₦airaland Forum

Hi @luvinhubby, please I need the following urgently:

1. MAF Sensor: R40
2. O2 Sensor 2 downstream (after the catalyst)

My car is an accord 2008 4-cyl. Thanks

Please I need to get new complete drive shafts for my honda accord 2008 (evil spirit). How much for single or pair?

Hi guys, I am looking to get the Pioneer UFO drone asap. Can't find anyone selling it. If you have any in stock, please kindly hit me up.

GAZZUZZ:
You are not using the scanner in the right way.

Please how do I use it correctly?

GAZZUZZ:
Vacuum the fuel tank from the evap line, does it hold pressure? If it does not find the leak.

Is it not supposed to indicate a CEL if it doesn't hold vacuum? I scanned using ODB II scanner and it says 02 sensor: Incomplete and Evaporative Sys: Incomplete but no CEL lighted.

So I had an electrical guy correct the cooling fan and now the fan comes on only on thermostat and spins for some seconds then switches off just like my honda. I observed that it gets to 96 degrees and then the fan comes on cooling it to about 92 degrees. But it still consumes fuel though its a lot better now.

I still suspect that the odor of petrol has a big part to play. The smell is still strong ooo. Abeg help, I want to travel with the car.

Thanks. If its any help, I just checked the car's temperature when fully warmed up and it reads 85 degrees. Is this good, is the thermostat bad?

The mech checked the fuel pump and its not leaking. Also I noticed that the fan is connected directly. How do I check if the thermostat has not been removed?

mayor2013:
Come to multi autolab for proper diagnosi if in lagos . Your car's problem would be solved. 08156087872 or 08165520837.

Where are u located in Lagos?

Afolabisemiu:
deportivo I'm sorry about that. as for the fan, both fans are directly connected. they start working immediately I start the. engine. Honestly I kn9w about the issue of direct fans and it implication on fuel supply. but I still chose to partially disregard it. this is because initially I wholeheartedly believed this theory. but because I jave a very close person that uses camry like mine, he uses his car with the two fans directly connected and he never experience this high fuel consumption, thouhh I can't say whether his car is working at optimum. one thing I forgot to add to my postnwas that I usually perceived fuel odour while driving I never see any drop of fuel on. from the car but I do experience it especially when I fire and when I park the car in hot weather

I have the exact same problem, the mech connected the fan directly and i also percieve fuel odor and it also drinks more fuel when I drive at high speeds! Exactly the same.

I forgot to mention that when I get to speeds of 100km/hr and above, the fuel level drops really fast. I thought at highway speeds, the car is supposed to consume less fuel?

Hi guys, recently I noticed that my wife's toyota matrix started consuming a lot of petrol and you can smell petrol odor inside the car and also outside the car just around the fuel tank. This happens only while driving or immediately you park. I thought maybe it's a leak but the mech has inspected the pipes and can't find any leaks. Iv had the air filter blown clean, serviced the injectors and cleaned the plugs. I also swapped fuel tank cap with a friend's corolla and still the odor persists. The exhaust was leaking initially but this has long been fixed.

No error codes relating to this shows up, the only error code is a System Voltage Malfunction which flashes infrequently. Iv scanned using my OBD II scanner and I only says O2 sensor incomplete.

I suspect that the cause of the high consumption is the strong petrol odor. Please help!

Laundrybag: On demand laundry & drycleaning mobile app service: https://play.google.com/store/apps/details?id=com.panthelope.laundrybag

Download the app from Google Play Store: https://play.google.com/store/apps/details?id=com.panthelope.laundrybag

#UberForLaundry

LaundryBag is an on demand laundry and dry cleaning mobile app service that picks up and delivers your laundry to your doorstep! . We’ll collect, clean and deliver your clothes whenever and wherever you want - be it your home or your office.

We handle just about everything from your socks to your dry cleaning. Stay smart with Lagos’ #1 laundry and dry cleaning on-demand app.
Download LaundryBag now to check your location coverage and discover exclusive deals in your area!

+ Laundry & dry cleaning picked up and delivered to your doorstep
+ Track your laundry - See what stage your laundry bag is at.
+ Get realtime instant notifications of your laundry bag’s progress
+ Flexible, affordable prices
+ Pay On Delivery - Pay only when you’ve received your cleaned laundry
+ Get a Free Laundry Bag on your first order
+ Share a smile with our pleasant valets at your service

**Special OFFER** Get N500 OFF your first order with promo code “FIRSTTIMER”

*DRY CLEANING *LAUNDRY *IRONING SERVICE *WASHING *SHIRT SERVICE *DUVET CLEANING *BEDDING SERVICE *BEDSHEETS *HOUSEHOLD *ACCESSORIES *SUITS *DRESSES *SKIRTS *TROUSERS *OUTDOOR *CLOTHING *BLOUSES *COAT CLEANING *FOLDED & HUNG SHIRTS *TOWELLING *KNITWEAR *SPECIAL WEARS *APPARELS *WEDDING GOWNS*

Website: http://www.laundrybag.com.ng, Download android app: https://play.google.com/store/apps/details?id=com.panthelope.laundrybag
Follow us:
On Twitter: http://twitter.com/laundrybagapp

Hi, I need 5 rolls of price labels (1000 per roll), the kind used in supermarkets to display prices of each item for sale. See picture below. Thanks

Is this available? I need one if it can also print on nylon bags too. Please reply asap. Thanks

Is this still available? How much is it? I need one for small scale printing needs

Toksytoks:
I bought the switch for 5k and bought the injector body for 15k.The parts are cheaper in Ladipo though but once you do this two things your problem will disappear. I am not sure about the check engine light cos mine is permanently on now. Am tired of paying for scans and i really dont care about it again.

