering Pump / Price Of Toyota Camry Tiny Light Power Steering Pump (2) (3) (4)

(1) (Reply) (Go Down)

. by bukitt: 1:47pm On Jan 04
.
Re: . by fineboynl(m): 2:25pm On Jan 04
bukitt:
Pls help my land cruiser power steering is still stiff but no noise when steered to the end like it used to before I changed power steering pump.


After just a few turns, it loosens up and becomes smooth.

Make una help.
which fluid you are using? Did you buy used pump?

Buy a new pump and use power steering fluid. Not engine oil.

2 Likes

Re: . by Requestmechanic: 2:37pm On Jan 04
1. Check air pressure of your car tires

If you find out that your steering wheel hard to turn at low speeds, the first thing you should check will be the air pressure of all your tires. All tires of a car should be filled with equal air and stayed at automaker’s recommended PSI (Pound per Square Inch) in order to prevent improper air amount in tires that leads to stiff steering.

2. Check power steering condition and fluid level

Steering wheel hard to turn at low speeds can happen due to some problems related to power steering fluid level and condition. Therefore, if this case occurs, you need to check both power steering condition and fluid level. (Note: You can easily found the power steering fluid in a cylindrical reservoir which is close to a power-steering belt and being labeled clearly. The cylinder may be a plastic cylinder or a metal one). Inadequate fluid is the reason makes hard and stiff steering. Thus, you need to keep the fluid at accurate full level and the color should be a dark red. If you observe that the fluid color is too dark and old, it’s time for you to change the fluid.

3. Check the pulley on the power steering unit

When your steering wheel hard to turn, inspecting the pulley on the power steering unit is what you should do. Notice that you only check the pulley when the engine of your car off to ensure the safety. Normally, proper tension doesn’t exceed one inch of play or three quarters. For checking tension, you just press your thumb down on the belt. Make sure that the pulley belt condition is good enough with no cracks or frayed edges.

Moreover, you also take a visual check with the car engine running to ensure that the pulley belt is running well. If you observe that the belt is slipping, you can face stiff and erratic steering.

4. Check the power steering unit

Next thing to do is inspecting the power steering unit. As a leak from connecting pressure hoses will decrease your pressure and thus leads to hard steering. Hence, a visual check for fluid leaks here is what you should do.

5. Check the front end parts

Check the front end parts like tie rod ends and ball joints for wear and lubrication. Too much wear on ball joints or tie rod ends is too dangerous and can cause steering wheel to turn as well. Inspecting these parts to make sure that your car has got proper front end alignment. A warning sign would be irregular front tire wear and your car will pull to one side when you drive it. You can face stiff steering, particularly when you make a turn if all the wheels of your car are not aligned precisely.

Moreover, regular maintenance and scheduled servicing are the best ways to keep your car free of this problem. You should check the fluid level at regular intervals. Also, make sure to have the power steering system diagnosed every time you send the car to a servicing shop for the schedule checkup. You could do further consultation on www.requestmechanic.com by clicking request now.
Re: . by bukitt: 2:50pm On Jan 04
.
Re: . by bukitt: 2:53pm On Jan 04
.
Re: . by fineboynl(m): 3:56pm On Jan 04
bukitt:


I’m using power steering fluid and I also bought used pump. The pump is ok as the pressure was tested and doesn’t make that noise when steered to the end.

Changed tyrod but ball joint was ok except bad front tyres.

Could it be the rack?
it is the pump if tour stering fluid level is ok. Never buy used pump. Talking from experience.

New pump will givd you peace of mind for at least 2 years. Go and return the pump.

1 Like

Re: . by Requestmechanic: 9:57pm On Jan 04
bukitt:


Thank you. Can i replace tie rod only without ball joint?

Yes you can replace, but would need alignment after replacing so it doesn't repeat same issue
Re: . by felix55(m): 4:35am On Jan 06
fineboynl:
it is the pump if tour stering fluid level is ok. Never buy used pump. Talking from experience.

New pump will givd you peace of mind for at least 2 years. Go and return the pump.
I have change upto 3 pump .. they will work like 3 months and failed.
Pls do u know where to buy new pump for Volkswagen Passat
Re: . by fineboynl(m): 4:34pm On Jan 06
felix55:

I have change upto 3 pump .. they will work like 3 months and failed.
Pls do u know where to buy new pump for Volkswagen Passat
i know know but check with vokswagen part sellers

(1) (Reply)

I Need Toyota Corolla Of 2005/2006 Model / NEMA Announces Rapid Response Plans In The South East. / Clearing Agents Associations Form Alliance To Address Operational Challenges

(Go Up)

Sections: politics (1) business autos (1) jobs (1) career education (1) romance computers phones travel sports fashion health
religion celebs tv-movies music-radio literature webmasters programming techmarket

Links: (1) (2) (3) (4) (5) (6) (7) (8) (9) (10)

Nairaland - Copyright © 2005 - 2024 Oluwaseun Osewa. All rights reserved. See How To Advertise. 16
Disclaimer: Every Nairaland member is solely responsible for anything that he/she posts or uploads on Nairaland.