rhymz:
Which screws are you guys talking about, the one under my carburetor started leaking fuel immediately I unscrewed it came tight.... I will like to adjust it it really works....

Oga wetin you dey look for again, sheybi your Tec junior is already giving you joy!!!

aieromon:


Not 4 days. 100 hours of operation refers to runtime hours of the generator. If you run the generator an average of 4 to 6 hours daily, then you should change the oil once every month.

ohhhh now I get it, I run it at least 10hours daily though. So I might have to change every 10days or thereabout. Thanks for the clarity I appreciate.

NobleEngineer:

Oga wetin you dey look for again, sheybi your Tec junior is already giving you joy!!!

actually, I will like to reduce the noise too from my Gen.... the fuel consumption is still excellent but if adjusting the screw can give me more run time for little fuel.... why won't I try it.

My maxi 3.5kva generator started fluctuating light after it's on for like over an hour... The generator sounds fine but the light keeps fluctuating, what could be the issue.

unex50:
Another thing, tampering with those screws on the carburetor mightvproduce unexpected results, from low voltage, misfiring, high voltage, current fluctuation to spoiling the coil in matter of months.... I will advise that you leave the Gen the way it came.... My TEC junior last me for 2h+ for a litre of fuel.... I know the sound can be loud though and the voltage seem kind of high....your best bet is to let a qualified technician look at it if it bothers you that much.... But no too tamper with am.

Please can you snap a pic of the firing screw on your TEC junior... My engineer just told me that mine doesn't have one

rhymz:
actually, I will like to reduce the noise too from my Gen.... the fuel consumption is still excellent but if adjusting the screw can give me more run time for little fuel.... why won't I try it.

Please can you snap a pic of the firing screw on your TEC junior... My engineer just told me that mine doesn't have one

NobleEngineer:

Oga wetin you dey look for again, sheybi your Tec junior is already giving you joy!!!

Please can you snap a pic of the firing screw on your TEC junior... My engineer just told me that mine doesn't have one

missylizzy:
My maxi 3.5kva generator started fluctuating light after it's on for like over an hour... The generator sounds fine but the light keeps fluctuating, what could be the issue.

Can someone help me out with this.

My gen key starter battery seems to be dead barely 5 months of usage.. can the battery be charged or I need to get a new one?

missylizzy:


Can someone help me out with this.

replace the spark plug

eightsin:
My gen key starter battery seems to be dead barely 5 months of usage.. can the battery be charged or I need to get a new one?

Get a new one. The dead battery was probably on its way out when you purchased the generating set.

Evening people. Pls i need advice on a gen to get.
I have a 32" LG tv, 125 Litre LG fridge, Lg Boom stand, ceiling fan, 2 light bulbs, a 1.5hp hisense Ac i might not use on gen.
Budget is 80k-100k
Thinking of Lutian or Firman.

Kindly help out, hoping to get it by 2moro

aieromon:


Get a new one. The dead battery was probably on its way out when you purchased the generating set.

Thanks

harley88:
Evening people. Pls i need advice on a gen to get.
I have a 32" LG tv, 125 Litre LG fridge, Lg Boom stand, ceiling fan, 2 light bulbs, a 1.5hp hisense Ac i might not use on gen.
Budget is 80k-100k
Thinking of Lutian or Firman.

Kindly help out, hoping to get it by 2moro

Pls someone should kindly help out. Pls i need to get the gen today

harley88:


Pls someone should kindly help out. Pls i need to get the gen today

I believe the Lutian LT 3990 fits this bill cos you cant get Firman with that budget.

Santa2:


I believe the Lutian LT 3990 fits this bill cos you cant get Firman with that budget.

Thanks. How much can i add to my budget to get a firman

harley88:


Pls someone should kindly help out. Pls i need to get the gen today

Why not get haeir thermocool.... Within that price range

I have finally adjusted my TEC Junior and my first test today since Yestarday that my Brother and I did the tweaking after watching a couple of videos.

First we screwed in the screw that is responsible for the flow of air fuel mixture
Then there was another screw that controls the governor...also screwed in until we were able to get a balance the two screws and output.

Note if you dont adjust it well, you Gen will be vibrating....not a good indication.

