₦airaland Forum

Ynix:
Take a look at this

1. Site Clearing and Preparation
Site Surveying and Mapping: ₦300,000
Site Clearing and Leveling: ₦500,000
Excavation for Foundation: ₦700,000
Sub-Total: ₦1,500,000
2. Foundation Stage
Materials (Cement, Sand, Gravel, Steel): ₦3,500,000
Labor for Foundation Work: ₦2,000,000
Damp Proof Membrane and Blinding: ₦1,000,000
Sub-Total: ₦6,500,000
3. Structural Work
Wall Construction (Blocks, Mortar, and Labor): ₦8,000,000
Reinforcement for Pillars and Lintels: ₦3,000,000
Sub-Total: ₦11,000,000
4. Roofing
Roofing Materials (Wood, Zinc/Aluminum, Nails): ₦4,000,000
Roofing Labor: ₦1,000,000
Sub-Total: ₦5,000,000
5. Windows and Doors
Aluminum/Steel Windows (Materials and Installation): ₦2,000,000
Doors (External and Internal): ₦2,500,000
Sub-Total: ₦4,500,000
6. Electrical and Plumbing
Electrical Wiring and Fixtures: ₦2,000,000
Plumbing and Sanitary Fittings: ₦2,500,000
Sub-Total: ₦4,500,000
7. Interior Finishing
Plastering and Screeding: ₦2,000,000
Painting (Interior and Exterior): ₦2,000,000
Tiling (Floor and Walls): ₦3,000,000
Ceiling Work (POP or PVC): ₦1,500,000
Sub-Total: ₦8,500,000
8. Exterior Finishing
Paving/Compound Finishing: ₦3,000,000
Drainage and Fencing: ₦2,500,000
Sub-Total: ₦5,500,000
9. Contingency (5%)
Unforeseen Expenses: ₦2,500,000
Grand Total: ₦50,000,000

Note: This costing is subject to reduction or addition based on inflation, market situation, quality of materials and type of expertise engaged

Your analysis on plumbing and Electrical might be wrong. Electrical cables are very expensive now... Check the below analysis for cables

1.5mm for lighting
Red 5
Black 4
Green 1

2.5mm
Red 3
Black 3
15mm green 3

4mm
Red 2
Black 2

1.5mm for fence light
Red 2
Black 2
2.5mm 2

10mm cable 1

With the above analysis, 2m will not be enough for electrical because pipes and distribution board is not part of the analysis above. Also, light fittings which is the final fix is not part of it too..

Ourown:
Guys can you please review and critique this plan for 3 bedroom bungalow? Thanks

Having 3 doors to the kitchen looks somehow to me, the switching might be a problem except you are ready for intermediate switch. .. Also, are you using cabinet as store? You need to create storage for the kitchen..

Geekop:
Between inverters and powerstations which is better?

Not just inverter but solar power is better

Jaydot:
I still believe that, though all these cables are quite good, but none of them is on the same level of quality compared to Nocaco. I still considered Nocaco as the best electrical cable in Nigeria.

MOCACO is manufactured by kabelmetal.. MOCACO is the flexible brand of Kabelmetal products. . MOCACO can only be used where we are running cable trays or basket or otherwise stated by MEP consultants... Nococa is manufactured in North. Nigerchin flexible cable is also the level with MOCACO
Remember MOCACO price not for Kobo Kobo project.. Very very expensive

sonnie10:
Do people still use terrazzo for flooring?
How much is good 120 x 60 Spanish tiles per meter?

Where is Oga Topsy23? Our in house electrical consultant.

Thank you sir for your call, really appreciate.

Zzyzxt:
Good morning house please how many ton of sand will be enough to make 70 bags of cement for block.

To set or to mould?

twinskenny:
Hmm rightly said… some will lure clients with cheap price… you end up paying

Like the site we spoke about some days ago. Looking for way out....

kuntash:
abi na japa things?

No sir, fully available in Nigeria. He's doing his business sir. You can chat him on WhatsApp sir
.

On going project

rotecch77:
Pics

The client really value quality in this installation using Schneider DB, switches and sockets .. One of the most expensive DB.

Well done oga Rotecch

Emdee590:
You are very right but the main issue on ground now is inavailability of the products here right now.

Ooh now I understand sir

Thanks for your call

Emdee590:
Who can deliver local iron rods to North, Sokoto to be precise ?

Buying over there is going to be because getting in far place like Lagos might be a bit expensive when you factor cost of transportation to it... Also, the risk involve is very high..

For your cables and electrical materials
Whatsaspp / 📞08033643191
✉️topselg.engineering@gmail.com or atope23@live.co.uk.

Can not be up to 30yrs in Lagos

Call today

For your MEP Design and standard installation
Whatsaspp / 📞08033643191
✉️topselg.engineering@gmail.com or atope23@live.co.uk

For your cables and electrical materials
Whatsaspp / 📞08033643191
✉️topselg.engineering@gmail.com or atope23@live.co.uk

floshady02:
@michlins obviously camera has to be visible. I don’t mean the camera. I mean this image. Are they accessories for cameras or solar? I would prefer them hidden and not bare like that. Is there something you can do to hide them so they are not visible

You can build a shelf around it... It must be accessible in case of emergency. They must not be too enclose because of heat.. They need ventilation especially during day when there is hot weather.


They are all solar accessories

ollykay619:
Inverter AC. 1.5hp

You are covered

ollykay619:
Good day house, please is 2.5mm good for AC?

