Okay

topsy23:


The smaller ones are 1500W while the 100L and 120L are 2000W

For the 100Litres to 120Litres the power rating is just 2000W;
Using Ohms law P = IV,
and I = P/V,

Current rating is just I = 2000/220 approximately 9.1A

and they are single phase. With with your 4KW generator you are okay.

In terms energy conservation, it's nice, but the disadvantage is the energy loss at the distribution line, the farthest toilet experiences low heat this is well pronounced if the heater is not well positioned or centralized, those that are closer to heater perform optimally,

sethtsadopp:


I actually don't need conditioned air in the closet. I even wished there was a door that separated it from the room so cold air doesn't escape inside the closet as nobody lives/stays there.

Okay, but I feel there's a need to have a reasonable thermal comfort within your livable space,

On a more serious note 2Hp(1nr) can not conveniently cool that space (master bedroom), it's cheaper if you can make provision for 2 ACs either in terms of sleeves or piping to avoid breaking of walls in future, with this you have nothing to worry about anytime you feel there's need to increase

sethtsadopp:
Please is one 2HP Inverter AC manageable for this Master room?
Note that the door has been moved from right after the stairs to the main entrance of the room itself (after that sink) so the lounge is separated.

No, 2nr of 2Hp sized AC is the most adequate, widen the closet entrance door to have maximum conditioned air

Born2conquer:
Our two tanks (3000litres per one) do take about 2hrs before they get filled up from the borehole,

Is there a way to make it faster?

If I may ask, What's the size of the pump and pump mains?

This always happen if the pump and pump mains are undersized

somehow:
Hello house.

Please, for a treated borehole sending water with some particles of sand from the reserved tank to the main tank, what can be done to eliminate sand from getting to the main tank?

To the few plumbers we have on this thread and to the knowledgeable ones here.

Thank you.

1- Clean your tanks
2- Incorporate filter to the pipe network,

bixton:


Okay.
Please what's the charge for workmanship alone per point if the client is buying the needed materials?

I charge 10k per point for ( piping only), you can reach out to me sir,

topsy23:


75mm could have been better for this

I don't think so sir, bc 4" is the minimum range size for cookerhood, although it will work but with lower efficiency,

CDG1:

I supply granite 24/7 and can handle as much as 2,000 tons daily.

Materials available are: Boulder,Dust,1/2inch,stonebase,3/4,5/8(3/4down) and Hardcore.

Note: I accept payment on delivery or payment before supply,I don't supply for credit for new clients.

I can also get you a truck to convey the material to any location within Lagos mainland and Island.

price list:

Boulder =6500/ton

Dust =2200/ton

1/2inch =7000/ton

stonebase =6500/ton

Hardcore =6500/ton

3/4 = 7000/ton

5/8(3/4down) =7000/ton

For more information, you can reach me on

08126254470 (WhatsApp)
07026691840 (calls)


Why you should buy granite from me:

�24/7 supply and support

�provision of trucks (China trucks and Mack trucks)

�exact tonnage

�issuing of waybill

� payment on delivery for new customers...one week credit sales for old and consistent buyers (under partnership).

� Affordable price (trucks)

� Quarry price (materials)

�clean materials

� my materials will deliver excellent projects that will pay off your hard work.

�hope we get to do business today

Is tfare inclusive?

redgem:


For the plumbing?

Yes

redgem:
Good evening Bosses....please help me review these quotations for piping of a 3 bedroom bungalow (plumbing and electrical).
4 AC units (1 each room & 1 for parlour)
2 Water heaters (2 rooms to 1heater)
The picture is for plumbing and the write up below is for electrical piping.

2 bundle of 20mm uk pip
1 bundle 25mm UK pip
1 highbridge 12ways neb
1 pcs of 6*6 England
6 pack of 3*3 England
6 pack of 3*6 England
1 pack of ubox dignity
1 pack of ybox dignity
1 pack of 20mm Copp dignity
1 pack of 25mm Copp dignity

The prices in the above list is fair enough, from the prices, it seems he's using light pipe, pls ask, more so tell him to use 50mm pipe for waste pipe instead 40mm there's no much difference in their prices,

qwertyboss:
Please if you have the PDF file of Simplified Reinforced Concrete Design by Victor I. Oyenuga
Kindly share please...
WhatsApp 0nine0six38two97one1

Kindly get an hard copy, that's the best way to encourage our dear authors, let's not support the piracy!

Your best plug for Plumbing and AC installation

Plz, sir, who know any good & reliable sharp sand and granite supplier, to supply materials around omi-odio, Ibadan,

folmus:



Installation gangan. Mowe-Ofada

10k per point

folmus:


How much do you install AC?

Piping or installation sir, and where's the site located?

Oviebright:

Sorry to mention I was talking about two different sites. One at designing the other at decking stage but it's the same architect. He only gave me the architectural and structural drawings with seal. He's a licensed guy. But we intend using flat roof for the decking building I'm seeing a lot of negative comments on flat roofing. And the architect said we should use hollow Blocks what's the difference between using hollow block and normal blind blocks?
What's the use of mechanical drawings I'm not familiar with it.

