₦airaland Forum

GAZZUZZ:
otumba, stick to car sales please.

obekediamondfuto:
kindly share

i removed the gear transmission range sensor, cleaned and reset it to neutral, i then went ahead and reset d tps, the tps should give u a 5v on idle and 4.5v when accelerated completely, this is done by putting d ignition on, u don't need to start d car before setting it

Johnsonkeyz2019:
My Honda Accord 2006 discussion Continue AC again o last month I changed one of the black rubber on top for the AC and they cleaned all mouth till that of the condenser retighted everything ND refilled it ND early this month the driver side starting blowing normal air ND when I used it today it wasn't cold at all what could have gone wrong again

Coz if I refill it again it's obvious before a month it might be back to same junction of no freon

you have a leak somewhere, do u perceive a smell in d morning when start d car and put on d ac?

kcbaba007:
Honda Gurus, my EOD was giving AC issues, then changed the condenser and evaporator, cleaned up the system and charged it with gas, when i put in d 1st bottle of gas, the thermostat was cutting as it should do, but when i put in d second bottle, it stopped cutting, i felt i had over charged it, i reduced it and made sure there is no air in d system, yet, the thermostat refused to cut, i checked d harness, nothing wrong, the ac is chilling fine,

Now, i noticed that the engine has started loosing compression when the ac is on, i would have to switch the ac off before it can pick acceleration, if i throttle, it hesitates before picking, it sometimes looks like it's Not changing gear as it should, even to climb hill, e go kind of dey crawl, if i come to a near stop, and throttle to move, it won't respond immediately, i would have to press d throttle like twice or thrice before it will move, d gear 1 sometimes can't climb a small culvet, pls, what could be happening and what can i do?

Scanned, all i got was ECT P2185 and ABS, this are codes that were there before this issue, i am yet to deal with this codes

cc Gazzuzz
luvinhubby
nurey
adanny01

fixed

kcbaba007:
Gear gurus in the house, pls, after fixing d other issue on my EOD, i discovered d gear started having high shift points, tried setting it from the transmission range switch sensor, no change, it reaches 3k rpm to make d 1st change, 3.1 to make the second change, same as the 3rd gear,

how can i reset the auto gear shift points?

cause normally, it shouldn't go beyond 2.2k rpm before it will change from gear 1 to 2 and it is supposed to reduce in 3,4 & 5

fixed

jceesquare:
I'll look into the fuel pump, I noticed the car jerks when I try to accelerate and when I down shift to overtake.

But where do I get quality pumps, I don buy 2 pumps in the space of 6 months.

i think u should just clean d filters and probably ur nuzzles, that will do

jceesquare:
Ogas in the house I have issues with my car A/C.
It's a Nissan Almera 1998 with the Sr20 engine.
I noticed each time I turn on the A/C, the car would find it difficult to rev hard. The RPM is slightly above 800 with A/C on and does not seem low but when you try to rev the engine it responds slowly as if the engine is under immerse load and accelerate as if it's towing something heavy.
I also noticed the A/C works or cools fine when the car is in motion or when you rev it up, but doesn't really work fine when stationary.
The car has manual transmission and runs perfect without A/C.
Pls I need help as my A/C guy does not know what to do again and is confused.

clean ur fuel filters, if very dirty, buy another one, also, check if ur fuel pump is pumping fuel at d required PSI.

phemolala07:
Pls wat are the symptoms of AC thermostat malfunction because I think my car is having the issue. Thanks

how is ur ac thermostat behaving?