Replace those two parts and you are good.

Hi, yesterday I actually just replaced the complete throttle head (black switch inclusive) and had the TPS re-calibrated and this cleared my check engine light. Now it runs smooth again yay!!

Everything cost me 25K. Thanks alot for assisting, appreciate.

ZIMDRILL:
did he touch the MAP sensor ? especially if the thinner got contact with MAP sensor

No he just cleaned the throttle head and the 4 injectors

Well the mechanic said he did the following:

1. Changed my plugs (9k for four of them)
2. Cleaned the throttle head (that is where the air intake hose from the air filter joins) he said he did not remove the head just cleaned the area with thinner.
3. Serviced the four injectors, said he removed them and flush them, that they have 12 holes unlike the usual 6 older models have. Said he made sure the were spraying well then coupled them back

I noticed that some fluid (maybe fuel leak was on the first injector even after a long drive which heat from the engine should have had it evaporated, didn't check the others). Could it mean the seals on the injectors are bad due to removing and cleaning with thinner?

Toksytoks:
This same thing happened to my 2009 Honda accord. I allowed a mechanic clean my injector head and he messed up my car. The idle went up and my car started consuming fuel and I found it hard to reduce my speed or slow down..the would push forward eachtime. I tried the idle re-learn it didnt work I went to oyingbo and had the black switch on the Injector head changed..the problem resolved but the check engine light is still on. I have tried all forms of scanning,the check engine light will dusappear onlybto reappear after few days. Change the black switch/sensor on the injector mouth or get a new injector head..the idle will normalize but as for the check engine light I have resigned my fate . Do not allow anyone clean your injector again.

Exactly the same issue i am having now. It pushes forward even when i am braking. And its consuming plenty fuel. I disconnected the battery and reconnect after 10secs which cleared the check engine light but it came back on. Please how much did you pay for the injector head black switch?

Thanks, I had to drive out to buy groceries and on my way back the check engine light came on. Now I couldn't perform the idle relearn plus i have a check engine light...what could be worse now. Did it come on due to the high idle? Can you recommend someone i can meet today to scan and fix this issue, i will be on the road to ibadan next week.

Hi Nlanders,

I had my injectors cleaned and changed my 4 plugs. My mechanic said he cleaned the injector head with thinner and applied oil treatment to stop a tampering sound from the engine. Now my car drives quieter but the idle is high. around 1500 to 1800 on cold start and drops to 1200 rpm.

How can I reduce the idle to the factory default at 700? I read stuff online and it said I have to perform the idle re-learn procedure, what is that?

Car: honda accord 2008, 4cyl
Thanks

Hi Nlanders,

I had my injectors cleaned and changed my 4 plugs. My mechanic said he cleaned the injector head with thinner and applied oil treatment to stop a tampering sound from the engine. Now my car drives quieter but the idle is high. around 1500 to 1800 on cold start and drops to 1200 rpm.

How can I reduce the idle to the factory default at 700? I read stuff online and it said I have to perform the idle re-learn procedure, what is that?

Car: honda accord 2008, 4cyl
Thanks

adanny01:
Complete lower arm 100k, wow, i rather order the oem part myself than pay that huge sum only for them to install a china replica worth 15k or less. That arm consist of 3 bushings and replaceable at not more than 15k both. You only need the complete arm if its bent or damaged from an accident. The ball joint is the point of concern which you must be weary of fakes that could pull off or break. Thats why i go for tokumbo instead.

Disc resurfacing should not be up to 8k.

Check the signature of the op of this thread for his website and contact.

Really! Thanks, was already planning to take the car to them tomorrow. Thanks!

Just got my Honda suspension check result from an auto workshop in lagos. This are the results:

1. Complete lower arm - 100,000
2. Front disc resurfacing - 8,000
3. Front brake pads - 12,500
4. Balancing and alignment - 4,000

The vehicle is a honda accord 2008, 2.4L 4cyl.

Please where can I get the named parts and how much are they? I know the auto workshop is overpriced.

Thanks

Hi @luvinhubby

Just got my Honda suspension check result from an auto workshop in lagos. This are the results:

1. Complete lower arm - 100,000
2. Front disc resurfacing - 8,000
3. Front brake pads - 12,500
4. Balancing and alignment - 4,000

The vehicle is a honda accord 2008, 2.4L 4cyl.

Please where can I get the named parts and how much are they? I know the auto workshop is overpriced.

Thanks

More than 1625 jobs delivered by over 475 active workers in 86 locations in lagos. Get listed now and become a part of the service cycle.
Get jobs in your location only so less traffic and traveling.

WorkCity, a place for all service providers in Lagos

We are a tech-startup aimed using the internet to bring the customers to those who offer some form of service. Our concept is so simple and a win-win for all registered services providers on our platform. We do not charge our service providers, we only require that you have an active phone line and can read and send SMS messages.


Find workers No matter where you live in Lagos, just enter your location and 2 minutes later we will match you with a pre-vetted, experienced worker in your area — one who's just right for you.

Become a worker WorkCity is the new way for workers like you to get more work and have more control over what you earn.

Visit http://workcity.com.ng for more information or email us at findaworker@workcity.com.ng or send an sms to +234 708 420 3366

Hi, may I introduce to you "Uxie" a brand product from our start-up company.

Uxie is a simple light-weight mobile application that runs on your smart phone. It is designed to overcome the flaws of the clumsy POS devices issued by our banks such as No network, incomplete transactions, battery life, portability and bank account restrictions etc.
Uxie can be linked to any bank account (savings or current).

We have just launched this new product and would like to have you as one of our pilot users hence all transaction costs will be waived for your first 25 transactions.

If you are interested in being a pilot user, please contact us on uxie@panthelope.com

Thanks