₦airaland Forum

calculation:
Weldone for the job. Please what is to blame for this?

sultaan:
How does the oil pan pick up screen and crank shaft look like

GAZZUZZ:
send them to me nah pls.

So no sourcing parts from our IPOB brothers is ruled out?

radautoworks:
We would refer them to you unless they were willing to import one of ours.

radautoworks:
Such a strong word! I'm not sure how I made it look evil. You started this thread and we both presented our cases so....

Many people on Nairaland have talked to Glen. Look through the threads. If you want to go up against him, your funeral. I'm more your speed.

Again, I'm not sure where your are getting these symptoms because those weren't the problem when he came lol. You assume things A LOT.

Actually, I wasn't going to bring it up BUT from what I understand, YOU presented a replacement choice to the customer and we presented ours. He chose ours. We never spoke to him about a replacement because YOU already had so.... Also, not a Camry.

radautoworks:
Go sit in the corner of you're going to keep asking childish questions. Adults are talking.

radautoworks:
New one. Toyota Corolla. [b][b]Owner ready for engine replacement [/b]but really all it needs is crankshaft and oil pump. Owner will have a 6 month warranty parts and labor on the repair.

radautoworks:
Parts 140k, labor 100k. 6 month warranty on both.

GAZZUZZ:
cost of crankshaft? Bearings? Piston rings? Etc total package.

will the crankshaft be brand new?

Oil pump brand new?

victorD3:
My brothers. Please i have a serious problem with my honda accord 2008 model 4 cylinder. I changed my shaft, camber bushings etc. Since then my percenger side shaft have been popping out from the cup.
I bought over 3 shafts of thesame size and make but it still pulls. I changed all the engine and geer box seating and mount still no way. A friend asked me to cut and extend the shaft whichbi did and it vibrates the car.

Please my people help me what could be wrong with the right leg of my car?

sultaan:
How does the oil pan pick up screen and crank shaft look like

lofty900:
Gurus in the house, how long does it take to charge a dead car battery from zero to full. How long is it going to last before it goes dead? Thanks in advance

Gazzuzz, autoreportng, carguideng , ur expertise is highly needed.

thebigkendo:
If I mention one of diportivo friend, a port harcourt oil seller aut*tra*er2..this thread go just scatter

I doubt if Toyota motor oil is at fault.. I will say extended oil change with a non-synthetic Toyota motor oil caused the sludge

EgunMogaji:
Thanks for the answers.

I wish that more people educate themselves about engine oil.

The valve train and the crud scares me.

iameze:
So dey adjusted the timing after working on gasket I think,right?And what if they opened and discovered some bent valve and replace with timing.Can I get my engine back to shape. Also I ll like to know the approximate cost of a 2007 Acura MDX tech engine?or am I better of buying top cylinder? Thanks

CC: GAZZUZ

Olamiikunle:
Good evening member, I am new here.
My toyota Camry 2097 xle had its ABS light and Slippery light on. Also the Check VSC system notification showing.
I changed the ABS sensor that was bad after scanning. The ABS light went off.
But the slippery light and check VSc comes on immediately I start moving at some minimal speed.
Also I notice that if I press the brake pedal while the car steering is turned to the left (like if I want to make a left U-turn and have to wait from a coming car), the car becomes slippery a bit an makes a staggering sound.
Pls, anyone with an on how to solve this.
My mech can seem to find the cause

EgunMogaji:
Hot or cold engine?

Startup to idle or high rev to idle?

Which engine oil? Toyota recommended? Engine oil and viscosity affects pressure.

iameze:
Please help,
I took my 07 Acura MDX to a "fake expert " because I had the engine oil light on dashboard of which the oil is OK at top level. On the other hand he called my attention to a sound from the engine saying the "its teething"(whatever that means). So from what I heard they doubled something that was flat(gasket maybe). After I insisted he uses the SUV for a day/2 to confirm job.Only for him to say my SUV trips off on motion.The car ended up for months at the rewires place who said the alternator was bad(although I had batt running down prior). So I changed it(3rd alternator eventually worked),I took it for a drive on very short distance and then tried a longer distance same day in a short time(with the rewires boy).Only for the engine to go off on motion just abt getting back to the shop. Tried to crank it,and got a weak turning and wouldn't start. Was later confirmed timing belt cut off.What are my chances?cos ve got both the army and Navy standing by for brutal engagement (Since dem like the Kazeem name ppl give them,we make it permanent for them).In BTW my Acura interior is in a mess,u need to see the rug and leather so dirty I ll need to soak the SUV. They say I don't need to change engine that def some bent valve and timing ll do.Best advice pls house

TMANTII:
Thank you mayor2013....
While planning to run the test, I will appreciate other experiences and suggestions....thank you all....

...........but also I forgot to add, while fixing back the batt, I inserted the first terminal, but there was a little/tiny spark while inserting the second one....
So I felt something is running while car is off which I'm yet to discover...or is that a norm.

TMANTII:
Good day house....
I use a Honda Accord 2012..
Have got few questions to ask..
1. The fan comes up immediately I kick start, having read/heard it shldnt be so and it doesn't goes off immediately I turn off engine.
2. The batt goes flat after four days and the baba batt charger claims it's the cause of the fan working after engine is off.
3. While reversing, I will need to apply throttle if climbing a little elevation.

CC. GAZZUZZ, Luvinhubby and other Gurus....pls help out.

babalonimi:
All other things v been checked in good condition bfr d conclusion. Though cooling but if d temperature s very hot d coolness wil not b felt to standard Pls can u help m out?

sultaan:
Engine loading

sultaan:
Let me guess with the engine noise and fault timing chain might be loose from broken guides and bad tensioner lacking lubrication.

Sludge too from used of 20w50