Stanleyallen17:


A 2010 Toyota Camry le with 2ar-fe engine was having a problem. The problem is when starting for the 1st time in the morning, the car will attempt to start while jecking and then switch off. On the 2nd attempt, it will start normal as if nothing happen on the previous attempt.
No check engine light seen while the engine is on but seen when you turn on the ignition.
A scan was performed and p0015 was seen as a pending code.
But the code disappeared after an oil change and driving for about 50+ miles.
My question is can this code cause the starting problem because the car still starts like that especially after being parked for about 6hrs even if you driven it for the day.

This sounds like a fuel system issue

Dear friends.

When am driving sometimes, I discover when am on the highway my gear D always blinks. Please who knows what the cause of it.

Please any solution to it.

Thanks

Wilson5183:
Dear friends.

When am driving sometimes, I discover when am on the highway my gear D always blinks. Please who knows what the cause of it.

Please any solution to it.

Thanks

That should be Honda.... run a scan but mostly na low or dirty transmission fluid. But to save yourself get the recommended fluid for transmission

Stanleyallen17:


A 2010 Toyota Camry le with 2ar-fe engine was having a problem. The problem is when starting for the 1st time in the morning, the car will attempt to start while jecking and then switch off. On the 2nd attempt, it will start normal as if nothing happen on the previous attempt.
No check engine light seen while the engine is on but seen when you turn on the ignition.
A scan was performed and p0015 was seen as a pending code.
But the code disappeared after an oil change and driving for about 50+ miles.
My question is can this code cause the starting problem because the car still starts like that especially after being parked for about 6hrs even if you driven it for the day.

When I had fuel pump issue, my car didn't start on the first turn of the engine. But when I changed it, it was always one hand.

Good day Ayo,
My ford Explorer 2005 I noticed lately that whenever I first engage the gear in drive or reverse it make this sharp noise "Gah". Please note when I first bought it in 2015 I changed the Gear filter and so the oil which I used Motorcraft ATF. What do you think might be the issue to get rid of this scary sharp noise. Thanks

HundeyinTosin:
Good day Ayo,
My ford Explorer 2005 I noticed lately that whenever I first engage the gear in drive or reverse it make this sharp noise "Gah". Please note when I first bought it in 2015 I changed the Gear filter and so the oil which I used Motorcraft ATF. What do you think might be the issue to get rid of this scary sharp noise. Thanks

Boss run a scan if there is a CEL.
But from what you said prolly an Engine Seat or An internal issue with the tranny.

Blackbishop:


This sounds like a fuel system issue

Cleaned and tested ok the fuel pressure regulator with a guage but still hoping on checking for leaking injection.

Blackbishop:


This sounds like a fuel system issue

Cleaned fuel pump filter and strainer then tested ok the fuel pressure regulator with a guage but still hoping on checking for leaking injection.

Welcome to B-Automobile NG Ltd



I am writing to introduce you to B-Automobile Nigeria Limited, I am an Auto Technician also known as Mechanic at B-Automobile Nigeria Limited.

As you know, statistically that the number of cars we have on our roads have exploded exponentially in the past few years, and we have a dwindling technical know how of these modern day cars skilled enough to care for them appropriately. This is where I come in and below are things I offer and no one else does.




Affordable New or Used Vehicles

Do you need a new car or you feel like disposing off your current? Contact us and be rest assured you get nothing but the best.


Capable Technical Team for the job

We offer fast on-demand car service and mobile workshop. We also have and consult the best auto technicians.


Budget Friendly Prices

We offer the best prices in today's competitive automotive services. Offering the best and lasting solution at a token.

Must-read Articles from the Blog



Erratic Performance After Warming Up

A Toyota Sequoia 2005 starts up well, sometimes the idle will sound a little low, but it has never stalled out while idling. If the idle is rough. When the car is taking off from a standstill it moves smoothly, there is no misfire/stuttering problem. But when the vehicle has warm after driving some distance, the vehicle misfires/stutters very badly, misfiring/stuttering also occurs after shifting but seems to only occur below about 2,500 RPM

Read the full article ›


Check us out on our website to know a little about us

We have worked with several clients, of different ideas on how to handle the maintenance of several automobiles. B-Automobile is a huge service manager with over three years of experience and has up to date solved most car issues tackled with less cash spent and genuine OEM.

Click the link below to visit our website.

Visit Us

B-Automobile Nigeria Limited
#22, Eliasau Street, Mafoluku,
Oshodi, Lagos
b.automobileng@gmail.com
Facebook
Twitter
Instagram


This email was sent to stanepath@yahoo.com
You received this email because you are registered with our Parent Company



© 2021 B-Automobile NG Ltd

Peppermintflav:

Check the bulbs. One is bad. Replace it and it will be back to normal.

I have change the bulb but it is still blinking fast

Wilson5183:


I have change the bulb but it is still blinking fast

Bro you need a wiring Technician to check for you

Hello i notice after i switch off my car,my brake lights remained on.i quickly remove both batery terminals then it went off. Im tired of removing terminals everyday wat is the possible cause

easytig:
Hello i notice after i switch off my car,my brake lights remained on.i quickly remove both batery terminals then it went off. Im tired of removing terminals everyday wat is the possible cause

A rewire will help you better

Stanleyallen17:


Cleaned fuel pump filter and strainer then tested ok the fuel pressure regulator with a guage but still hoping on checking for leaking injection.

Any help on this?

Okay i will get in touch with one thanks

Blackbishop:


A rewire will help you better

Stanleyallen17:


Any help on this?