Twinskenny

What is the horse power of your AC? Is it an inverter AC or non inverter?

ben1daEbiri:
Noted.

Again from the quote it seems 2.5mm would be used for the cooker unit in the kitchen. Cooker units should be able to handle 3k watts if I'm not mistaken. You don't recommend 2.5mm on that do you?

Cooker unit should be at least 4mm but with the look of things I don't think he is installing cooker in the kitchen.

ben1daEbiri:
There's no 4mm for cooker unit.
There's no 16mm for supply from the pole to the house or is your Disco expected to provide that?

The half roll of 10mm I believe would be used to supply the DB from the cut out fuse unit. It may not be enough if there's a considerable distance from the cut out to the DB considering it's a 3-phase wiring.

The 10mm single might likely to be enough if the electrician is using single phase supply to the distribution board... Also, the 16mm you mentioned is going to be service wire(aluminium.). He might not need that now because the electrician quoted for only internal installations

Gharnew112:
Please electricians in the house, kindly help look into this quotation from our electrician for a 3 bedroom bungalow… project is Ogun state.


PIPING
(1)8 Bundles of 20mm pipes @11000 =88000
(2)7 packets of 3by3 plastic boxs @1500 =10,000
(3)5 packets of 3by6 plastic boxs @1400 =7000
(4)4 packets of 20mm cupplers @2000 =8000
(5)1 pack of 20mm looping box@3000
(6)1 pack of Ubox@3000
(7)1 big gum@ 12000
( 1 piece of D4 Distribution box@75000
Total cost is 206,000

Workmanship and transport 150,000


WIRES
(1)4 coils of 2.5mm Red@47000=188,000
(2)3 coils of 2.5mm black @47000=141,000
(3)5 coils of 1.5mm red@27,500=137,000
(4) 4 coils of 1.5mm black @27,500=110,000
(5)3 coils of 1.5mm green @27,500=82,500
(6) half coil of 10mm wires =95000
(7) 1 coil of TV cable @12000
Total cost is 765,500

Workmanship and transport 190,000.

Below is my observation
-The Electricidal pipe the guy quote is not dignity because is more expensive than what he quoted for.
-A pack of looping box won't be enough if you plan to have recess light in all the rooms, sitting room, toilet, kitchen and dining.
-What type of 3x3 and 3x6 did he priced, galvanized or plastic ?

-The 2.5mm(RED and BLACK ) cable must the same quantity since they are taking source from the same DB

-He must also specify the make of cables too, alot of cables are in the market now

Not sure the man is checking this thread anymore. If you check his last seen on his profile you will notice that he visited Nairaland in January

twinskenny:
Glad to have you back ogami! Gods speed

Thank you sir.. Really appreciates your call. God bless you

We are available now

We are available now

We are available now

For your Electrical, plumbing and AC design and installation

Also, you can get in touch for your original cables

You can also check our thread with the link below.


CABLES
https://www.nairaland.com/2326721/nigerchin-kabelmetal-coleman-cables/37


MEP INSTALLATION
https://www.nairaland.com/1233943/contact-us-electrical-mechanical-plumbing/40

MEP DESIGN
https://www.nairaland.com/1804476/complete-package-design-drawing-mechanical/11

DISTRIBUTION BOARD
SALES, INSTALLATION
https://www.nairaland.com/2668061/abb-distribution-board-schneider-distribution/10

FINAL SUB-CIRCUIT TERMINATION AND CABLE MANAGEMENT
https://www.nairaland.com/6980507/distribution-boards-final-sub-circuit

For more information you can contact us

Whatsaspp / 📞08033643191 or 09053556216
✉️topselg.engineering@gmail.com or atope23@live.co.uk

For your Electrical, plumbing and AC design and installation

Also, you can get in touch for your original cables

You can also check our thread with the link below.


CABLES
https://www.nairaland.com/2326721/nigerchin-kabelmetal-coleman-cables/37


MEP INSTALLATION
https://www.nairaland.com/1233943/contact-us-electrical-mechanical-plumbing/40

MEP DESIGN
https://www.nairaland.com/1804476/complete-package-design-drawing-mechanical/11

DISTRIBUTION BOARD
SALES, INSTALLATION
https://www.nairaland.com/2668061/abb-distribution-board-schneider-distribution/10

FINAL SUB-CIRCUIT TERMINATION AND CABLE MANAGEMENT
https://www.nairaland.com/6980507/distribution-boards-final-sub-circuit

For more information you can contact us

Whatsaspp / 📞08033643191 or 09053556216
✉️topselg.engineering@gmail.com or atope23@live.co.uk

You can contact us for your Electrical, plumbing and AC design and installation

Also, you can get in touch for your original cables

You can also check our thread with the link below.


CABLES
https://www.nairaland.com/2326721/nigerchin-kabelmetal-coleman-cables/37


MEP INSTALLATION
https://www.nairaland.com/1233943/contact-us-electrical-mechanical-plumbing/40

MEP DESIGN
https://www.nairaland.com/1804476/complete-package-design-drawing-mechanical/11

DISTRIBUTION BOARD
SALES, INSTALLATION
https://www.nairaland.com/2668061/abb-distribution-board-schneider-distribution/10

FINAL SUB-CIRCUIT TERMINATION AND CABLE MANAGEMENT
https://www.nairaland.com/6980507/distribution-boards-final-sub-circuit

For more information you can contact us

Whatsaspp / 📞08033643191 or 09053556216
✉️topselg.engineering@gmail.com or atope23@live.co.uk