chuuxxy:
so boss.... iv checked the pipes and found out i had leakage from one.... changed it and still get the check engine light with same code after making sure no air leakages... am thinking about changing the sensor u pointed out, but getting it is a challenge.... or is there any other reason am still getting the fuel too rich on bank1 and 2 error

imoci:
Pls gurus in the house what does"black turtle mean"

It's this guy

GAZZUZZ:


Pls scan transmission and post codes

J0hnTrevolt:
Chief plz i'v noticed of recent, a very slight noise, very slight noise my car makes b4 d gear engages. Be it reverse or forward. 2005 eod.

solutionboy:
Good day Gazzuz,

I drive an Honda civic 2007. Lately my vehicle has been misfiring and it takes longer time to achieve full speed as I have to fire down in addition also jerks as it climbs a hill or move speedily on bad portion on the road though not all the time.Fuel consumption has also increased. I ran a scan and the ffg codes displayed
P2184
P0113
P0108
P0118
P0102
P2649
I have changed the fuel pump, plugs and catalyst yet to no avail. Please what could possibly be the root cause.

GAZZUZZ:


Remove the solenoid valve, blow thru it, if air goes thru it, it is bad or erase codes Block both sides of the pipes firmly ( independent of each other) if you don't have the rich code the valve is bad.

chuuxxy:
Please where is this located. Is there a picture of the valve. Honda Accord 2005 v6.

GAZZUZZ:


Possible]Engine mounts, C.V joints, Lower control arms.

J0hnTrevolt:
Tnx Chief. Engine mounts is ruled out cos it's still as it is when bought toks dilect flom amelika, never tampered or replaced. I have to settle for d Cv joints or lower control arms.
Plz does it need replacement or serviceable?

GAZZUZZ:


First of all who is gazuu?

The civic and city have a regular suspension setup like the corrola. Sadly one thing I have noticed about the city is very thin steel gauge was used in designing it's lower control arms, which makes them more prone do deformation when they hit really bad roads without notice. for private use as I always say, buy a good car. City or civic will suffice.

GAZZUZZ:


Misfires Triggered by long lack of use. Did Vehicle overheat recently?

slimmoney:
Morning oga Gazzuzz, pls i use honda accord baby boy but recently my car doesnt change gear smoothly i always feel as if someone hit me from the back whenever it changes and i have changed the gear oil and engine seat but yet it still persist.

NinaMiliano:
Oga Gazzuz,.

I have a 2000 Acura TL with 3.0 vtec V6 engine
It was ok until a roadside mechanic was meant to service it.
Timing belt got cut, valves were were grinded and fix.
The car is ok but I hear tutututututu from the exhaust, checked for leakage, none, changed plugs and some coils yet sound is same.
What could be wrong cos it's consuming fuel like hell fire

GAZZUZZ:


Did you scan?

solutionboy:
Good day Gazzuz,

I drive an Honda civic 2007. Lately my vehicle has been misfiring and it takes longer time to achieve full speed as I have to fire down in addition also jerks as it climbs a hill or move speedily on bad portion on the road though not all the time.Fuel consumption has also increased. I ran a scan and the ffg codes displayed
P2184
P0113
P0108
P0118
P0102
P2649
I have changed the fuel pump, plugs and catalyst yet to no avail. Please what could possibly be the root cause.

GAZZUZZ:


List all the accompanying definitions.

solutionboy:


P2184: Engine coolant temp sensor 2 circuit low
P0113: Intake Air temp sensor circuit high voltage
P0108: Manifold absolute pressure sensor circuit high voltage
P0118: Engine coolant temp sensor 1 circuit high voltage
P0102: Mass Air flow sensor circuit low voltage
P2649: Rocker Arm oil control solenoid circuit high voltage
Gazzuz sir, I await ur input pls

ozoneymcm:
Hello GAZZUZZ. Good afternoon. My car suddenly started changing direction with the application of the brakes. I changed the pads thinking that was the issue but I still encountered the problem. Please what do you think could be the issue

Bizzyliss:
take it for alignment and balancing

ozoneymcm:
Hello GAZZUZZ. Good afternoon. My car suddenly started changing direction with the application of the brakes. I changed the pads thinking that was the issue but I still encountered the problem. Please what do you think could be the issue

GAZZUZZ:


Possibly faulty ball and socket joint on suspension, or torn rubber bushings on lower control arm. Have it checked, fixed before doing alignment

Bizzyliss:
take it for alignment and balancing

GAZZUZZ:


Possibly faulty ball and socket joint on suspension, or torn rubber bushings on lower control arm. Have it checked, fixed before doing alignment

Ezimuoh:


Wow thanks. Timing belt on an interference engine. Danger

tukopy:
Oga Gazzuzz please help.

My brother's 2008 Ford edge has an issue with the brakes. Sometimes I'll have to press the brake pedal to the end before the car will come to a stop.
His Kazeem said the culprit is Brake Servo or Brake Server and it'll cost 50k to purchase a new one.

What do you think might be the problem and how much will it cost to fix Sir.

phadriz:

No overheating rececently and I use the vehicle everyday to office, this started when I changed the lower clutch recently.

GAZZUZZ:


the job of the Servo is to increase braking efficiency and reduce the effort required to when pressing the brake pedal. In lay man's English it makes the brake pedal soft (with engine running) and it becomes hard when the engine is turned off.

The brake master distributes hydraulic pressure evenly to the abs pump, which further distributes to each wheel.

if you have an intermittent issue with the brakes the Servo is ruled out.
Please Get a 2nd opinion.