₦airaland Forum

Can anyone help me on how to stop the phone from hanging most especially when I on my data. It always hangs and displays phone not responding?

Also, is there any software update for Leagoo KIICAA Power | 2gb /16gb

please is there Leagoo phone thread? because i have an issue with mine
It always say google play service or other application is not responding. what can i do to permanently solve this?

Sensicut:
check ur inbox

kindly forward it to me on inioluwa36@yahoo.com

Truly1:
Upright2010, I have said b4 on this forum that 4950h is the best out of the three. Once you know how to operate it u would agree with and this should not be a problem if u are IT compliant. While SRT 4922 is for the boys 4950 is for the men.

. Thanks

Pls house I need ur advice. Which one is beta among these receivers: 4950;4922A. 4922D cos I intend to go for d latter .tnx

Pls what is the current situation about Daarsat package

blexxonmak:
@omotech.Use your phone.

. Pls how do I.unzip the software using an android phones?

blexxonmak:
@ganex.Please be more specific

. Thanks but the issue I'm having is that after using 3626 I blind scanned but to my supprise I got just 2 channels. Also , apart from EPL does Amos has any advantage over irib? Thanks

blexxonmak:
@upright2010.You need high speed internet and unlimited data plan;IPTV consumes megabytes.

. Which one is better btw Amos 5 c band and irib? Meanwhile I tried tracking Amos 5 c band to get more channels using 1.35m strong pan dish only to get é channels. Pls help me with the best t.PS to track it , thanks

blexxonmak:
@upright2010.You need high speed internet and unlimited data plan;IPTV consumes megabytes.

. Thanks a lot. Can I have ur personal contact for further assistance? Here is my email inioluwa36@yahoo. com

pls GURUS in the house how can i watch iptv on.my 4922a ,thanks

blexxonmak:
@mtchris.No.For Pan African beam and EIRP ≈ 44.5 dBW,you will need a minimum of 80 cm dish.However,I will recommend 120 cm dish.
You can track both the C and Ku band transponders on one dish using Strong SRT L972. COMBINED C+KU-BAND LNBF.

. Thanks for the information but pls how can I get this lnbf and how much? Can I track both Amos 5 c and ku on 1.35m dish not motorized? Thanks

agkilis:
on an offset dish yes,on a prime focus you tell me,do you remember the day you talked about badr 5 a new channel ?a guy in this forum told you he has blind scan his multitv and did not get those channels,what was your answer?guy you are talking about i mean badr 5 not multitv i think that was your answer,i have nailed ses5 &7e yes.well lets leave it at that,my point is this guys who have not done it should not join those who have to say it is true when they have not done it them self practically

. It's possible to nail badr and joy TV with the same lnb. I've done on about 6 different occasions but to my suprise I can't even get it with a single lnb set up using 12303h 27500

blexxonmak:
@purplekayc. Multi-lnb setup on a single dish is better.Alternatively,you can do a 3-in-1 motorized setup if you got the space.Much more better than littering the whole place with dishes.

. Good work but can u pls give us details about this setup cos I assume they are all c band . so also d satellites' names n their tracking tps . thanks

Rotimiseyi:
finaly i was able 2 locate d problem. D cable conectin d multi tv dish 2 d disec is faulty cos i used a direct cable 2 my decoda and it works. Thx 2 u all 4 ur concern am gr8ful

good luck. But mind u, the problem may be diseqc

blexxonmak:
@upright2010. By copper to copper coax I mean a coax that has both the center conductor and the outer conductor (braid) made of copper.

. thanks but I don't think that solves the issue of quality

Rotimiseyi:
Thx bro i've tried dat but d signal strenght of L is about 96% and Q is low. Though its red anyway. But could it b dat d two lnb develop fault at dsame tym? Thx in anticipation

. That means that ur cable is OK but did u try tracking Dstv with d dish without diseqc? Try and do that to establish the condition of ur lnb . cheers

blexxonmak:
Eriteria TV2 = ERI TV Arabsat-5A @ 30.5° East
12606 V DVB-S 2589 3/4 (Maghreb Beam)
10832 V DVB-S 2780-5/6 (Pan Arab Beam)
180 cm dish and above can comfortably do the job

pls can I track it with MPEG 2

blexxonmak:
@Rotimiseyi. In that case you got to change the entire length of cable.This sort of thing often
happens with low grade coaxial cables.Poor cables tend to degrade with time.When next you
buy do request for copper to copper coaxial cable.

. Pls what's the meaning of "copper to copper coaxial cable"?

@Rotimiseyi , the litmus test u can do on ur dish, lnb & cable are:
1. Connect the cable to the lnb on the dish in question and connect the other end directly to ur receiver with out disecq and go to any ku band. If d signal strength gives u a reasonable %
That means the cable is OK otherwise it's bad.
Going by that i.e if the cable is tested good n ok. u can use it to track dstv to confirm the lnb. But mind u, this test on ur coxia cable doesn't guaranteed ur lnb being good. That is my token

drandonzero: i posted the frequency earlier if am not mistaken! 12602v 2589 at 30.5e, thats arabsat 5a

. Pls what is the strongest to for the sat. 2 what are other FTA channels

sammu: The best patch for 4922a is 164p. Get it from crosat.us or wizkid.persiangig.com

. Thanks my Oga

olenyi: http://www.flysat.com/amos5.php


http://www.flysat.com/e16a.php


Regards.

. I'm experiencing similar thing with daarsat package. It freezes while others are stable on their tps with 4922a . also what is the best patch for 4922a,thanks

olenyi: @atuagbo.

I got your mail. Sorry for taking this long to acknowledge it. Will attend to it by today or tomorrow at most. I hope my reply would still be relevant.

kindly accept my warm regards.

. Good day n quite a long time. Remain blessed

hotobo: this tp is equally on 26e badr 4. be sure of what u are tracking

. You are right. He's on Badr 26e. U can even get it together with multi tv using 12523 v 27000 . All you need to do is raise ur dish up a bit to reduce ur signal strenght to 70-75, iinput d tp 12304 H 27500 and u are good to go.

lonzo2214: thanks but it refuses to get d channels back... Cine afrik, joysports and aljazera all gone.. Any other help.

.what type of receiver are u using? U may need to change the satellite to another Ku band and insert d same tp.

odilibe: ....few C-band channels on the 2 sats but for me i prefer amos 5 for the english channels....kinda like OHTV on amos 5 for entertainment if it is still running

. Thanks but what's the best tracking tp for Amos 5 c band

odilibe: ...where amos 5 has circular C-band pol, die-electric plate needed..lol...while the satellite owners states that 90cm can do the job hehehehe!

. pls help me with d tracking tp for Amos 5 C band. kindly advice which one is beta btw Arabsat @ 20e and Amos 5 c band. thanks

Ussals: 1. Getting MBC on motorize with q23 = yes is possible, use 11661v27500, 10992v27500 get d highest quality u can get then input 11560v27500
2. Try this tp for 10e 3742 R 10114
Rgds...

. .pls what is the dish size for 10e

upright2010: @all. Kindly help me out. Any time i attempt to loop out from Qsat to other tv. The decoder will just switch off. What could be the problem?

.I'm still waiting for ur response, thanks

@all. Kindly help me out. Any time i attempt to loop out from Qsat to other tv. The decoder will just switch off. What could be the problem?

blexxonmak: @Dlee1,Edox4,lamtam0,routsz,zpakln,freshp,Rotimiseyi.I cannot thank u guys enough for the wonderful support and prayers.

. It's a pity Bro. May God console you and fill up her gap