₦airaland Forum

Musty4ahmed1:
Please can I have a replacement ignition barrel for Toyota camry 2001? My key couldn't turn the ignition on as the steering was stiff, the rewire did a bad job on the key, now car engine can still be running even when I remove the ignition key

Get it from your nearest parts market within your locality.

halima83:
We intend buying it for intercity taxi. Please how strong is it to endure the trips?

Long time dear, how are you?

Alphafeezay:
Sold...just now

Oh I just saw this.

Alphafeezay:
Abuja

08091300407

Where in Abuja?

Milestogo:
Yes I have,
Like 4 rewires have done that for me. And this same issue continue..
Funniest part is after scanning it will work fine for some days, and comes back again

The engine light also goes off after scanning but after some days when the issue persist again, the engine light comes up.

Dem scan ya motor and dem no tell you codes wey dey?

abiolag:
Thanks for your input 🙏🏾
I started the car in the afternoon and noticed the abs and brake light were not showing again but door light and cruise light started blinking with airbag light 😀
I called another Rewire who could not even say anything reasonable. I decided to drive the car for like 30 minutes around without Ac and when I put on the Ac after like 45 minutes the car just went off. I start it again and all lights were gone and it became normal again.
I drove for another 2 hours and no light.
Though I washed the engine a day earlier maybe that could be the reason for the malfunctions

It's normal with 1975 TransAm.

udy4real:
Please I need a very bright light for my vehicle,which do you advice?

What type of car do you have?
Take a picture of the headlight and post here.

abiolag:
He has already put it back and scan but claimed the machine could not read it

Take it elsewhere, scan with a competent scan tool.

masciv:
Hello guys, any idea on genuity of Masuma parts being sold in Nigeria?

I have changed my brake discs to tokunbo and then to a brand new one but I'm still getting steering judder when braking on highway speeds (100-140KMh)

I'm thinking on buying an 'oem' or at least legitimate quality as I've changed almost everything (discs, pads, calipers, tierod ends, ball joints, control arm and stabilizer bar bushings, wheel bearings, shaft, tokunbo tires, shock absorbers, even rotated tires) on my front end except the hub itself but I keep, getting the ridiculous vibrations when I dare brake.

Or is there anything I should be looking at? What's the possibility of a tokunbo and brand new brake discs being out of round?

Replace the Hub ASSY.

abiolag:
Hello bosses, my Camry 2003 V4 have Abs issue. It was only the abs light that was blinking yesterday but it has been showing brake light alongside it and stays like that. My rewire pull the abs module out to check and he said it was not communicating that I need to replace it. I don’t know what he means by not communicating.
Pls help me out with what I need to do. Thanks 🙏🏾

Tell your rewire to reinstall whatsoever he pulled out. When he reinstall it back, flee from him, go elsewhere and scan it then post codes.

AutoConsult:
🤣🤣🤣

You can imagine. Had to do it the Nigerian way.

Baba, dem no dey tell blind man say rain dey fall. 🤣🤣🤣

AutoConsult:
Some people don't know the value of the cars they drive.

Please tell them some side mirrors cost over 1million.

Side mirror for ordinary Peugeot 508 is over 500k.

They don't know.

The 06 Infiniti I drive, had an exhaust leak, I decided rather than go weld it, to get a replacement from the Y pipe down to the muffler tip, guess what?
It cost 180k.
I kuku humble myself, go weld am back.

fbtowner:
If by “Is your ABS and traction control on” u mean if my abs light is on, the answer is no.

I change the 4 brake pads 3 months ago also.

Thanks I will check all that you mentioned and I will also remove the rubber they used to raise it


What is the best way to raise the car just slightly?

If you must alter the suspension height of your car higher to enable you drive it, pls sell it off and get an SUV.

Bobxin:
Okay, thanks.

You're welcome

soxyfem:
Good evening great minds,
Pls I drive a 2005 lexus es330, I recently changed the water pump and since then I observed that
1.There is a water flowing sound (like water running through holes from the dashboard) that the car makes whenever I start the car, very strange sounds o.
2. Each time I brake at a bump or speed breaker, it sluggishly picks up and jacks as well before driving smoothly.
Kindly advise me on what to do pls.

Check if your car has been bled properly after water pump replacement, check if water still stay at same level after driving for some time.
As for the sluggish pick up after slowing down, have your car scanned and post codes here.
Undo the rubbish contraption cut and join rubber that mechanic did.
Finally, change mechanic

fbtowner:
Hi guys. Please I need some assistance. My 08 Accord kind of want to swerve off road if I brake @120km or above, if I try to slow down with brake it forcefully turn my steering making the car moving like it wants to leave the road. So if I’m @120 speed or above I will have to release the throttle then when the speeds drops to 100 I will then apply brake very slowly

I experienced this the very first time I traveled interstate with the car. And that was the only time I have traveled interstate with the car since I bought it

The only notable things I did to the car when I bought it are
1, change driver side shaft
2, change both ball joint
3, change tire from 225/50 R17 to 225/55 R17 for front and 235/55 R17 for back
4, raised the car with one black rubber

The mechanic said he will use one black rubber that will be added to the shock absorbers to raise it a little , after raising with that rubber a friend warned me that I won’t be able to travel with it because that rubber always have a bad effect when you are on high speed but he said I won’t notice anything if I’m driving around town. Now I don’t know if it’s the rubber or something else

The way it swerve is really scary especially when I am beside a trailer and I want to quickly slow down to let it go

Is your ABS and traction control on?
Have you checked if your brake pads are installed properly, and that the brake pads are the right type?
Check if your brake caliper binds on one wheel or is stuck?
Check also your lower control arm if the bushing is broken, it can cause similar problems.

