₦airaland Forum

sirleke:
thanks for your response sir:. My Kaz confirmed just last week that I still have it intact....gonna double check/confirm/sure by this weekend again

sirleke:
P0420: catalyst system threshold bank 1
catalyst system efficiency below
threshold bank 1

P0506: idle air control system RPM lower than expected....

Got the codes on my car...

Some1 should help out.

Thanks

DelTel:
@gazzuzz pls how much is the gear and engine with 3months warranty.



Is vehicle available and customs papers, how much las las pls?

Abdomox:
Hello Gazzuzz, thanks for the help so far. When I scanned the car again today, it shows code P0303 as pending fault.

Now my mechanic is advising I change the cylinder at the back. What do you suggest please?

Change both cylinders or the one at the back only?

greggng:
Oga Gazzuz I throw way salute ...my mum's burial is on Saturday ..otherwise I would 've bought this car and fix it and advertise it here ....I swear none of those bad mouthing it will recognise it after . ....

greggng:
The gear box is faulty ...my mechanic also confirmed to me that The engine is not top grade...in the other hand engine and gear need replacement if you want to enjoy the car. Again , the back and front bumpers needs replacement..The passenger side airbag need replacement ...To perfect the job , you can do a few body work and paint the car. The a.c. still works..

Note...This car is meant for end users not dealers

Engine and gear budget 270k

Bumper budget .....35k for both
Body work and painting budget ..70k
Cost of car 650k

Total N1,025,000

Only serious end user should call 08062593234. Location Gowon estate Lagos

this is a humble deal.

Neddstark:
If we can unite on #endsars, can we unite on these uneducated bastards trying to make a living by harassing others. The old man messed up. If they are going to arrest me, they have to arrest everyone plying that road.

Wahala be like bicycle

bigseank:
hello Chief. please help out.

I have an EOD 2004 with gear issues. The car refuses to enter any of the drive gear, it would just rev. it only enters the reverse gear. We have tried draining and renewing the gear oil with the DW1 as i just found out to use only this, but the same problem still persist. The car was with my mom while i traveled out of the state and she was using it. the car has been packed down for 4 months since it was towed home, it cant move to anywhere. Before it developed this fault, she noticed the green light on the dashboard that shows you what gear your are on, doesn't comeup.

The mechanic working on it says it is the gear sensor, but he has been battling with it for 4days now. i just bought this gear last year April, please i cant afford to change it again. i have been showing loyalty to the mechanic because he was the one that towed it at a very late hour that day, but at this junction.

Attached is what he said should be changed

bigseank:
hello Chief. please help out.

I have an EOD 2004 with gear issues. The car refuses to enter any of the drive gear, it would just rev. it only enters the reverse gear. We have tried draining and renewing the gear oil with the DW1 as i just found out to use only this, but the same problem still persist. The car was with my mom while i traveled out of the state and she was using it. the car has been packed down for 4 months since it was towed home, it cant move to anywhere. Before it developed this fault, she noticed the green light on the dashboard that shows you what gear your are on, doesn't comeup.

The mechanic working on it says it is the gear sensor, but he has been battling with it for 4days now. i just bought this gear last year April, please i cant afford to change it again. i have been showing loyalty to the mechanic because he was the one that towed it at a very late hour that day, but at this junction.

Attached is what he said should be changed

Born2conquer:
Gazzuzz, do you have these tyres available?

Abdomox:
This is the 2nd time in 4 weeks the head gaskets were changed.

I am curious if the mechanic did not fix it very well, or there's something spoiling the head gaskets after fixing. Kindly advise.

dljbd1:
@GAZZUZZ

Hi Boss,

Please I have the following codes showing up on my scanner. Its a gear issue that made me get the Bluetooth scanner.

The gear slips when changing to 2 and wouldn't shift up until I off and on the car before it engages normal but starts the crazy after like 10mins. It has been really frustrating.

It started after I serviced the gear sometime in July with another transmission fluid (can't remember the name). At a point, the D began to blink then I decided to revert to DW1 about a month ago after doing some online research. I plan to drain 2litres out and replace with DW1 in 2wks time.

Please can you help out/advise on what to do. I wish to fix all these codes if possible but first off is to fix the gear.

I use '03 EOD

Abdomox:
The engine is 3MZ-FE.

