₦airaland Forum

Plastering will Starr from the back

On to wall plastering, we will start off with the gauging of the external plastering

More update

Pictures

Starting up with the roofing: the roof truss will be done first while installation of roofing sheet will be done after plastering and coping

Going into the following stage
1. Electrical piping
2. Plumbing
3. Aluminum windows subframes
4. AC
5. Bamboo scaffolding for external works
6. Roofing

Bede2u:
is egypt morocco and tunisia sub saharan African? Wat of somalia or mouritiania or chad or niger republic or gambia or sudan?

Southern Nigeria is better than Egypt while comparable to Morocco. Tunisia is a very small nation with a smaller population than Lagos state and also a tourism destination for Europeans due to her location along the shore of the Mediterranean sea.

completion of the block work moving into electrical piping work, plumbing work, aluminum subframes and plastering work

More updates

More updates

construction of the pent house

smatnemo25:
hi abdul, your lectures are amazing. I am still waiting for the final steps(step 9 through 11).

We are coming with them soon

More updates

Pent house slab reinforcements work

Moving into the pent house slab formwork construction

More updates

Moving to the next face of the job...
First floor to pent house deck block work

More picture

Completion of the slab reinforcements work...

dubemcapital:
I mean since your footing wall ( foundation wall) is not a concrete reinforced wall or slab, that is where you have the metal container, what measure did you take to prevent moisture or damp on the outer wall considering the hight of the foundation from the concrete blinding.

I think we filled all the hollow blocks with concrete which should help

More pictures

Pictures

slab reinforcement.
we use Y12 for the reinforcement all spaced at 200mm c/c
for this slab we have both a bottom and top reinforcement done in accordance with the structural design
The bars were adequately returned at all the edges and the cantilever slabs were reinforced accordingly

dubemcapital:
Good job Abdul, pls i want to ask if you observe any vapor or moisture reterder internally, since your footing wall is not a concrete reinforced wall especially before the metal container over there , considering the hight of the wall. Thanks

please come again with the question I didn't quite get it

Information about the beam reinforcement
1. depth of beams are 450mm and 600mm
2. The beams are reinforced based on the structural designs but most of the longitudinal reinforcing bars are 16mm and 20mm while the link is made of 10mm bar
3 The spacing of the rings are 200mm c/c

More updates

From beam reinforcements

Completion of the form work, moving into beam reinforcements.

The beams are heavily reinforced based on the structural design.

More picture from the decking work.

Picture from the formwork

Resumption of decking formwrok

completion of the block work up to decking work...