Bobxin:
Just the glass. Not the whole.

Yes, the glass alone. E be like you no know wetin dey sup yet for your car.
The non BSM is 50-70k a set.


Your front logo, becareful too, that logo is 25k.

Bobxin:
Yes

A side is over 100k at the last time I got for a customer. Budget around 200k minimum.

Bobxin:
Please my side mirror was stolen, (2013 Lexus RX 350). What is the cost of just the glass? (Tokunbo) Both Left & Right.

Is yours equipped with the blind spot monitoring system?

REDshouse:
Bro pls send me ur number so that we can talk and explain better

This is my number
0903. One 42838 four.

07034581213

Hostermipo:
Good evening house,

Please my steering is always very hard to turn when I am stationary while pressing break, until I lift my foot from the break or throttle a little before if functions normally again. It makes it really difficult to come turn or come out of very small space.

Please advise

Thanks

Check steering rack for leaks, check pressure pipe for leaks, if any, replace the failed parts and replace the power steering pump

REDshouse:
Help Help Help

My Corolla 09

Car driving gud though Abs and brake light on, have been driving like that for months with no issue until I decided to change hub bearing and shaft which were all making noise, after changes I test run the car and all went fine until the next day,

I drove from Gbagada to Ikorodu all went smooth and on coming back to Gbagada I observe car transmission shifting at gear 3 and 4, I managed to drive it to base at Gbagada.

Called my mechanic, we scanned the car and it brings out ... Code P0751, shift Solenoid A performance/stuck off, called in a gear master and he said I have to service the valve body and possibly check all the solenoids.

After gear master servicing, installing bigger switch and change of oil to original ATF WS ... We tested the car and still doing same thing. Scanned the car again but all transmission code gone only left with ABS code C0215 and C0221.

Please I need solution to this problem of my Car

Replace the front right ABS sensor and check if the rear left ABS wiring Is connected, if it is, swap left wiring to right, test and record. If the code moves to right, it's wiring if code stays in left rear, replace hub.

24dro:
Tyre, rim, shock and spring are in perfect shape my guess is lower arm or ball joint.

Don't conclude, recheck everything

Do not be afraid of the value they state on their dowry or brideprice list. Visit her family, get very close to them particularly her parents. Some parents can forgo some requirements just to let the union take place and some can decide to let you do the mich you feel you can shoulder, and as time goes on, you fulfill the remaining requirements.

Please, do note, payment of dowry/brideprice is not a one time affair, it's a payment that is continually made thru out the life of the union. As long as you're married to that family, when they have important occasions, and need a contribution to be made, you'd be included and you should feel honored to do so.
Whenever you visit their family home, or when they come over to visit you, as a mark of respect and regard, you can offer gifts to the parents and siblings as you're financially capable of. It doesn't need to be big or small. As long as it's from your heart, then it's fine.

These are the continuous dowry/brideprice youd keep paying.

Feel free, chill, relax and welcome to the club in advance.

Kasdat5:
Boss , even you suprise

Yes o, e shock me

tunbosun002:
I want to deactivate it because of the noise, It just starts making noise for no reason or if there’s a setting to it.. I live in an estate and I do not want other residents to start complaining.

Is it a factory alarm or an aftermarket 3rd party alarm?

MrTed:
A Nissan double door pickup available for sale. Bought Brand New, first body and first owner. Buy and drive with complete papers in Abuja. Come for inspection. Good for site, construction, logistics, supplies, haulage, and general purpose farms and goods distribution.

Price 5 million. Call now for inspection 2347034565215

What do you intend to do, How do you intend to do it and what's the cost of doing it?

Mrkindness:
are you in Abuja come to Gudu market we will do it at a cheaper cost

Jeffrey22:
Buffing

Buffing alone won't bring out this level of finish.

LexusGs350:
Hey everyone.. does anyone know how i can make my car gleam like this? Is it wax? If it is wax what type of wax can give me this amazing result?

Paint decontamination, correction, detailing, waxing and ceramic coating.

tunbosun002:
Hello house, please how do I deactivate my toyota venza auto alarm?

What about it and why would you want to deactivate it?

ReformerD:
They've checked the timing , in fact the car sound is okay, the only issues is the accelerating part, if you don't hard press the accelerating pedal, you won't have issues, but the moment you hit hard the accelerating pedal, it will stop responding

Scab the car, also run live data scan. I believe your turbo or the electrical system that controls throttle body or ECM may be the issue o