₦airaland Forum

Now that sanity has been restored, I can continue with my selfless service to the benefit of humanity.

Finally, they’ve successfully derailed the thread for their selfish benefits.

…Unfollows thread…

clinician2x:
I have misfire on cyl 4 (p0304) as the only code. Now when I clear it and drive, it will not show up and acceleration will be steady for as long as but once I park and get out, only to start the car much later to move, car will start jerking and check engine will appear and start blinking for a few seconds and acceleration will be steady if I drive for say 5 mins. On anothercold start however the cycle continues.. I have changed all plugs and mechs have cleaned the injectors.

Having checked and performed the following above, swap the coils if it still persist, run a compression test wet and dry compression test pls.

Hope you didn’t hydro locked that 4th cylinder

louken:
Wow

There’s a reason I asked you to replace that transmission. Your car came from factory with a U151F transmission AKA 13pin gearbox. It’s a very sensitive transmission and doesn’t tolerate abuse or any error. It’s not a forgiving transmission by any measure. It’s easier for me to ask you to repair that transmission and go about my own life, but you’d be the one spending money to fix something which the technicians won’t give you a guarantee or the valve body or solenoid part sellers won’t offer buy back guarantee. Your best bet here is to replace that transmission with a tokunbo unit and 1 week warranty and call it a day.

clinician2x:
Pls oo. I recently took my car to a car wash, everything was pressure washed including engine bay and right from that moment, I'm experiencing misfires and jeering at idle and rough acceleration. I've called two mechanics so far, they have changed the plugs, clean the injectors and nozzles and airfilter all of those but I'm still experiencing this issue. My mpg is dropping from the usual 16mpg city driving to around 10mpg now. Car is lexus es 300, 03.

Scan and post codes here. We will assist you with the remote work.

timenamoney:
Re: Tell Us Your Car Fault Lets Assess And Fix Them by kingreign(m): 8:52am On Jan 17
louken:
I started experiencing sluggish acceleration at second and, sometimes, third. Beyond that the vehicle moves smoothly.
I scanned and got these codes: P0500, P0986 and P0798.
Please how do I tackle this problem especially with the last two codes that point to solenoid.
Will replacing the gear brain box solve the problem.
Also, where is the vehicle speed sensor A located. (P0500)

Car is 2006 Rx330 AWD



PLEASE KINDLY DISREGARD THIS UNRECOMMENDED ADVICE FOR TROUBLESHOOTING YOUR PROBLEM

THE GEAR DOES NOT HAVE IT'S OWN BRAIN BOX, RATHER IT HAS SENSOR'S, SOLENOID, VALVE, THAT REPORTS TO THE CAR ECU OR ECM (BRAIN BOX ) FOR PROPER TRANSMISSION AND ENGINE OPERATION FOR PROPER MOVEMENTS, THE MANUFACTURERS KNOW THIS ITEMS MAY GET BAD AND BE REPLACED, THAT WHY YOU HAVE THE CODE TO IDENTIFY THE PARTICULAR COURSE OF THE SLUGGISH ACCELERATION, AND WILL NEVER ADVICE YOU TO BUY A NEW TRANSMISSION , WHAT IF YOU BUY A NEW TRANSMISSION AND A TRANSMISSION OBD CODE COMES ON AGAIN , WILL YOU PREFER REPEATEDLY CHANGING TRANSMISSION'S ?

REMEMBER TIMENAMONEY

Pls, kindly open your own thread and stop detailing my thread with needless and untested advise born out of zero experience.

Thank you.

stanlotion:
Pls help me resolve this: My 1999 Camry 2.2 selects fuel pump. It doesn't use new fuel pump. It only uses Belgium fuel pump. That's the only pump that makes the engine to run smoothly. But have seen other Camry of same model use new fuel pump. What could be the cause?
Pls help a brother as the Belgium pump is more expensive besides, it is not readily available as the new pump .