GAZZUZZ:
how long have you owned the car? How long have you used the car WITH the a/c working?

over a year, i always use AC

I have taken care of d AC thermostat malfunction, i reduced d gas to the extent where d thermostat started cutting, but, it still vibrates when it's in gear and break is depressed with d AC on, if i put the gear in neutral, it will stop vibrating

Honda Gurus, my EOD was giving AC issues, then changed the condenser and evaporator, cleaned up the system and charged it with gas, when i put in d 1st bottle of gas, the thermostat was cutting as it should do, but when i put in d second bottle, it stopped cutting, i felt i had overcharged it, i reduced it and made sure there is no air in d system, yet, the thermostat refused to cut, i checked d harness, nothing wrong, the ac is chilling fine,

Now, i noticed that the engine has started loosing compression when the ac is on, i would have to switch the account off before it can pickacceleration, if i throttle, it hesitates before picking, it sometimes looks like it's Not changing gear as it should, even to climb hill, e go kind of dey crawl, if i come to a near stop, and throttle to move, it won't respond immediately, i would have to press d throttle liketwice or thrice before it will move, d gear 1 sometimes can't climb a small culvet, pls, what could be happening and what can i do?

Scanned, all i got was ECT P2185 and ABS, this are codes that were there before this issue, i am yet to deal with this codes

cc Gazzuzz
luvinhubby
nurey
adanny01

4llerbuntu:
This your EOD sef. na 1 week 1 issue.

my broda, i no just understand o.

Honda Gurus, my EOD was giving AC issues, then changed the condenser and evaporator, cleaned up the system and charged it with gas, when i put in d 1st bottle of gas, the thermostat was cutting as it should do, but when i put in d second bottle, it stopped cutting, i felt i had over charged it, i reduced it and made sure there is no air in d system, yet, the thermostat refused to cut, i checked d harness, nothing wrong, the ac is chilling fine,

Now, i noticed that the engine has started loosing compression when the ac is on, i would have to switch the ac off before it can pick acceleration, if i throttle, it hesitates before picking, it sometimes looks like it's Not changing gear as it should, even to climb hill, e go kind of dey crawl, if i come to a near stop, and throttle to move, it won't respond immediately, i would have to press d throttle like twice or thrice before it will move, d gear 1 sometimes can't climb a small culvet, pls, what could be happening and what can i do?

Scanned, all i got was ECT P2185 and ABS, this are codes that were there before this issue, i am yet to deal with this codes

cc Gazzuzz
luvinhubby
nurey
adanny01

dakpemien:
hello guys,

i just bought a honda accord 09- tokunbo(my first car), pls what should i likely change or look out for at this initial stage to prevent any problems. I am a novice when it comes to car maintenance.
thanks in advance

Oga, for ur own good, pls just use d manufacturer's recommended fluids, don't go for less, so many people from experience can attest to the ills of using a non recommended fluid in a car. Take my advice and thank me later

Gurus in d house, i have a 2010 corolla, i want to change the electric power steering, what is d name it's being called and how much can i get it in d market?

thanks in advance for ur responses

cc Gazzuz
nurey
adanny01

radautoworks:
NO. after rebuilding, you can use the conventional of the recommended oil

kindly enlighten us on the conventional u talking about pls

seanfer:
Rebuild if you trust your Kazeem.

can he use synthetic oil after rebuilding the engine?

Brand new single cell Radiator for Toyota Camry 98 model (tiny light) available for sale

Brand new headlamps and trafficator right side for Toyota Camry (tiny light) available for sale

Call and whatsapp
08056022511

and this

more pics

brand new single cell radiator for Toyota camry 98 model (tiny light)
price: 15k

brand new Toyota camry 98 model headlamp and trafficator right side

Ahijo1990:
Well done guys,

Pls I just got a Nigerian used EOD. V4.

Pls what's the recommended products for transmission oil, engine oil and gearbox oil?

gear oil and transmission oil is same

gear oil DW1

engine oil is 5w20

Gazzuzz has original 5w20

luvinhubby should have DW1

kingreign:
Try adjusting the TPS. It's the reason.

thanks kingreign, u too much

idtwo:
Hello NLanders. Pls someone should kindly educate me on what to do to properly effect a change of ownership. I'm about to buy a naija used vehicle and I want to be sure I know the details of what is to be done. What documents must I ask for? Do I need to bring a lawyer into the transaction? Thanks for your kind help.