Also note, the sound reduced slightly but nothing significantly different from the follow come noise ...typical small Gen problem.

So I decided to add two litres of Fuel at around 8:25pm, the Gen just went off some few minutes ago, 2:29am to be precise.

That's approximately 6 hrs for 2litr of fuel with two Ceiling fans, one rechargeable standing fan, my laptop and about 5 charging phones.....that's all.

I will upload pictures of the screw postions tomorrow

rhymz:
I have finally adjusted my TEC Junior and my first test today since Yestarday that my Brother and I did the tweaking after watching a couple of videos.

First we screwed in the screw that is responsible for the flow of air fuel mixture
Then there was another screw that controls the governor...also screwed in until we were able to get a balance the two screws and output.

Note if you dont adjust it well, you Gen will be vibrating....not a good indication.

Also note, the sound reduced slightly but nothing significantly different from the follow come noise ...typical small Gen problem.

So I decided to add two litres of Fuel at around 8:25pm, the Gen just went off some few minutes ago, 2:29am to be precise.

That's approximately 6 hrs for 2litr of fuel with two Ceiling fans, one rechargeable standing fan, my laptop and about 5 charging phones.....that's all.

I will upload pictures of the screw postions tomorrow

LMAO. Does this tally with what the data sheet preach now? Unah make mod just ban me in this thread for doing nothing.

Good morning how, please I need review on fuel consumption of the follow Gen to know which to eventually go with

1) sumec fireman 2900

2) semec fireman 3000

3) lutian 3390

Mainly about fuel consumption please

puffynana:
Good morning how, please I need review on fuel consumption of the follow Gen to know which to eventually go with

1) sumec fireman 2900

2) semec fireman 3000

3) lutian 3390

Mainly about fuel consumption please

Suco01
Enochogaga

And anyone using the Gen please I need reviews

obisite:




What's your view about this brand.. And what's the kva..

Tigmax6800


Try getting sumec fireman.. Unfortunately I couldn't get copper...

Was advice to get Tigmax6800...

Good day
Please how is the fuel consumption in the tiger gen

puffynana:


Suco01 Enochogaga
And anyone using the Gen please I need reviews

Are u buying generator because of fuel consumption or durability?

suco01:


Are u buying generator because of fuel consumption or durability?

Fuel consumption.

puffynana:

Fuel consumption.

I pass my neighbour is ur best shot. lol

suco01:


I pass my neighbour is ur best shot. lol

Lol
Sure, but which will you recommend

puffynana:

Lol Sure, but which will you recommend

I pass my neighbour

suco01:


I pass my neighbour

.

Ok ,that's for fuel consumption.

Can you recommend any 2.5kva gen

puffynana:
.

Ok ,that's for fuel consumption.

Can you recommend any 2.5kva gen

you just dey ask correct question.

I have decided not to answer some people question related to fuel consumption here anymore because when u advice them they will still qoute to throw words at you that data sheet, data paper data that.

for your question

TEC
LUTIAN
PARSUN

NB: Go with an engineer to inspect for you.

Thank you and God bless.

puffynana:


Good day
Please how is the fuel consumption in the tiger gen

Not tiger gen... Tigmax6800...

To me the fuel is OK.. I use 1k fuel for maximum of 12hrs...(7pm-10pm) for 4 days...

Wow good development... Pls don't forget to post pictures as in the bolded.

rhymz:
I have finally adjusted my TEC Junior and my first test today since Yestarday that my Brother and I did the tweaking after watching a couple of videos.

First we screwed in the screw that is responsible for the flow of air fuel mixture
Then there was another screw that controls the governor...also screwed in until we were able to get a balance the two screws and output.

Note if you dont adjust it well, you Gen will be vibrating....not a good indication.

Also note, the sound reduced slightly but nothing significantly different from the follow come noise ...typical small Gen problem.

So I decided to add two litres of Fuel at around 8:25pm, the Gen just went off some few minutes ago, 2:29am to be precise.

That's approximately 6 hrs for 2litr of fuel with two Ceiling fans, one rechargeable standing fan, my laptop and about 5 charging phones.....that's all.

I will upload pictures of the screw postions tomorrow