Stick to what it accepts na. Most new pumps sold cheaply are knock offs aka poor quality aftermarket parts.
Also, pumps shouldn’t be failing frequently except your vehicle Electrical or engine is having some underlying problems stressing these pumps or you run your car till the tank empties.

kowalsky:
Thanks for this boss.

You’re welcome sir

3kay945:
Seriously, let me go confirm cos all bulbs are working o

Replace all chinko bulbs with genuine bulbs also that high mount stop light you need to check it well.

3kay945:
Good morning bosses in the house,
Plsz, what is meaning of the light on dashboard?
Rx300 2001 model

One or more bulbs is dead. Replace with good tokunbo type bearing same wattage pls.

Therockauto:
take note, you can't idle when the transmission is in the drive when you are in the traffic, So if you want to idle you need to shift to neutral. So why idling? Shifting up and down is a bad idea.

Where did you read or heard or learn about this from?
It’s totally untrue and needless.

kowalsky:
Thanks boss. Appreciate the insight.

Is there a known issue with these engines failing. If it's on the off chance and more cautionary than certain for the engine to fail, it's a bill i can manage.

My main concern is with day to day reliability. I'd say I'm meticulous when it comes to maintenance. If I were to stick to factory recommendations for maintenance , do you see this car popping up with issues?

Manufacturer defect and also highly over engineered engine with very little tolerance for the slightest laxity.
A Honda engine is way more reliable than that Mercedes Benz engine. Remember, Honda is the biggest Internal combustion Engine manufacturer in the world.

jceesquare:
I disagree with the bolded. Leaving the car on neutral should not stress the gear in anyway, but rather idling with a drive gear (R or D) is what stresses the gear.

Wear the quoted pls.

Also, more quotes from Quora.com,
https://g05.bimmerpost.com/forums/showthread.php?t=1788962

Etc

kowalsky:
Boss. Please expatiate

M276 engine is not a forgiving engine. It’s also more than 2.5m at the current market rates.
M272 is approximately 800-1m now.

jojomario:
just Ike that?

Just like that!

jojomario:
He confirmed one coil to be bad. I got another one. But engine now come up with white smoke. He's suggested a bad piston ring on the cylinder 3.

Replace engine!
New year GOBE!

jojomario:
I went to scan the car again. Giving me this codes
P0301, P0301 P0303, P0303 (cylinders 1-4misfire)
P0012
P0116

P0303 came out twice (pending and current)

Solve the cause of misfires, the P0012 should disappear

jojomario:
Good evening house. My car vibrates a little and start blinking the check engine light. I stopped by for rewire and mechanic to have a check. I was told the line 3 on the cylinder is faulty .

I was told the issue is from my cylinder and not nozzle, plug nor coil. My mechanic worked on the cylinder, he showed me the line 3 side being oily.Replacing 2 valves on the line 3 and grinding the valves and cylinder. I changed the plugs to grade 1 tokunbo. After coupling, and starting the car for a long time. I realised if I'm on a spot on D it vibrates, returning to N, it will be normal. If I put ac on D while on a spot, the engine might want to go off but if I put on N, it normalizes.

Please, what could be the cause?
It's a camry 08 2AZ

Pls carry out compression test. Also, you need to ask your mechanic if he performed a break in procedure after the repairs.

timenamoney:
you didn't debate anything rather you contributed , I was expecting debate about brakes to look at beautiful ladies lol it was said to add fun to the trend, so do you mean when the gears is under stress it cunsum the same fuel as when it's not under load, so what powers the gear box ? Water or fuel?

Pls what did you just write here?
I don’t understand and I can barely find any relationship between what I commented and your response.

Get the Honda pls

timenamoney:
pls note Any mechanic working with out an obd scanner or ignorant is a qwak kazeem , so start by buying an obd scanner at jumia or konga for 5k and above

High fuel consumption can be coursed by many factors

1) no themostat leading to open loop fuel injector operation
2) connecting the fan to blow continuesly
3) low tire pressure
4) using thick engine oil viscosity, that stressed out the oil pump for more power to work
5) insufficient EGR valve flow
6) excessive load, remove all unnecessary items in your car
7) bad driving habit, excessive acceleration and brakes when looking at beautiful ladies lol and slowing down at bumber
excess idle and driving at go slow with out putting your car in neutral ,
9) failing o2 sensor etc.

