₦airaland Forum

Thank you! Will add 1litre oil in the morning and drive down to my Mechanic to check then correct whatever went wrong. I appreciate your response.

jceesquare:
Remote diagnosis would be difficult.
Your mechanic needs to go under the car to physically inspect where the leak is coming from.
I've seen oil filter housing leak so that before.
Physical inspection is your best bet.

Good Evening everyone. I have Honda Accord 05. Yesterday evening while I was to get fuel at the filling station, each time I followed the queue I noticed oil where I moved my car, I went under my car to check, it was from my car and I concluded it was the power steering oil without even touching to feel or check the color of the oil. This morning before I get to crank the car, I decided to Guage my engine oil, I realized there's little or no oil in the engine. I checked the sump no leakage from the sump but I could see oil behind the sump. How could this be? The last job I did on the car engine was the IVtec racing sensor which was serviced couple of days ago when the car started jerking when the RPM is going above 3000.

What could be the cause or where is the leakage coming from?

Gbessss!

Iamuk:
Hmmmmmmm.
Grace to grass.
On our way to treasure acquiring may we not be marooned.
A**men.

As usual, they came for their urgent 2bay

Lmao

siofra:
It's the nonsense uncouth beer parlour regular customers say to console themselves

Oga stfu! Igara dey different nah...

lhordspy:
In yoruba. Gragra is refer to as gara gara . Ask around.

vivalavida:
It still remained the same after servicing the caliper.

I will do what you asked me to do.

How much didu get the caliper?

Buy Original Brake pads. Talking from experience!

I had similar issue with my Accord. I did everything, I got advise here but none worked, I was about to change the brake disc between but decided against it.. I gave up on it and drove the car that way, when I notice vibrations, I usually reduce my speed. So, when I decided to service my car, I decided to change the brake pads. Immediately I left the place, I noticed the vibration was not there anymore.

How much for front bumper Honda Accord DC with fog light.

zarakikenpa:
Please recommend a good Honda mech within Kosofe/Shomolu Lagos.
My 08 accord vibrates a bit when accelerating. Took it to a mech, he said ball joints need changing; bought the pair. After changing on the driver side, he said the passenger side is still okay. Did alignment thereafter but still notice the vibration.

I had similar issue in the past and did all that was listed here. The solution to mine was a change of brake pads and it solved the vibration. Get original brake pads.

Racoon:
Despite the adequate publicity and sensitisation? Nigerians will always be Nigerians.

The mentality is just too poor in my opinion.

Newsmic:
https://igberetvnews.com/1433815/super-eagles-nigeria-can-better-morocco-nff/

If I hear! Lmao

This is my issue exactly! I'm deeply connected to my late wife!

I'm in similar situation. I lost my wife after the delivery of my baby girl, she is my second child.

I lost her due to complications after child birth. It'll be two years by February 2023.

I have been doing the do after 6months cos body no be firewood but I'm not in a rush for marriage but I have a steady lady whom I feel satisfied that she'll be a good mom for my kids.

My delay in marrying again is that, considering the situation of our country, I don't want another baby but due to this our mentality, she is in the opinion she must have my own kid too.

She's had a baby too (single mom) I'm willing that will train our kids together but I don't want anymore but she wants at least a baby for me.

I'm taking my time, we aren't in a rush, as a matter of importance we decided to opt for family planning to avoid unwanted pregnancy.

Back to what the op is asking, this is a personal decision. The guy knows what's best for him.

Amala ni keh!

Story for the gods....

Urchins can gladly hug the nearest transformer..

chokekachy:
https://bat-ksm.com/peter-obis-manifesto-offers-nothing-new-to-nigerians-apc-pcc/

blababababa bulaba bulab lol...

Cantonese:
If you know how people dey look person wey im name na Abdul or Mumuni, you go reject the name. Sometimes we dey call shoe wey dey scatter Abdul.

Your comment show say you truly be Abdul. No common sense at all.

Now we all see why BAT dodges all the invitations.

LOL. AB-DULL!

atdscentofwater:
question sha answered
case close

Ask yourself if your brain dey work!

PointZerom:
Imagine this clown with other world leaders?

Moving around with urine bag concealed in his bed bug infested babariga

God Abeg! �

Nice one.

Anwons:
Why trying so hard to convince people if you're actually fit?
All these for the sake of becoming president.
Baba, just kwantinue getting fit there and never come back till 2024

Na old video, link below;

https://www.nairaland.com/1451042/bola-tinubu-shows-off-exercise

Spaxon:
And again I say Damage Control.

