wumss:
hello...I need a consultant for water treatment in Lekky County homes Ikota. The water that comes out of the borehole smells badly and it is brownish in colour. Are you able to help?

dayjeee:
Can u give me a cost estimate of the shallow borehole around aguda ogba lagos?
Thank you

Ibinwanne:
Project: Underground water investigation for borehole drilling.


Location: Cele Medu, Awoyaya, Lagos

Please, contact us for all your Borehole drilling projects, Water treatment, Reverse Osmosis( RO), Geotechnical data acquisition (soil test), Piling, Pile load test, Geophysical survey, etc.
(www.olivewell.com.ng).
E-mail: info@olivewell.com.ng.

+2348099405096, +2347055722800, +2348084019485.

CruzJoe:





pls is there a solution to this....
low current doesn't carry our sumo in pumping water......

Is not as if the voltage is that low oo....for me...e suppose carry it cos is not that low.


Is there a kind of stabilizer for borehole sumo in case of such low voltage current?

Ibinwanne:
I think you should first of all get in touch with an electrician to find out if there is anything wrong with the submersible pump or the panel. Sometimes, the problem may just be the panel, because the panel was designed to switch the pump off in case if there is any issue that has to do with high or low voltage and sometimes you may need to be the one to switch it on again. Alternatively, you can use a generator to find out if is current or not, but please, don't forget to check the button beside the on/off switch to make sure is well regulated.

CruzJoe:



when we use Gen....which definitely have up to 220v voltage...it pumps water


Most times...when NEPA current is full...it equally pumps.


Is just when the light is not that full....not as if is too low....it won't be able to pump water...


with these...re u still saying there is something wrong with the sumo.

the sumo is 0.75hp

Ibinwanne:
From everything you have said so far, the only challenge you're having with the submersible pump is light, 0.75hp submersible pump does not really require high voltage to function, is a small pump. But the truth is that an experienced electrician should be able to know if there are some other issues affecting the pump apart from the light, because even when the connection to the panel is not professionally done, it could result to a lot of challenges. Therefore, I advice you to avoid plugging the pump on when the voltage is low to avoid the pump having issues, wait till the voltage is high enough or you use a generator.