MEP drawings Consists of all the details regarding HVAC systems, wiring, and piping required for the construction of any type of structure

Your best plug for plumbing and AC installation
[b]#ExceptionalValue#Simplyplumbing&HVAC#

hamtabfawaz:
Good Evening house.

Lost my Mum Today

Sorry bro! May God be with everyone!

Good morning
We're always ready to provide solution to all your plumbing and Air Conditioning needs, engages us today, for your MEP projects

Good evening!
We're always ready to provide solution to all your plumbing and AC challenges, engages us today, for your MEP projects

EgunMogaji2:


Called my neighbour who is an AC person and he got it sorted out for me this morning.

Thank you very much for clueing me in and we're now cooking with propane

Cool! , you're always welcome,

EgunMogaji2:
Question for plumbing gurus. So I need help terminating the pipe I placed in the wall for my propane supply.

Any safe suggestions to hook these two together?

Thanks.

Kindly follow this procedure, although I don't know the size of the hose, but I assumed copper pipe : 1/2", hose size: 3/8", I hope it might be helpful, but I will still advice you to get AC technician to carry It out for you properly,

Tools and materials needed:
Flaring tools, 1/2" by 3/8" male flare hose connector and nut, hose clip, thread tape

1. Insert¹flare nut into copper pipe

2-flare the copper pipe with flaring tools to appropriate size,

3- tightening the male flare hose connector with it's nut firmly with thread tape

4- insert the hose into the tips of hose connector and clip it tightly,

5-testing of leakage

somehow:
@House

Please, can tiling stop a wet wall from expanding?

The leaking pipe was replaced, yet the wet wall keeps expanding.

No, it can't, although it might not be visible, but the leakage will keep expanding to untiled area, the water will always have its way, this means the problem hasn't fully solved, I will advice you keep troubleshooting, until lasting solution is found, re-pressure testing and grout all the floor tiles openings if necessary,

KolaShangOne:


I feel its much if its just first stage.

First stage means no external works, right? So I don't think he needs that much 4 inch pipes.

Yeah, it's much he shouldn't need more than 7length,

sethtsadopp:
Please is there any danger with using China PPR Piles instead of Turkey?

Although China ppr is cheaper, the issue is the service life, nominal working pressure, reliability, turkey ones are the best especially hakan, for plumbing, the quality of materials is essential, and no amount is too much to be incurred for having rest of mind,

2roll:
Good evening all,

I got the attached estimate from my plumber for internal piping for cold and hot water for one unit of a 3bedroom flat( one storey building)

I would appreciate if professionals in the house help me look into this list.

Thanks

It's cool but tell him to use 1/2" sized of PPR for the hotline considering the cost implication of using 3/4" size for it, is excessive, only if you're are using central water heater that's when 3/4" size might be applicable,

More so, no gate valve or stop cork in the quote, is it omitted or it's not going to be used, kindly seek clarity,

henrymor:
Good afternoon smart people in the house,

Please what is the major difference between a standing AC and a split Ac? I want to get a 2hp inverter Ac and I am confused about whether to go for a standing one or a split ac.


How is one better than the other, please?

None is better than the other, each with pros and cons, more so everyone has his own choice of things, but these factors can be helpful in making the decision,

1- Room space : floor standing AC flows well in a spacious room, but if not choose wall mounted, that why it's mostly use in the living room,

2- Accessibility: floor standing AC is more accessible especially for elderly,

3- Distribution of Air: the conditioned air circulate evenly through wall mounted AC, in most of the cases, furnitures are easily avoided due its high positioning, reverse is the case for floor standing,

4- ease of installation : floor standing has this one, it's easy to install,

5-Aesthetics : floor standing is the best it's more appealing,

6- maintenance: both are easily maintained, but wall mounted has features which are more easier to clean,

n3xt:


Just thinking aloud. What if the guy has no ulterior motives?

I went the bush wood route in one of my personal build and I can still tell you some of the woods supplied to me are still lying on the floor unperturbed after many years.

I had to reward the supplier 7 years later when I realized I wasn’t cheated.

Inside life! Ninu Aye

rotecch77:


I don’t have permanent supplier now in that Axis I buy anywhere I see cheaper rate. Cost of things are not smiling now
But for sand you can go to ilaje area very close to vgc you will see those China truck there loading direct from lagoon at good rate

———/-
In other news this our ongoing duplex remodeling is coming out gradually by gradually.

NL good clients thanks oo

Weldone bro! I wish you best

diordaves:


The tiles go support the weight of the tanks so?

I think is just to complement the waterproofing, if I'm not mistaking,

chimexdnice1:
Good day all. Please as a follow up to my inquiries on roof-top tank elevation, this is how I eventually did it. Thanks for all the advice.

Well done sir!