hoyinmide: GOOD AFTERNOON PLEASE I CHANGED MY ACURA TL 09 linkages and then did ALIGNMENT AFTER. I DISCOVERED IF TURNED TO THE RIGHT THE STEERING GET HOOKED BUT DOES NOT HAPPEN WHEN TURNED TO THE LEFT.
You didn’t mention if it’s a 2.4 or 2.0 or 3.5l V6, and if it’s a LEV or PZEV vehicle. You also didn’t indicate the symptoms you are experiencing. If it’s a 4 cylinder 2.4L, you need to service something like this. It’s at the rear of your car engine. If after servicing it, it still behaves same way, replacing it should be next.
josephsm823: Please how can I stop this oil leak under my car? Lexus RX 350 2011.
Thanks!
Ensure you buy genuine Toyota Filter and change the Seals on the filter cartridge. If it still seeps, checks if the aluminum part where the cartridge tightens into is not cracked.
BKholip1: Please I am using 2006 Honda accord DC. I noticed that wen I drive like 30mins, it will not move as I match on the turtle to overtake. It will just make sound of turtle but will not pick to move
Ikehbobo: I drive a 1998 Volvo S40, manual and sealed engine. Lately, I noticed that my car emits black smoke when you start the engine, but this clears off after a while; this want happening before. Again, the engine shorts oil after a little period of servicing; please what could be the reason for all these?
I’m not a Volvo mechanic, but I know black smoke indicates engine running rich. You may wish to check your AF sensor or ‘Lambda sond’ as Volvo calls it. As for oil shortage, check if there is any leak from the engine oil seal. If none, then the pistons rings and valve stem seals might be the culprits.
Nemesisobaara: Thanks boss. I checked the TCM and noticed that two pins where bent. I straightened and refined it. Now my gear is flying as usual and I got my Rx350 back and sound. Gracias boss. Now, I want to flush out the gear oil and replace with Toyota WS. Any precaution or advice from the house?
What oil was used previously? Ensure transmission is cold and someone who knows how to service these transmissions are hired for the job. Also, ensure genuine Toyota WS oil is used as there are lot of fakes in the market.
Nemesisobaara: I scanned and the code I got is U0101.. Please gurus, help me with your technical advice. Vex full my mind like this..
Check if the TCM harness is plugged in properly. If it is, have your technician unplug it and check if it’s pins are rusted or bent. Then plug it properly and securely. Clear codes and test drive again. If it doesn’t work, replace that TCM module.
larryuche: `I was driving and smoke full inside my car and i instantly packed the car and discovered that the gear oil is leaked in between the gear box and engine. Please i need help. What is cause? Is a serious issue? And how can it fix? What do i do?
Larry
It’s very normal. That’s how a Classic Ford Bronco is meant to operate.
Nemesisobaara: Please I need urgent help. I noticed oil spillage under my Rx350. On consulting my mechanic, he said it was from the gear, that he needs to drop the engine to fix the oil seal. To cut the long story short, he dropped the engine and fixed a new oil seal, but right now, my car cannot move as suppose. It keeps revving without moving and it jerks when switching from P to D and R..Mehn! I am so unhappy right now. It's Rx350 2011 model. Please I am sad and confused right now.
Get that car scanned and let me know the code, just bear in mind, that transmission may have been contaminated.
The VSC light came on and later the check engine light. The mechanics are saying its the catalyst. What could be wrong? The check AWD system warning is also on. Cc Kingreign and all the other gurus in the house