abiolag:
Good morning
My car idle rpm fluctuates. Sometimes too high and after driving for some minutes it will go down. And most times it will go so low while driving which makes d car to off sometime (most especially in traffic). Sometime it will be difficult for the car to restart because the battery will appear so weak to restart the car. I’ve changed battery and also work on the alternator when I was informed it was doing slow charging.
Whenever throttle body is cleaned it will get better for like 2 days and start misbehaving again.
Base on my rewire suggestion to stop the slow charging issue, I decided to change the throttle body yesterday but surprisingly the RPM has remained above 1 since and even this morning when I start the car it was so high almost getting to 2000rpm at idle. The mechanic guy told me that it will normalise with Time which I don’t know how long it will take.
Please what could be the next thing I will do to get a normal rpm?
I drive Camry 2004

abiolag:
Good morning
My car idle rpm fluctuates. Sometimes too high and after driving for some minutes it will go down. And most times it will go so low while driving which makes d car to off sometime (most especially in traffic). Sometime it will be difficult for the car to restart because the battery will appear so weak to restart the car. I’ve changed battery and also work on the alternator when I was informed it was doing slow charging.
Whenever throttle body is cleaned it will get better for like 2 days and start misbehaving again.
Base on my rewire suggestion to stop the slow charging issue, I decided to change the throttle body yesterday but surprisingly the RPM has remained above 1 since and even this morning when I start the car it was so high almost getting to 2000rpm at idle. The mechanic guy told me that it will normalise with Time which I don’t know how long it will take.
Please what could be the next thing I will do to get a normal rpm?
I drive Camry 2004

tojahh:
Once I turn on my AC, one of my coil must burn!

Car is not overheating.

Honda Civic 07
What do I do?

jceesquare:

Get an electrician to thoroughly check your wiring harness.
There's no connection between your AC and ignition coils.

tojahh:



I did a complete overhaul of my AC system... Changed condenser and compressor and evaporator even expansion valve, system was flushed and replaced.

So the AC returned my ac system to factory settings. Since then the coil burn problem started.

jceesquare:

Kindly take the car back to the person to go through job done.

reverendfather:
I went to replace the front bearings of my car today and now my car drifts to the leftside when driving. Plus I can feel the steering is a bit hard and also I can smell burning rubber coming from the front left tyre.

I had to leave it at the office and book bolt home, I was scared it could lead to something more dangerous

leTrizzle:

Wheel alignment is needed.

Dracoe:

My mechanic got it

reverendfather:
o wow, but yhe car was driving okay before all these. Just the bearings making some funny noises

Onyeka90210:

You always have to do alignment after any work on the front legs

reverendfather:
I went to replace the front bearings of my car today and now my car drifts to the leftside when driving. Plus I can feel the steering is a bit hard and also I can smell burning rubber coming from the front left tyre.

I had to leave it at the office and book bolt home, I was scared it could lead to something more dangerous

jceesquare:

That's very wrong. You don't need an alignment after replacing wheel bearing.

Get another technician to physically inspect the car.

ModJ1:
Please house I need help to get navigation and radio code for my newly purchased tokunbo Honda pilot 2011 model

Superman94:
Hello house, my car which is Toyota Camry 2010 consumes fuel at a high rate, the catalyst and every other thing are intact, what could be the cause.
NOTE: it wasn’t like this before, just started recently, I’m tired

Superman94:
Hello house, my car which is Toyota Camry 2010 consumes fuel at a high rate, the catalyst and every other thing are intact, what could be the cause.
NOTE: it wasn’t like this before, just started recently, I’m tired

nurey:


Check the glove compartment a sticker of the code should be pasted there. A five digit number.

If the vehicle came with owners manual glance through it may be available there.

If all these fail, you will have to get it online using your VIN and radio serial number

emrino:
I'd like same, would you mind sharing his contact? Or advise how best I can get it?

ReformerD:
"Good day! My Kia Optima's recommended oil type is 5w-30, and I've been using Mobil 1. However, after rebuilding the engine, my mechanic suggests switching to Visco 2000 due to Nigeria's temperatures. He mentioned that the Mobil 1 oil is too light in texture. Should I stick to Mobil 1 5w-30, or is it advisable to follow his recommendation and switch to Visco oil?"

uncleck:
Good evening gurus. Please what could be the problem with my 05 Honda Civic? It jerks while driving. Sometimes it looses power that I'll have to turn off the engine and restart it again. It doesn't show any error code when scanned. I've changed fuel pump, injector mouth, 02 sensor, nuzzles, ignition coil and spark plugs still the problem persist. What else should I do?

uncleck:
Good evening gurus. Please what could be the problem with my 05 Honda Civic? It jerks while driving. Sometimes it looses power that I'll have to turn off the engine and restart it again. It doesn't show any error code when scanned. I've changed fuel pump, injector mouth, 02 sensor, nuzzles, ignition coil and spark plugs still the problem persist. What else should I do?

Etizz:
Good Day guys, I wanted to change my oil so I asked the mechanic to open the bottom plate and clean it, so I found this pieces of metal or brass about 3 in the oil pump screen, pls where do you think it may come from and how dangerous do u think it could be? How can I prevent it from happening?

Car engine is Toyota 2AZ

Talismann:


it simply means you need to increase your monthly savings to do the needful very soon. Na sign be that, the end is nigh