What's the Point trying to prove to Nigerians that you're healthy. If you're healthy like Atiku and Obi are;

It'll show in your daily routine.

You could not rest in Lagos or Abuja or as big as Nigeria is you couldn't rest here abi.

It's London that people cannot disturb you.
But you want to be president of Nigeria.

Try to be like Buhari, even if we don't like Him. Try to dish out the silent treatment.


Emi lo Kan ko

Lobo Juice ni.

Like for Peter Obi abeg.

Old video.. Link below

https://www.nairaland.com/1451042/bola-tinubu-shows-off-exercise

Namzy:
If its this item below you removed and cleaned or changed the filter and erase the code and said code comes back after erasing it, then change the unit. That's you made sure the wiring is intact and harness connected. You can also try changing the unscrewing and changing the sensor

Yes it is. I will get the rewire to do all that. Thank you for your help. I appreciate.

Namzy:
This is quite easy just clean the filter of the vtec solenoid behind the engine for starters. If problem persists (symptoms like your car in limp mode and can't rev past rpm 3000) then you might need to change the sensor of the vtec solenoid. But I've had this code multiple times and cleaning the screen helps

I have done all that sir. It still coming up.

Namzy:
Since you are sure the wires are good and part working. Also check that your engine oil has been recently changed and not low in any way, lemme have the exact code to check the honda service manual

After Scanning, the only code is P2646

Dozieson:
Before tire change, where you experiencing that vibration?

Did you do any work before vibration started?

There was no vibrations before tyre change. What I observed was my ATF was very short, I went to where I buy parts to meet with the Honda Technician to confirm what I found out, they recommended Honda Genuine and we added 3 liters of Honda Genuine ATF. I complained I had Oando Dextron 2 initially, why not drain everything then he mentioned something about the pressure reducing if we drain it all. At the spot I noticed droplets of oil where I parked and it was confirmed it was the gear oil, we cleaned the sump and all the gear base with petrol but didn’t notice where the leak was coming from so I took additional 1 litre of Honda Genuine ATF home in case there’s shortage and I can always top it up in the morning before running the engine. I have noticed shortage and continuous leakage of the ATF since then. Could this be the cause of the Shuddering Transmission?

Namzy:
Range? I'm confused was it clicking or not?

Yes, it was clicking.

Namzy:
Did you test the part you bought before installation?

Yes. The range were very good compared to the former one but it was still the same issue when it was fixed.

Tires were recently changed, no contours or any defects. I did wheel balancing and alignment same day tires were changed at Enyo Fueling station.

I scanned the car and the only code that came up was the one I mentioned earlier in my previous post.

Dozieson:
Have you done your wheel balance and alignment? Are you tyres good?

What about scanning the car?

Brake disc only affect applying brakes

Namzy:
Did you clear the code after fix?

The check engine light is still on and it’s still the only code that’s up. If it’s cleared, it comes back on almost immediately u drive a minute.

I need help regarding the picture you posted earlier.

The only code my Honda accord 2004 threw up was this and I replaced this stuff and the code is still showing up. The wiring is intact. What could be the issue, rewire dey suggest I replace ECU (brainbox)

What’s the solution please.

Conner44:
Either your VTEC solenoid is bad (picture below) or it’s wiring is faulty. Check the wiring first

Or worse

Your timing chain might have jumped a tooth, you should buy another timing chain and tensioner rod and take your vehicle to a mechanic that knows how to set the timing chain of your engine very well to do it before the chain breaks and scatters your cylinder head.

Good Afternoon House. I have Honda Accord 2004. Recently I noticed some vibrations from the front wheel when I’m accelerating and this vibrations will start from 40km/h up till 80km/h and vehicle starts running smoothly from that point until I’m starting over again.

I visited a mechanic to help me check the from wheel shaft and all. He complained about the skeleton/bearing in the shaft cup for the right shaft (the long one) and said the other shaft bearing I.e the driver side is manageable but this vibration still persist after changing the passenger side shaft bearing bearings. The vibration is more prevalent on the driver side recently. All engine mounts are intact.

What could be the problem? I’m considering changing the brake disc for the driver side cos I kinda notice friction and also try and replace the bearing for the driver side too. I need expert advise from the house before making my decision.

Thank you all.