lungwun: Just received word that a connection lost their home on Sunday due to Solar/Inverter/Battery system fire.
Are there any IP65 rated batteries and Inverters? If i jump into solar because AEDC are more useless than two follicles of hair, I really do not want it in my house anymore.
IP65 rating will help with outdoor placement
It's not a matter of protection class.
A bad installation will still have the same disaster effect.
go fir competent installer.
You can still get IP65 inverter they experience an electrical fire because of wire etc
onostech: Build a complete Industrial IoT (IIoT) smart factory system from scratch — Raspberry Pi edge gateway, ESP32 PLC - FLProg, Node-RED dashboards, predictive maintenance & AI anomaly detection. Full Industry 4.0 open-source tutorial with zero prior experience needed.
In this step-by-step guide, we install the Raspberry Pi headless, configure Node-RED, program the ESP32 PLC FLProg to connect to Modbus RTU, build dashboards, enable remote smartphone control, and implement anomaly detection with CUSUM for predictive maintenance.
oluchibabe: Most things in that quote are too Cost-excessive! Infact. the Installer wants to build House from your Job. Imagine, #16,000 Clamp (#200 each!) to tie down just Six Panels? Run!
That Amount should conveniently get you a 5KVA setup, with 8KVA - 9KVA LiP04 Battery
Depending on your Budget, buy Growatt Inverter (it does not need an External Charge Controller because it is Hybrid), read all the complaints about Felicity in the last 30pages behind though, some will still advice you to buy it, if that is what they have in Stock to sell but the eventuak decision is your own.
If you need an Installer that is reasonable, leave a message for me and l will share his Number, he just did work for me.
The problem with that clamp Is he might be quoting for the actual PV clamp, but might end up getting #200 clamp .
So we can only speculate. Besides all the wires he dey write up and down what are they for? 180k should cover all the wires needed.
fuckboys: No, what the governor does is increases voltage to the fan from 1-12v and at constant current of 1a depending on the ambient temperature.
I’m 100% certain it’s going to work.
Yes there’s yellow wire a tach sensor, this actually sends signals to the inverter to shut down in case of fan failure
Yes there’s a blue speed control wire, now this wire doesn’t matter anymore if the power to the fan isn’t controlled by the inverter anymore. This wire will remain and tell the inverter to send full 12v (highest speed) to the fan which the inverter can’t do anymore cos it doesn’t control power to the fan.
Now this is where the governor comes, anything with motor actuality increases or decreases speed depending on the speed of current passing through it which is voltage. The governor increases voltage to the fan when the temperature rises.
fuckboys: putting expensive brushless fans that would still run 24/7 on high speed.
This is actually the best cos it controls the speed using ambient temperature, lowers the fan noise and will also prolong the fans life cos it won’t be running at full speed all the time anymore.
Your idea actually works if it's a 2 pin fan(just + &-) What you have not considered is that the fan needs input voltage to to be able to Send signal and it needs to receive signal too.
Red = +12v Black= -12v Yellow= tach signal from the fan Blue= speed control signal
A better approach will be to use an external PWM signal to control the present fans
I am quite sure the device you ordered will likely connect the power to the fan when a certain temperature threshold is met
fuckboys: I have made my research and you're wrong chief.
I'm not disconnecting the fan totally, I'll only run the power line of the fan through the governor. The fan has 4 wires. The sensor and signal wire are still connected to the inverter
So if it can only lower the speed of the fan at night, I'm okay cos night is my only issue.
fuckboys: I won’t be going to arena anymore, I think I will diy with this. This is the best solution imo. Ordered 2 already
No stress your self the best option remains to buy a real brushless fan.
If you decide to remove the fan, it will affect the inverter. The inverter is designed such that it receives signals from the fan (around 5v). It's through that signal is able to tell when a fan is connected or not.
It seem lot of folks are complaining about the fan noise, there should be a way out anyway.
oluchibabe: Good morning Gentlemen (I even wonder why we dont have more Ladies contributing here?)
Thank you to all wey give me ideas with my own Solar issue, it is partially being resolved but not fully sha.
But l have decided to help a friend, and bring his matter here, as a show of gratitude for the helep l don get here. We want to install Small Solar System for im House, on the Roof of a One Storey Building.
We have identified good Stores where/from whom to buy the 4Units of 715W Panels, Inverter and Good Lithium Batteries. No purchases yet, though.
Wetin l dey seek here, is a TRUSTWORTHY Installer who can do Roof install without damaging the Roofing and causing leaks because his Landlord will be very annoyed, if he causes a leak on the Aluminum Roof.
If you are good with Roof Installs and are Trustworthy (very important), please leave indicate here and l will hook you Up.
Good morning.
All Services are to be Paid for, dis one no be "Niaraland Helep" thing.
onostech: Take your Node-RED dashboard global! Learn to set up mobile alerts, remote control, and industrial logic for ESP32 PLCs to manage your Industry 4.0 factory from anywhere.
In this episode, we transform a local setup into a worldwide IIoT Edge Gateway. Using Remote-RED, we implement push notifications and "Question Nodes" that allow you to shut down a failing motor directly from your smartphone. We also dive into professional Javascript function nodes for debounce logic, state management, and localized timestamps. Download the code on GitHub and join the open-source automation revolution!
BangaRice: Who produced the cars and gadgets? Roadside technicians or graduates?
Matter of fact, most of the theories we are learning in school didn't originated from graduate or technicians. They originated from apprentice who made their observations from working for their masters.
What am I trying to say modern education created this hierarchy and classes.
A technician will likely outperform a graduate if he is willing to put effort to study and observe and vice versa.