Just changed the head gasket. What could damage it again? Or was it not properly done?

ojun50:
.Sometin dey worry una, park all the cows in Abuja and go to the stadium let them eat the grass.

Somone should give this man an award

Abdomox:
Observed this bubbling on the radiator

Abdomox:
Yes. New Radiator was bought alongside Tokunbo fan

Abdomox:
Good day Gazzuzz,

I have a 2006 Sienna running fine without a thermostat. But the driver allowed the gasket to blow due to overheating.

My Mechanic re-surfaced the Cylinder and put a new gasket. The car is still overheating while in traffic, but runs well when driving on highway.

While driving, the check engine light started blinking. When scanned, P0301, P0303 and P0057 were the codes showing. After replacing oil seal and Injector Nozzle of cylinder 1 and 3, codes P0301 and P0303 disappeared. Still, the car is still overheating.

The only code showing now is P0057

Things done: Changed Fan, Changed radiator, replaced most hoses, Replaced plugs & 1 Nozzle, Serviced other Nozzles.

Please what can be the cause of the overheating in traffic after all these repairs.

Thanks.

eRex:
Good morning auto gurus in the house.

I recently realized my corolla 2008 South Africa has no "ring" on the shaft head on the wheels.
I realised this when the abs cable snapped and we were reconnecting it.
Abs cable reconnected now and it works just as before but my mechanic says I will have to get a ring for the shaft head.

What's the pro and cons of this cos I have been driving car so over years...

Your vehicle is equipped with an electromagnetic pulsar . Not the old sch type

The pulsar on your vehicle is attached to the wheel bearing.

eRex:
Good morning auto gurus in the house.

I recently realized my corolla 2008 South Africa has no "ring" on the shaft head on the wheels.
I realised this when the abs cable snapped and we were reconnecting it.
Abs cable reconnected now and it works just as before but my mechanic says I will have to get a ring for the shaft head.

What's the pro and cons of this cos I have been driving car so over years...

mrsdaniel:
Hello, I've a sienna '08 which had clogged fuel pump filter issues but dirt was cleaned and car drove up hill smoothly .. We observed sometimes the RPM fluctuate and car hesitates a little but am not really convinced with the mechanic touching Car injectors since I haven't done any work around engine asides oil change since car was bought few months ago . Car was scanned yesterday after seeing some black smoked color around the exhaust and higher fuel consumption and came up with codes ( P0159 , P0300, P0174 , P2197 ) in snapshot below.. kindly assist me with these codes & possible solution ?

Abdomox:
Good day Gazzuzz,

I have a 2006 Sienna running fine without a thermostat. But the driver allowed the gasket to blow due to overheating.

My Mechanic re-surfaced the Cylinder and put a new gasket. The car is still overheating while in traffic, but runs well when driving on highway.

While driving, the check engine light started blinking. When scanned, P0301, P0303 and P0057 were the codes showing. After replacing oil seal and Injector Nozzle of cylinder 1 and 3, codes P0301 and P0303 disappeared. Still, the car is still overheating.

The only code showing now is P0057

Things done: Changed Fan, Changed radiator, replaced most hoses, Replaced plugs & 1 Nozzle, Serviced other Nozzles.

Please what can be the cause of the overheating in traffic after all these repairs.

Thanks.

seunoj:
I get panel beater wey dey craze. They will fix it. Let me know u r interested.

AmandaLuv:
OK. Will u buy the engine with humility? Car still runs smooth with AC

icu4:
Hello boss.. I'm on the verge of buying a Toyota avalon 2007 (toks) . I intend to use for normal work - home commute... Based on your experience what will be your advice

AmandaLuv:
Good evenning Sir. Plz is this car salvageable? What's your kind advice to owner? Thanks.

PS712:
Buy sir. Am not in Lagos, Kaduna to be precise.

mrsdaniel:
Hello, I've a sienna '08 which had clogged fuel pump filter issues but dirt was cleaned and car drove up hill smoothly .. We observed sometimes the RPM fluctuate and car hesitates a little but am not really convinced with the mechanic touching Car injectors since I haven't done any work around engine asides oil change since car was bought few months ago . Car was scanned yesterday after seeing some black smoked color around the exhaust and higher fuel consumption and came up with codes ( P0159 , P0300, P0174 , P2197 ) in snapshot below.. kindly assist me with these codes & possible solution ?