I can only help with physical inspection

Scan result of my car corolla s 2008. The car is slow in pick-up, rattle noise during cold start and my idle speed is high (around 1100 rpm after about 15min).

The same copy

Good Afternoon. Please is Kia Rio/Hyundai Accent 2003-2008 a good car.
Is it economical? Maintenance?
Finally, How much is the complete engine? And complete gear incase of unforseen

BwalaMarama:
The same copy

Couple of things can be done to correct it.

REPLACING The CAMSHAFT ACTUATOR
OR CHECKING THE TIMING CHAIN

Lovelynife:
Good Afternoon. Please is Kia Rio/Hyundai Accent 2003-2008 a good car.
Is it economical? Maintenance?
Finally, How much is the complete engine? And complete gear incase of unforseen

Short and simple, the 2 cars are lovely and good for the Ehauling.
Maintenance part; just make sure you use recommended part to save you the streee

Blackbishop:


Short and simple, the 2 cars are lovely and good for the Ehauling.
Maintenance part; just make sure you use recommended part to save you the streee

Thanks so much sir

Gud morning sir.... Blackbishop... Abeg my front wheel is getting hot dah wen I nta water... Smoke ń sound of wen hot object is put inside water is observed... Thou... Mai hub has bin making a woo-ING sound for quite somtymz now.... Hw much shd I budget to come ń fix front hub... Thanks
Riliwansaka86@gmail.com

Sakamanjeh99:
Gud morning sir.... Blackbishop... Abeg my front wheel is getting hot dah wen I nta water... Smoke ń sound of wen hot object is put inside water is observed... Thou... Mai hub has bin making a woo-ING sound for quite somtymz now.... Hw much shd I budget to come ń fix front hub... Thanks
Riliwansaka86@gmail.com

Boss morning, you didnt specify the vehicle model. Also it all depends on you the type you want if you want? A used or bearing fitted one it all depends on you.

Corolla 06....whc one is better.... Used or bearing fitted.... D cost too... Thanks

C1201 – Engine Control System Malfunction

A fault is found in Toyota SUV engine control system and is detected through the CEL (Check Engine Light) and running a Diagnosis, the fault code that came up are P0430 and C1201. The fail-safe feature of C1201 that came up on the dashboard bans the operations of VSC and TRAC. When the signals from the engine are input normally, the fail-safe is cancelled and the DTC is not stored.

One major issue with this C1201 code, it comes with other fault codes; mostly

P0455: Evaporator Emission Control System Leak Detected (no purge flow or large leak)

P0441: Evaporator Emission Control System Incorrect Purge Flow

The 3 codes are related to each other.

The C1201 code is the one which tells the vehicle to turn on the light of the check engine and to disable the traction and VSC. Basically, when the other two codes pop up, this one is responsible for letting you know that there is a problem there. This one can also be solved by changing the other codes because they are the ones that caused it.

But in this case I have to deal with[b] P0430 – 2007 TOYOTA HIGHLANDER[/b] – Catalyst System Efficiency Below Threshold Bank 2.

Causes

Faulty Three-way Catalyst Converter Bank 2
Exhaust Tube
Intake Air Leaks
Faulty Oxygen (O2) Sensor
Faulty Fuel injector(s)
Leaking Fuel Injector (s)
Faulty Spark plugs
Improper Ignition Timing
Dirty Air Filter and lastly but rarely
Faulty Engine Control Module (ECM)

After fixing the P0430, the next step was to check if the VSC [/b]light on the dashboard was gone or still showing. Which was showing with the [b]CEL.

C1201 codes is mostly corrected by changing the gas cap tank to an OEM gas cap to solve the issue.

In conclusion we decided to order for a new one online to solve the issue and the car now run smoothly.

My car finds it difficult to selecting gears easily these days. When you move after the light turns green, it'll select 1,2 then instead of 3, it'll do as if it pulled off gear. Then I'll have to reduce acceleration then it'll gradually select 3 and above. Then cars behind you will notice you aren't picking pace and start honking. Any idea what the problem might be?

1daboi:
My car finds it difficult to selecting gears easily these days. When you move after the light turns green, it'll select 1,2 then instead of 3, it'll do as if it pulled off gear. Then I'll have to reduce acceleration then it'll gradually select 3 and above. Then cars behind you will notice you aren't picking pace and start honking. Any idea what the problem might be?

First run a scan and get back to me bro

Blackbishop:


First run a scan and get back to me bro

ok

Reason Your Car Slowly Accelerate or Deaccelerate while driving.

Read the full article on my page by clicking on the link below

https://bautomobileng dot wordpress dot com/2021/07/06/reason-your-car-slowly-accelerate-or-decelerate-while-driving/

in your browser change the dot to actual dot and close the gap

Toyota camry 2005
4 plug
Automatic.
Petrol
High fuel consumption
I scan the car and I got the following error

Car Scanner INNOVA 3100 abs
P0031
Selected brand: Toyota
HO2S Heater Control Circuit Low(Bank 1, Sensor 1)

P0500
Vehicle Speed Sensor A

Pls help @Blackbishop

nbolaji:
Toyota camry 2005
4 plug
Automatic.
Petrol
High fuel consumption
I scan the car and I got the following error

Car Scanner INNOVA 3100 abs
P0031
Selected brand: Toyota
HO2S Heater Control Circuit Low(Bank 1, Sensor 1)

P0500
Vehicle Speed Sensor A

Pls help @Blackbishop

Good day sir, from this result I can categorically tell you it's more than that. Why don't you run a freeze frame?

But O² sensor going bad and VSS can be replaced.