Just make sure the vehicle papers are original, after purchase, get a receipt of payment, a letter of change of ownership from the owner, go to the nearest court, get an affidavit for change of ownership, then go to the nearest police station, with d court affidavit, apply for a statement for change of ownership, pls make sure the vehicle has an authentic proof of ownership, vehicle registration, CMR, road worthiness, and insurance, then head on to where the vehicle registration was issued, if it was issued in festac, or apapa or mushin or ikeja, go back there, get a re-issue in ur name, there and then other documents will be issued to u, the change of ownership will now be in ur name
Hope this is helpful. pls, do not patronize touts

realbee:
Thanks luvinghubby, Can this be repaired or its best to get a replacement? how much can I get it from you if you have it? I can come down to your shop on Friday.

i did a resetting for mine

ricki:
broke a bolt inside Front Shocks Top Mount ........


kai egbami

get a welder to help u out.

GAZZUZZ:
Vehicle is an accord 03? Drop TPS to between 7-9.8%

Thanks Gazzuzz, problem solved, advice taken,

as long as this field is concerned, Gazzuzz na master

osuofia2:
pls gurus in the house, i intend to buy honda EOD but some people seems to complain about the leg pulling. pls what is your opinion and how can one manage such situations

osuofia2:
pls gurus in the house, i intend to buy honda EOD but some people seems to complain about the leg pulling. pls what is your opinion and how can one manage such situations

it's d ball joint that pulls off, and this ia so because of the way it was manufactured it is positioned, this is also compounded by the careless attitude and mismanagement of drivers, if attention is paid to it, good management culture is developed, and perhaps changing it every six months with quality ones, u will not have problem, EOD is a nice car,

pls, when buying, get a good toks, and when buying a nigerian used, pls, make sure that mechanics have not raped the engine, u can contact one of the gurus on this platform to help u in getting a good one

Gear gurus in the house, pls, after fixing d other issue on my EOD, i discovered d gear started having high shift points, tried setting it from the transmission range switch sensor, no change, itreaches 3k rpm to make d 1st change, 3.1 to make the second change, same as the 3rd gear,how can i reset the auto gear shift points?cause normally, it shouldn't go beyond 2.2k rpmbefore it will change from gear 1 to 2 and it is supposed to reduce in 3,4 & 5cc Gazzuzzkingreignluvinhubbyobi

Gear gurus in the house, pls, after fixing d other issue on my EOD, i discovered d gear started having high shift points, tried setting it from the transmission range switch sensor, no change, itreaches 3k rpm to make d 1st change, 3.1 to make the second change, same as the 3rd gear,how can i reset the auto gear shift points?cause normally, it shouldn't go beyond 2.2k rpmbefore it will change from gear 1 to 2 and it is supposed to reduce in 3,4 & 5

cc Gazzuzz
kingreign
luvinhubby
obi

Gear gurus in the house, pls, after fixing d other issue on my EOD, i discovered d gear started having high shift points, tried setting it from the transmission range switch sensor, no change, it reaches 3k rpm to make d 1st change, 3.1 to make the second change, same as the 3rd gear,

how can i reset the auto gear shift points?

cause normally, it shouldn't go beyond 2.2k rpm before it will change from gear 1 to 2 and it is supposed to reduce in 3,4 & 5

Thank God i was able to resolve the issue of erratic/hard gear changes and fluctuating speedometer in my honda eod, thanks to everyone that contributed ideas and solutions. God bless u all

GAZZUZZ:
I am glad you know how to use a multimeter. The resistance you are looking for is in milli ohms. I will advise you go the easy way out and employ the use of scan tool that can read the abs sensors and also carry out a live test on functionality of each wheel.

sir, can u recommend a scan tool that can scan engine, gear box, abs, srs, etc. thanks