Pls this is highly debatable. Yes, idling for long periods of time will take fuel, however, putting your car in Neutral will have NO effect on your fuel consumption whatsoever. Rather, it will cause stress on the transmission. Please research more on these.
Thanks.

https://www.motorbiscuit.com/5-things-you-shouldnt-do-in-a-car-with-an-automatic-transmission/

Buharifan:
Got this code from car. Note the car doesnt accelarate pass 3000rpm.

The culprit is p0335

timenamoney:
When I bought my camry it came with a 1 cell plastic radiator, after ignorantly listen to a qwak kazeem to buy a double cell and remove themostat then ,when I didn't know how a car works, which has been reversed by putting back the thermostat, but after resetting the fans to factory settings, I started observing gear oil shortage with out a dropping in my driveway, a kazeem advice I change a seal between engine and gear box , which I did but the shortage continued, but after resetting the fan at the gear box side to blow continuesly for safety sake, which I know is wrong the shortage stopped , which means the gear box oil shortage is course by overheating,

Pls note that the gear box oil cooling line are linked to the radiator

What your take? Should I re-buy the single cell radiator? What should make the gear box oil to over heat and course shortage? I need to reset the fan to factory for better fuel economy
Thanks

Get an external transmission cooler for the transmisison. As for the Radiator, double cell is better cos it handles more cooling than the single stock radiator.

P0335 is the culprit. However, it will be better if you solve the whole issue with these codes.

Osasxplus:
I have an es350 won’t crank security light flashing while the ignition is on steering wheel won’t unlock when I press the brake pedal is turn green but the push button does nothing at all I had key no detected issues before which they had to replace the smart key box with some IC 900 replace from the old smart key box car lock and unlock security alarm works fine but car won’t crank at all from start button please help

Did you replace the electric steering lock?

louken:
I started experiencing sluggish acceleration at second and, sometimes, third. Beyond that the vehicle moves smoothly.
I scanned and got these codes: P0500, P0986 and P0798.
Please how do I tackle this problem especially with the last two codes that point to solenoid.
Will replacing the gear brain box solve the problem.
Also, where is the vehicle speed sensor A located. (P0500)

Car is 2006 Rx330 AWD

Replace gearbox.

Buchika:
Please house any suggestions on the best personal scanner for 1st generation Toyota highlander v6 to buy.

Any good scanner car scan it. Launch, foxwell, Autel etc.

jeff1607:
For instance the fuel meter gauge doesn’t stay put to show the actual amount of the fuel in the car , it goes up n falls down like the hand of a clock , all the corresponding gauges does the same

I have no idea what’s wrong with it. Have a competent electrician check it.

jeff1607:
My Nissan sunny 2011 has the dashboard light flickering and all the arrows cat seem to stay put to ascertain their functions as it goes up and comes down and also AC dies pick up until it gets heated by the sun, any solution?

I don’t understand, pls explain better

josephsm823:
Lexus RX 350 jerks when I step on the throttle pedal. It only jerks while accelerating anytime I step on the throttle pedal.
No check engine light ON

What could be the issue?

please I need advice

Stop trying to step on the throttle pedal
Okay okay I am only trying to pull your legs.

Those U151F and U151E transmissions are known to ‘have a mind of their own’ and may delay or even suddenly shift causing that jerk when you try to accelerate sometimes. But I think you may have to give it to a technician to have a look at the car abs properly diagnose this issue so you don’t end up stalling the vehicle when you need to accelerate.

Dozieson:
For me, no sir. Why not go for 2012 or Honda 2011

That Camry 2011 is very very good. No need dissuading or diverting his attention from what he finds pleasant.

queentefah:
Advice needed. Moving from Toyota corolla 2009 for Toyota Camry 2010/2011 a good idea.
Nurey
Kingreign

Go for it. It’s a great idea!